额外股骨远端截骨增加后稳定型全膝关节置换术屈曲挛缩中的屈中冠状松弛:一项计算研究
本研究通过六个具有尸体特异性关节囊和侧副韧带属性的计算膝关节模型,模拟后稳定型全膝关节置换术(PS TKA)中10°屈曲挛缩,并分别进行+2 mm和+4 mm的股骨远端额外截骨,测量0°至90°屈曲过程中的冠状松弛度。结果显示,额外截骨导致屈中冠状松弛度显著增加,+4 mm截骨在平均15.7°屈曲时松弛度增加最大(7.8°)。结论提示,关节线抬高时冠状松弛在早期(约16°)达到峰值,建议在15°至30°屈曲范围评估冠状松弛以检测屈中不稳定。
要点
- +2 mm和+4 mm股骨远端额外截骨均显著增加30°和45°屈曲时的冠状松弛度(p<0.001)。
- +4 mm截骨在平均15.7°屈曲时冠状松弛度增加最大,平均增加7.8°。
- 若需抬高关节线,建议在15°至30°屈曲范围评估冠状松弛以检测屈中不稳定。
核心结论
- 在PS TKA中抬高关节线时,冠状松弛在早期(约16°)达到峰值,最大松弛度为8°。
- 如有可能应恢复关节线;若必须抬高关节线,建议在膝关节屈曲15°至30°时评估冠状松弛以检测屈中不稳定。
研究设计与样本
- 研究使用六个计算膝关节模型,模型具有尸体特异性关节囊和侧副韧带属性。
- 每个模型植入后稳定型(PS)全膝关节置换术(TKA),并创建10°屈曲挛缩以模拟关节囊挛缩。
- 对每个膝关节分别模拟+2 mm和+4 mm的股骨远端截骨。
主要发现
- +2 mm截骨在30°和45°屈曲时,平均冠状松弛度分别增加3.1°(SD 0.18°)(p < 0.001)和2.7°(SD 0.30°)(p < 0.001)。
- +4 mm截骨在30°和45°屈曲时,平均冠状松弛度分别增加6.5°(SD 0.56°)(p < 0.001)和5.5°(SD 0.72°)(p < 0.001)。
- +4 mm截骨的最大冠状松弛度增加发生在平均15.7°(11°至33°)屈曲时,较基线平均增加7.8°(SD 0.2°)。
关键数值与推荐
- 在10 Nm的外翻和内翻力矩下,测量0°至90°屈曲过程中的冠状松弛度(相应最大力矩下内翻和外翻角度的总和)。
临床怎么用
- 在初次PS TKA中,如有可能应恢复关节线。
- 若必须抬高关节线,建议在膝关节屈曲15°至30°时评估冠状松弛,以检测屈中不稳定。
局限性
- 需要进一步的体内研究来了解这种屈中冠状松弛是否具有负面临床意义。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
AIMS: Surgeons commonly resect additional distal femur during primary total knee arthroplasty (TKA) to correct a flexion contracture, which leads to femoral joint line elevation. There is a paucity of data describing the effect of joint line elevation on mid-flexion stability and knee kinematics. Thus, the goal of this study was to quantify the effect of joint line elevation on mid-flexion laxity. METHODS: Six computational knee models with cadaver-specific capsular and collateral ligament properties were implanted with a posterior-stabilized (PS) TKA. A 10° flexion contracture was created in each model to simulate a capsular contracture. Distal femoral resections of + 2 mm and + 4 mm were then simulated for each knee. The knee models were then extended under a standard moment. Subsequently, varus and valgus moments of 10 Nm were applied as the knee was flexed from 0° to 90° at baseline and repeated after each of the two distal resections. Coronal laxity (the sum of varus and valgus angulation with respective maximum moments) was measured throughout flexion. RESULTS: With + 2 mm resection at 30° and 45° of flexion, mean coronal laxity increased by a mean of 3.1° (SD 0.18°) (p < 0.001) and 2.7° (SD 0.30°) (p < 0.001), respectively. With + 4 mm resection at 30° and 45° of flexion, mean coronal laxity increased by 6.5° (SD 0.56°) (p < 0.001) and 5.5° (SD 0.72°) (p < 0.001), respectively. Maximum increased coronal laxity for a + 4 mm resection occurred at a mean 15.7° (11° to 33°) of flexion with a mean increase of 7.8° (SD 0.2°) from baseline. CONCLUSION: With joint line elevation in primary PS TKA, coronal laxity peaks early (about 16°) with a maximum laxity of 8°. Surgeons should restore the joint line if possible; however, if joint line elevation is necessary, we recommend assessment of coronal laxity at 15° to 30° of knee flexion to assess for mid-flexion instability. Further in vivo studies are warranted to understand if this mid-flexion coronal laxity has negative clinical implications. Cite this article: Bone Joint J 2021;103-B(6 Supple A):87-93.
引用
- Chalmers BP, Elmasry SS, Kahlenberg CA, et al. Additional distal femoral resection increases mid-flexion coronal laxity in posterior-stabilized total knee arthroplasty with flexion contracture : a computational study. Bone Joint J. 2021. PMID: 34053287. doi:10.1302/0301-620X.103B6.BJJ-2020-2444.R1
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。