文献速递乳房整形与再造

验证两阶段假体乳房再造最终假体体积预测模型的准确性

Verifying Predictive Models for Determining Final Implant Volume in 2-Stage Implant-Based Breast Reconstruction.
PubMed 文献 · Plast Reconstr Surg · 2025-10-30

本研究回顾性分析Duke大学2021至2024年两阶段组织扩张器-假体乳房再造患者,使用既往胸肌前与胸肌下预测公式计算假体体积并与实际值比较。结果显示两模型总体低估最终假体体积,胸肌前与胸肌下均方根误差分别为73.6 cc和54.9 cc,提示模型可作为决策起点。

要点

  • 胸肌前与胸肌下预测模型总体低估最终假体体积,平均低估23 cc。
  • 胸肌前模型均方根误差73.6 cc,胸肌下模型54.9 cc。
  • 模型准确性在胸肌前为3-4个型号内,胸肌下为2-3个型号内。

核心结论

  • 两种预测模型总体低估最终假体体积,平均预测值比实际值小23 cc(477 cc vs 500 cc)。

主要发现

  • 胸肌前模型均方根误差为73.6 cc,胸肌下模型为54.9 cc。
  • 根据假体凸度不同,55-75 cc差异相当于胸肌前模型准确在3-4个型号内,胸肌下模型准确在2-3个型号内。

关键数值与推荐

  • 胸肌前预测公式:26.6 + 0.38 × 组织扩张器最终填充量 + 0.61 × 组织扩张器体积。
  • 胸肌下预测公式:71.7 + 0.8 × 组织扩张器最终填充量 + 0.1 × 组织扩张器体积。

临床怎么用

  • 模型可作为选择最终假体体积的起始参考,帮助优化手术规划、减少每例订购的假体数量并降低成本。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Most breast reconstructions following mastectomy use a 2-stage tissue expander (TE)-to-implant approach. Prior studies on prepectoral and subpectoral breast reconstructions have identified formulas for predicting final implant size using TE size and final fill. The aim of this study is to test the accuracy of these models. METHODS: A retrospective chart review of patients who underwent 2-stage TE-to-implant breast reconstruction within the Duke University Health System between 2021 and 2024 was performed. Demographic, oncologic, and reconstructive data were collected. The equations (26.6 + 0.38 * [TE final fill] + 0.61 * [TE size]) for prepectoral and (71.7 + 0.8 * [TE final fill] + 0.1 * [TE size]) for subpectoral reconstructions were used to calculate predicted implant sizes, which were then compared with actual implant sizes. RESULTS: Seventy prepectoral patients (117 breasts) and 39 subpectoral patients (67 breasts) met criteria for inclusion. All patients had at least 5 months of postoperative follow-up. The mean predicted implant size was 23 cc less than the mean actual size (477 cc versus 500 cc). The root-mean-square errors for prepectoral and subpectoral reconstructions were 73.6 cc and 54.9 cc, respectively. CONCLUSIONS: In general, both models underpredicted final implant size. Depending on the implant profile, a 55- to 75-cc difference equates to the models being accurate within 3 to 4 sizes for prepectoral and 2 to 3 sizes for subpectoral reconstructions, suggesting their potential use as a starting point to guide surgeon decision-making. Being able to predict final implant size more accurately will optimize surgical planning, decrease the number of implants ordered for each case, and reduce costs.

来源:Plast Reconstr Surg,查看原文。版权归原作者所有。

引用

  1. Thomason TD, Sergesketter AR, Atia AN, et al. Verifying Predictive Models for Determining Final Implant Volume in 2-Stage Implant-Based Breast Reconstruction. Plast Reconstr Surg. 2025. PMID: 41172348. doi:10.1097/PRS.0000000000012581

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。