文献速递显微修复重建创面修复

胸背动脉穿支、旋髂浅动脉穿支及股前外侧穿支皮瓣减薄手术靶区皮下组织层的解剖学理解

Anatomical Understanding of Target Subcutaneous Tissue Layer for Thinning Procedures in Thoracodorsal Artery Perforator, Superficial Circumflex Iliac Artery Perforator, and Anterolateral Thigh Perforator Flaps.
PubMed 文献 · Plast Reconstr Surg · 2018-01-01

本研究按供区脂肪厚度分层,每组30名供者,利用CT测量胸背动脉穿支、旋髂浅动脉穿支及股前外侧穿支皮瓣供区浅层脂肪与深层脂肪厚度,计算达到目标皮瓣厚度(4、6、8 mm)需去除的各层脂肪比例。结果显示浅层脂肪层所需去除比例随供者脂肪厚度变化,沿浅筋膜减薄后厚度减少约三分之一,脂肪极厚组需去除部分浅层脂肪才能达到任一目标厚度。结论认为获得薄穿支皮瓣常需处理浅层脂肪层,减薄方法应具备控制浅层脂肪厚度的适应性。

要点

  • 沿浅筋膜减薄后皮瓣厚度减少约全层三分之一。
  • 浅层脂肪层需去除比例随供者脂肪厚度变化。
  • 脂肪极厚组需去除部分浅层脂肪才能达到目标厚度。

核心结论

  • 本研究表明获得薄穿支皮瓣时常需对浅层脂肪层进行处理。
  • 为有效应对供区脂肪厚度与所需厚度的不同组合,合适的减薄方法应具备更高的适应性,包括控制浅层脂肪层厚度的能力。

研究设计与样本

  • 按脂肪厚度分层形成三个组,每组30名供者,分别对应胸背动脉穿支皮瓣、旋髂浅动脉穿支皮瓣和股前外侧穿支皮瓣。
  • 在三个皮瓣供区的特定点测量浅层脂肪和深层脂肪厚度。
  • 计算达到目标皮瓣厚度(4、6、8 mm)需去除的浅层和深层脂肪层比例。

主要发现

  • 浅层脂肪层的中位比例随供者脂肪厚度变化。
  • 沿浅筋膜减薄抬高后,厚度估计减少约全层三分之一。
  • 需去除各脂肪层的可变比例以获得所需薄度。
  • 在脂肪极厚组,需去除部分浅层脂肪层才能达到三个皮瓣的任一目标厚度。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Thinned perforator flaps, reported techniques, and degree of thinning differ by study. This study investigated the anatomy of subcutaneous tissue according to the varying fattiness and identified which component and how much of the subcutaneous tissue layer needed to be excluded to meet target flap thickness using computed tomography. METHODS: Three stratified fattiness groups consisting of 30 donors were formed for thoracodorsal artery perforator, superficial circumflex iliac artery perforator, and anterolateral thigh flaps. Thickness of the superficial fat and the deep fat layers was measured at specific points in donor sites of the three flaps and the proportion of superficial and deep fat layers to exclude to reach the target flap thickness (4, 6, and 8 mm) was calculated. RESULT: The median proportion for the superficial fat layer varies depending on donor fattiness. The estimated percentage reduction of thickness after thin flap elevation along superficial fascia was approximately one-third of the whole layer. A variable proportion of each fat layer needs to be excluded to obtain required thinness and in very thick groups, part of the superficial fat layer must be removed to reach any of the target thicknesses for the three flaps. CONCLUSIONS: The present study demonstrated the frequent need for superficial fat layer manipulation when obtaining a thin perforator flap. To cope with various combinations of donor-site fattiness and different required thicknesses effectively, an appropriate thinning method should have increased adaptability, including the ability to control superficial fat layer thickness.

来源:Plast Reconstr Surg,查看原文。版权归原作者所有。

引用

  1. Kim SY, Lee YJ, Mun GH, et al. Anatomical Understanding of Target Subcutaneous Tissue Layer for Thinning Procedures in Thoracodorsal Artery Perforator, Superficial Circumflex Iliac Artery Perforator, and Anterolateral Thigh Perforator Flaps. Plast Reconstr Surg. 2018. PMID: 29889740. doi:10.1097/PRS.0000000000004619

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。