文献速递运动医学创伤骨科

胫骨前侧闭合楔形截骨矫正过大的胫骨后倾角:楔形高度与矫正度数的比值研究

Determining the Ratio of Wedge Height to Degree of Correction for Anterior Tibial Closing Wedge Osteotomies for Excessive Posterior Tibial Slope.
PubMed 文献 · Am J Sports Med · 2021-09-30

本研究利用38膝CT模拟胫骨结节上方(ST)与经胫骨结节(TT)前侧闭合楔形截骨,确定楔形高度与矫正度数的比值,并在12例3D打印胫骨上验证。结果显示ST比值为0.99±0.07 mm/度,TT为0.83±0.06 mm/度(P<.001),模拟截骨平均矫正误差在目标1°~2°内;ST易矫正不足,TT易矫正过度。

要点

  • ST截骨楔形高度与矫正度数比值约1 mm/度,TT约0.8 mm/度。
  • 按上述比值模拟截骨,平均斜率矫正与目标相差1°~2°内。
  • ST技术易矫正不足,TT技术易矫正过度。

核心结论

  • 前侧闭合楔形截骨矫正过大胫骨后倾角时,ST技术每矫正1°需移除约1 mm楔形高度,TT技术每矫正1°需移除约0.8 mm楔形高度,平均矫正误差在目标1°~2°内。

研究设计与样本

  • 受控实验室研究,使用38膝(37例患者)翻修ACL重建的CT扫描模拟ST与TT截骨,并在12例后倾角最大患者的3D打印胫骨上实施截骨验证。

主要发现

  • CT测量楔形高度与矫正度数比值:ST为0.99±0.07 mm/度,TT为0.83±0.06 mm/度(P<.001)。
  • 在12例3D打印胫骨上模拟截骨,平均斜率矫正与目标相差1°~2°,无论截骨位置或测量内侧/外侧平台。
  • ST技术倾向于矫正不足,TT技术倾向于矫正过度。

关键数值与推荐

  • ST截骨比值0.99±0.07 mm/度,TT截骨比值0.83±0.06 mm/度,比较P<.001。
  • 模拟截骨平均斜率矫正与目标误差在1°~2°内。

临床怎么用

  • 临床行前侧闭合楔形胫骨截骨矫正过大后倾角时,可按ST约1 mm/度、TT约0.8 mm/度估算楔形高度,并注意ST可能矫正不足、TT可能矫正过度。

局限性

  • 研究为实验室模拟,基于CT和3D打印胫骨,非临床活体手术验证。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Anterior closing wedge osteotomy of the proximal tibia may be considered in revision anterior cruciate ligament (ACL) reconstruction surgery for patients with excessive posterior tibial slope (PTS). PURPOSE: (1) To determine the ratio of wedge thickness to degrees of correction for supratubercle (ST) versus transtubercle (TT) osteotomies for anterior closing wedge osteotomies and (2) to evaluate the accuracy of ST and TT osteotomies in achieving slope correction. STUDY DESIGN: Controlled laboratory study. METHODS: The computed tomography (CT) scans of 38 knees in 37 patients undergoing revision ACL reconstruction were used to simulate both ST and TT osteotomies. A 10° wedge was simulated in all CT models. The height of the wedge along the anterior tibia was recorded for each of the 2 techniques. The ratio of wedge height to achieved degree of correction was calculated. ST and TT osteotomies were performed on 3-dimensional (3D)-printed tibias of the 12 patients from the study group with the greatest PTS, after the desired degree of correction was determined. Pre- and postosteotomy slopes were measured for each tibia, and the actual change in slope was compared with the intended slope correction. RESULTS: According to CT measurements, the ratio of wedge height to degree of correction was 0.99 ± 0.07 mm/deg for the ST osteotomy and 0.83 ± 0.06 mm/deg for the TT osteotomy (P < .001). When these ratios were used to perform simulated osteotomies on the twelve 3D-printed tibias, the mean slope correction was within 1° to 2° of the intended slope correction, regardless of osteotomy location (ST or TT) or whether slope was measured on the medial or lateral plateau. The ST technique tended to undercorrect and the TT technique tended to overcorrect. CONCLUSION: When anterior tibial closing wedge osteotomies were removed to correct excessive PTS, removing a wedge with a ratio of 1 mm of wedge height for every 1° of intended correction for an ST technique and a ratio of 0.8 mm to 1° for a TT technique resulted in overall average slope correction within 1° to 2° of the target. CLINICAL RELEVANCE: The calculated ratios will allow clinicians to more accurately correct PTS when performing anterior closing wedge tibial osteotomy.

来源:Am J Sports Med,查看原文。版权归原作者所有。

引用

  1. Quinn CA, Miller MD, Turk RD, et al. Determining the Ratio of Wedge Height to Degree of Correction for Anterior Tibial Closing Wedge Osteotomies for Excessive Posterior Tibial Slope. Am J Sports Med. 2021. PMID: 34591705. doi:10.1177/03635465211044136

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。