反向全肩关节置换术不同假体设计的并发症系统综述
该系统综述纳入42项研究,比较三种反向全肩关节置换假体设计在肩袖撕裂关节病、巨大肩袖撕裂、骨关节炎和类风湿关节炎患者中的并发症模式。荟萃分析显示,内侧盂/内侧肱骨设计肩胛骨切迹发生率显著更高(52%,95%CI 40-63),高于内侧盂/外侧肱骨(18%,95%CI 6-34)和外侧盂/内侧肱骨(12%,95%CI 3-26);内侧盂/内侧肱骨假体盂松动率也更高(6%,95%CI 3-10)vs(0%,95%CI 0-2),但证据强度低。其他并发症及患者报告结局测量(PROMs)在各设计间无显著差异。
要点
- 内侧盂/内侧肱骨假体肩胛骨切迹发生率显著高于其他两种设计。
- 内侧盂/内侧肱骨假体盂松动率较高,但证据强度低。
- 各假体设计间PROMs无显著差异,总体并发症率低。
核心结论
- 三种假体设计均显示PROMs显著改善且并发症率低。
- 肩胛骨切迹是唯一明确与内侧盂/内侧肱骨设计显著相关的并发症。
研究设计与样本
- 系统综述与荟萃分析,检索MEDLINE和Embase,纳入42项研究。
- 纳入接受反向全肩关节置换术治疗肩袖撕裂关节病、巨大肩袖撕裂、骨关节炎和类风湿关节炎的患者。
- 比较Routman等分类的三种假体设计:内侧盂/内侧肱骨、内侧盂/外侧肱骨、外侧盂/内侧肱骨。
- 采用Wylde非累加四点系统评估方法学质量,研究注册于PROSPERO(CRD42020193041)。
主要发现
- 肩胛骨切迹发生率:内侧盂/内侧肱骨52%(95%CI 40-63),内侧盂/外侧肱骨18%(95%CI 6-34),外侧盂/内侧肱骨12%(95%CI 3-26),内侧盂/内侧肱骨显著更高。
- 盂松动发生率:内侧盂/内侧肱骨6%(95%CI 3-10),内侧盂/外侧肱骨0%(95%CI 0-2),但证据强度低。
- 其他并发症及PROMs在各假体设计间无显著差异。
关键数值与推荐
- 肩胛骨切迹发生率内侧盂/内侧肱骨52%(95%CI 40-63)vs 内侧盂/外侧肱骨18%(95%CI 6-34)vs 外侧盂/内侧肱骨12%(95%CI 3-26)。
- 盂松动发生率内侧盂/内侧肱骨6%(95%CI 3-10)vs 内侧盂/外侧肱骨0%(95%CI 0-2),证据强度低。
临床怎么用
- 选择反向全肩关节置换假体时,内侧盂/内侧肱骨设计需关注肩胛骨切迹风险。
- 内侧盂/内侧肱骨设计的盂松动风险证据强度低,需谨慎解读。
- 三种设计PROMs改善相似,假体选择可综合并发症模式个体化决策。
局限性
- 盂松动比较的证据强度低。
- 方法学质量采用Wylde非累加四点系统评估,原文未报告具体质量分布。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
AIMS: This systematic review asked which patterns of complications are associated with the three reverse total shoulder arthroplasty (RTSA) prosthetic designs, as classified by Routman et al, in patients undergoing RTSA for the management of cuff tear arthropathy, massive cuff tear, osteoarthritis, and rheumatoid arthritis. The three implant design philosophies investigated were medial glenoid/medial humerus (MGMH), medial glenoid/lateral humerus (MGLH), and lateral glenoid/medial humerus (LGMH). METHODS: A systematic review of the literature was performed via a search of MEDLINE and Embase. Two reviewers extracted data on complication occurrence and patient-reported outcome measures (PROMs). Meta-analysis was conducted on the reported proportion of complications, weighted by sample size, and PROMs were pooled using the reported standardized mean difference (SMD). Quality of methodology was assessed using Wylde's non-summative four-point system. The study was registered with PROSPERO (CRD42020193041). RESULTS: A total of 42 studies met the inclusion and exclusion criteria. Rates of scapular notching were found to be significantly higher in MGMH implants (52% (95% confidence interval (CI) 40 to 63)) compared with MGLH ((18% (95% CI 6 to 34)) and LGMH (12% (95% CI 3 to 26)). Higher rates of glenoid loosening were seen in MGMH implants (6% (95% CI 3 to 10)) than in MGLH implants (0% (95% CI 0 to 2)). However, strength of evidence for this finding was low. No significant differences were identified in any other complication, and there were no significant differences observed in PROMs between implant philosophies. CONCLUSION: This systematic review has found significant improvement in PROMS and low complication rates across the implant philosophies studied. Scapular notching was the only complication found definitely to have significantly higher prevalence with the MGMH implant design. Cite this article: Bone Joint J 2021;103-B(5):813-821.
引用
- Burden EG, Batten TJ, Smith CD, et al. Reverse total shoulder arthroplasty. Bone Joint J. 2021. PMID: 33616421. doi:10.1302/0301-620X.103B.BJJ-2020-2101
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。