文献速递颅颌面外科

基于上颌前部面高垂直延长的唇裂相关正颌手术

Cleft-Related Orthognathic Surgery Based on Maxillary Vertical Lengthening of the Anterior Facial Height.
PubMed 文献 · Plast Reconstr Surg · 2018-01-01

研究提出唇裂相关牙颌面畸形除上颌后缩外还存在上颌垂直短缩和前牙暴露不足,于2007年12月至2016年12月对41例连续患者采用包含有意垂直延长与上颌前徙的正颌手术。术后单纯上颌前徙组平均垂直延长0.88 mm,有意垂直延长联合上颌前徙组7.65 mm。作者认为同期上颌垂直延长与水平前徙是可行方法,基于本研究显示的长期稳定性。

要点

  • 唇裂相关畸形除上颌后缩外,上颌垂直短缩和前牙暴露不足也是关键要素。
  • 41例唇裂患者鼻根点至切牙尖距离76.70 mm,SNA角74.03度,前牙暴露1.02 mm。
  • 术后平均垂直延长:单纯上颌前徙组0.88 mm,垂直延长联合前徙组7.65 mm。

核心结论

  • 作者结果提示,同期上颌垂直延长与水平前徙是唇裂相关畸形正颌手术的可行方法,基于本研究显示的长期稳定性。

研究设计与样本

  • 采用新方法于2007年12月至2016年12月治疗连续牙颌面畸形患者,纳入唇裂相关牙颌面畸形者,证据等级为治疗性III级。

主要发现

  • 41例唇裂相关牙颌面畸形患者鼻根点至切牙尖距离为76.70 mm,蝶鞍-鼻根点-A点连线角为74.03度,前牙暴露为1.02 mm。
  • 40例无唇裂患者相应测量分别为81.57 mm、80.08度和3.38 mm。
  • 术后平均垂直延长在单纯上颌前徙组为0.88 mm,在有意垂直延长联合上颌前徙组为7.65 mm。

关键数值与推荐

  • 唇裂相关牙颌面畸形患者鼻根点至切牙尖距离76.70 mm,蝶鞍-鼻根点-A点角74.03度,前牙暴露1.02 mm。
  • 无唇裂患者鼻根点至切牙尖距离81.57 mm,蝶鞍-鼻根点-A点角80.08度,前牙暴露3.38 mm。
  • 术后平均垂直延长:单纯上颌前徙组0.88 mm,有意垂直延长联合上颌前徙组7.65 mm。

临床怎么用

  • 作者认为,鉴于本研究显示的长期稳定性,同期上颌垂直延长与水平前徙是唇裂相关畸形正颌手术的可行方法。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: The conventional approach during orthognathic surgery for cleft-related deformities has focused largely on restoration of maxilla retrusion, using the maxillary advancement as a standard treatment objective. However, the authors thought that maxillary vertical shortening and deficient incisor show could be additional key elements of cleft-related deformities. Although slight vertical lengthening can be obtained with only maxillary advancement, it would not be enough to obtain satisfactory aesthetic results in terms of the anterior facial height. The authors hypothesized that vertical deficiency and anteroposterior maxillary retrusion exists in cleft-related deformities. Therefore, orthognathic surgery including intentional vertical lengthening and advancement would be better than the conventional simple advancement. METHODS: A new approach was used to treat consecutive patients with dentofacial deformities between December of 2007 and December of 2016. Patients with cleft-related dentofacial deformities were included in the study. RESULTS: Forty-one patients with cleft-related dentofacial deformities were included. The distance from the nasion to the incisor tip was 76.70 mm; the angle of the lines connecting the sella, nasion, and point A was 74.03 degrees; and the incisor show was 1.02 mm. Corresponding measurements in 40 patients without clefts were 81.57 mm, 80.08 degrees, and 3.38 mm, respectively. Postoperatively, the average vertical lengthening achieved was 0.88 mm in the simple maxillary advancement group and 7.65 mm in the intentional vertical lengthening accompanied by maxillary advancement group. CONCLUSION: The authors' results suggest that simultaneous maxillary vertical lengthening with horizontal advancement is a viable approach to orthognathic surgery for cleft-related deformities, given the long-term stability of outcomes demonstrated in this study. CLINICAL QUESTION/LEVEL OF EVIDENCE: Therapeutic, III.

来源:Plast Reconstr Surg,查看原文。版权归原作者所有。

引用

  1. Jeong WS, Jeong HH, Kwon SM, et al. Cleft-Related Orthognathic Surgery Based on Maxillary Vertical Lengthening of the Anterior Facial Height. Plast Reconstr Surg. 2018. PMID: 29140903. doi:10.1097/PRS.0000000000004172

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。