DIEP皮瓣灌注面积与体积:穿支与皮瓣特征估算灌注面积和体积的多变量分析
本研究在2018年11月至2023年2月间对101例DIEP皮瓣乳房再造患者术中用吲哚菁绿血管造影评估灌注,以ImageJ测量单穿支灌注面积并计算灌注比。多变量分析显示灌注比均值67.8%±11.5%,与穿支直径和脐下位置正相关、与皮瓣厚度负相关;灌注重量预测的校正R²为75.5%,高于灌注面积的69.4%。结论认为给定直径和位置的穿支决定的是皮瓣体积而非面积。
要点
- 灌注比均值67.8%±11.5%,与穿支直径(p=0.022)和脐下位置(p<0.001)正相关。
- 灌注比与皮瓣厚度负相关(p=0.003)。
- 灌注重量预测校正R²为75.5%,高于灌注面积的69.4%。
核心结论
- 给定直径和位置的穿支决定的是皮瓣体积而非面积。
研究设计与样本
- 术中采用吲哚菁绿血管造影评估DIEP皮瓣灌注,纳入2018年11月至2023年2月间接受DIEP皮瓣乳房再造的患者101例。
- 以ImageJ软件在皮瓣表面勾勒并测量单支优势穿支的灌注面积,计算灌注面积除以皮瓣总面积的灌注比。
- 采用多变量线性回归分析估算灌注比,候选预测变量包括皮瓣大小(cm²)、皮瓣厚度(mm)、穿支直径(mm)、穿支排(内侧/外侧)、穿支垂直位置(脐水平及以上/脐以下)和穿支偏心距(皮瓣上缘至穿支的垂直距离,cm)。
主要发现
- 灌注比均值为67.8%±11.5%。
- 多变量分析中灌注比与穿支直径(p=0.022)和穿支位于脐以下(p<0.001)正相关,与皮瓣厚度负相关(p=0.003)。
- 灌注面积和灌注重量均由穿支直径、穿支垂直位置、皮瓣大小和皮瓣厚度预测(p<0.001)。
- 灌注重量预测的校正R²高于灌注面积(75.5% vs. 69.4%)。
临床怎么用
- 原文未据此给出推荐。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: The extent of perfusion of a deep inferior epigastric artery perforator (DIEP) flap is a primary concern for surgeons. This study aimed to determine whether the flap area or volume can be estimated using perforator and flap characteristics. METHODS: Intraoperative flap perfusion was assessed using indocyanine green angiography in patients who underwent DIEP flap breast reconstruction between November 2018 and February 2023. The area perfused by a single dominant perforator was delineated on the surface of the flap and measured using the ImageJ software. Multiple linear regression analysis was conducted to estimate the 'perfusion ratio,' defined as the perfused area divided by the total flap area. Potential predictor variables included flap size (cm2), flap thickness (mm), perforator diameter (mm), perforator rows (medial/lateral), vertical location of perforator (at or above/below the umbilicus), and perforator eccentricity (vertical distance from upper flap margin to perforator, cm). RESULTS: In total, 101 patients were included in this analysis. The mean 'perfusion ratio' was 67.8% ± 11.5%, predicted by perforator diameter (p = 0.022) and vertical location below umbilicus (p < 0.001) with positive correlations and negatively correlated with flap thickness (p = 0.003) in the multivariable analysis. Both perfusion area and weight were predicted by perforator diameter, vertical location of perforator, flap size, and flap thickness (p < 0.001). The coefficient of determination (adjusted R2) for prediction of perfusion weight was higher than that for the perfusion area (75.5% vs. 69.4%). CONCLUSIONS: Flap volume, rather than area, is determined by a perforator of a given diameter and location.
引用
- Park JW, Kang JM, Yoo K, et al. Perfusion area versus volume of the DIEP flap: A multivariable analysis of perforator and flap characteristics for estimation of perfusion area and volume. J Plast Reconstr Aesthet Surg. 2024. PMID: 39096738. doi:10.1016/j.bjps.2024.07.030
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。