骨水泥抛光锥形柄翻修率低于常用非骨水泥柄:澳大利亚骨科协会国家关节置换登记系统201,889例全髋关节置换17年随访分析
该研究基于澳大利亚骨科协会国家关节置换登记系统1999至2019年数据,比较了常用的5种骨水泥与非骨水泥股骨柄在骨关节炎全髋关节置换中的翻修率。共纳入201,889例全髋关节置换,骨水泥组与非骨水泥组各占50.0%。骨水泥抛光锥形柄在所有时间点的翻修率均低于非骨水泥柄,尤其术后2周内风险比0.48(95%CI 0.40-0.58,P<.001),2周后风险比0.85(95%CI 0.81-0.90,P<.001)。亚组分析进一步支持使用骨水泥柄。
要点
- 骨水泥抛光锥形柄翻修率在所有时间点均低于常用非骨水泥柄。
- 术后2周内翻修风险比0.48(95%CI 0.40-0.58,P<.001)。
- 推荐所有年龄组及低/高手术量医生使用,尤其头尺寸≤32 mm时。
核心结论
- 常用骨水泥抛光锥形柄相比常用非骨水泥假体具有更低的翻修率,推荐在所有年龄组及低手术量和高手术量医生中使用,尤其当头尺寸为32 mm或更小时。
研究设计与样本
- 基于澳大利亚骨科协会国家关节置换登记系统1999至2019年数据,纳入因骨关节炎行全髋关节置换的201,889例,比较常用的5种骨水泥与非骨水泥股骨柄的翻修率。
主要发现
- 骨水泥组与非骨水泥组各占50.0%,骨水泥柄在所有时间点的翻修率均低于非骨水泥柄。
- 术后2周内风险比为0.48(95%CI 0.40-0.58,P<.001),2周及以后风险比为0.85(95%CI 0.81-0.90,P<.001)。
- 针对头尺寸、摩擦界面类型和医生手术量的亚组分析进一步支持使用骨水泥柄。
关键数值与推荐
- 排除骨水泥亚光柄、线对线骨水泥技术、非交联聚乙烯、大头(>32 mm)金属对金属摩擦界面或可交换颈的病例。
- 推荐所有年龄组及低手术量和高手术量医生使用骨水泥抛光锥形柄,尤其当头尺寸≤32 mm时。
临床怎么用
- 在因骨关节炎行全髋关节置换时,可优先考虑使用骨水泥抛光锥形柄以降低翻修风险,尤其适用于头尺寸≤32 mm及不同手术量医生。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: Data assessing femoral stems may be influenced by grouping together matt and polished stems, despite their differing reported survivorship. The aim of this study is to assess the difference in revision rates between commonly used cemented and cementless stems when polished tapered stems are assessed independently of matt stems. METHODS: Australian Orthopaedic Association National Joint Replacement Registry data from 1999 to 2019 were used to assess difference in revision rates between the 5 most commonly implanted femoral cemented and cementless stems for osteoarthritis. Cemented matt femoral stems, stems using line-to-line cementing techniques and procedures using non-cross-linked polyethylene, large head (>32 mm) metal-on-metal bearing surfaces or exchangeable necks were excluded. Cumulative percent revision was used to help compare survivorship between stems. RESULTS: There were 201,889 total hip replacements meeting the inclusion criteria, of which 50.0% were cemented and 50.0% cementless. Cemented stems had a lower rate of revision at all time points compared to cementless stems. This was most significant during the first 2 weeks (hazard ratio 0.48, 95% confidence interval 0.40-0.58, P < .001) compared to 2 weeks postoperatively and onwards (hazard ratio 0.85, 95% confidence interval 0.81-0.90, P < .001). A subanalysis of head size, bearing type, and surgeon volume further supported the use of a cemented stem. CONCLUSION: Commonly used cemented polished tapered stems have a lower revision rate when compared to commonly used cementless prostheses, and are recommended in all age groups for both low-volume and high-volume surgeons especially when head size 32 mm or smaller is used.
引用
- Babazadeh S, de Steiger RN, Holder C, et al. Cemented Polished Tapered Stems Have Lower Revision Rates Than Commonly Used Cementless Implant up to 17 Years of Follow-Up: An Analysis of 201,889 Total Hip Replacements From the Australian Orthopedic Association National Joint Replacement Registry. J Arthroplasty. 2021. PMID: 34592358. doi:10.1016/j.arth.2021.09.013
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。