文献速递显微修复重建创面修复

显微外科的人体工效学负担:利用生物传感器技术实时量化颈部姿势

Ergonomic burden in microsurgery: Real-time quantification of cervical posture using biosensor technology.
PubMed 文献 · J Plast Reconstr Aesthet Surg · 2025-11-21

结果显示,皮瓣切取阶段该比例达88.5±8.5%,显著高于微血管吻合阶段的3.9±7.0%(p<0.001),且54.5%的参与者报告过去12个月内有颈部疼痛。

要点

  • 皮瓣切取阶段颈部屈曲超过30°的时间占比高达88.5%,远高于吻合阶段。
  • 外科医生身高可独立预测两个手术阶段的颈部屈曲程度。
  • 超过半数参与者报告颈部疼痛,且与睡眠和娱乐活动受限相关。

核心结论

  • 显微外科手术中颈部负荷显著,尤其在皮瓣切取阶段。
  • 人体工效学负担反映姿势、外科医生人体测量学特征与生活方式因素的相互作用。

研究设计与样本

  • 主刀医生佩戴Upright GO 2™姿势传感器,在25例游离皮瓣手术中测量皮瓣切取和微血管吻合阶段颈部屈曲超过30°的时间比例。
  • 参与者完成经验证问卷评估肌肉骨骼症状(NMQ-E)、颈部功能障碍(NDI)、心理韧性(BRS)及结构化风险因素调查。

主要发现

  • 在25例游离皮瓣手术中,皮瓣切取阶段颈部屈曲超过30°的时间比例为88.5±8.5%,微血管吻合阶段为3.9±7.0%(p<0.001)。
  • 外科医生身高独立预测两个阶段的颈部屈曲(皮瓣切取:β=+0.008,p=0.009;微血管吻合:β=-0.006,p=0.005)。
  • 54.5%的参与者报告过去12个月内颈部疼痛,并与睡眠受损和娱乐活动减少相关。
  • 每周显微外科暴露时间越长,皮瓣切取阶段过度屈曲时间越长(ρ=0.439,p=0.019)。
  • 久坐时间越长,微血管吻合阶段屈曲程度越高(ρ=0.416,p=0.025)。

临床怎么用

  • 应关注显微外科医生在皮瓣切取阶段的人体工效学负担,考虑针对性干预。
  • 需开展前瞻性干预研究以促进显微外科医生肌肉骨骼健康并维持手术表现。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

INTRODUCTION: Reconstructive microsurgeons are prone to musculoskeletal strain due to prolonged static postures and use of magnification. This study prospectively quantified intra-operative cervical posture, assessed the prevalence of neck pain and identified factors associated with ergonomic strain. METHODS: Eleven reconstructive microsurgeons were prospectively recruited between July and December 2024. The lead surgeon wore an Upright GO 2™ posture sensor to measure the proportion of operative time spent in cervical flexion >30° during (a) flap raise and (b) micro-anastomosis. Participants completed validated questionnaires assessing musculoskeletal symptoms (NMQ-E), neck disability (NDI), resilience (BRS) and a structured risk-factor survey. RESULTS: Across 25 free-flap procedures, surgeons spent 88.5 ± 8.5% of flap-raise time in flexion >30°, compared with 3.9 ± 7.0% during micro-anastomosis (p < 0.001). Surgeon height independently predicted cervical flexion during both phases (β = +0.008, p = 0.009; β = -0.006, p = 0.005). More than half of the participants (54.5%) reported neck pain within the previous 12 months, associated with impaired sleep and reduced recreation. Longer weekly microsurgical exposure correlated with greater time in excessive flexion during flap raise (ρ = 0.439, p = 0.019), while higher sedentary time correlated with flexion during micro-anastomosis (ρ = 0.416, p = 0.025). CONCLUSION: Cervical loading during microsurgery is substantial, particularly during flap raise. Ergonomic strain reflects the interplay between posture, surgeon anthropometry, and lifestyle factors. Targeted ergonomic interventions and prospective interventional studies are warranted to promote musculoskeletal health and sustain operative performance in microsurgeons.

来源:J Plast Reconstr Aesthet Surg,查看原文。版权归原作者所有。

引用

  1. Phoenix E, Canavan C, Kelly L, et al. Ergonomic burden in microsurgery: Real-time quantification of cervical posture using biosensor technology. J Plast Reconstr Aesthet Surg. 2025. PMID: 41380363. doi:10.1016/j.bjps.2025.11.042

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。