文献速递关节外科脊柱外科

脊柱矫正融合术后植入物撞击模拟预防全髋关节置换脱位

Simulation of Implant Impingement After Spinal Corrective Fusion Surgery in Patients with Previous Total Hip Arthroplasty: A Retrospective Case Series.
PubMed 文献 · Spine (Phila Pa 1976) · 2021-01-01

本研究为回顾性病例系列,纳入12例既往全髋关节置换(THA)的成人脊柱畸形患者,术前用CT软件模拟THA前侧植入物撞击并测量可耐受骨盆倾斜(PT),术中据此调整腰椎前凸角度。结果显示模拟组THA脱位2/7例(28.6%),非模拟组4/5例(80%),但该方法在部分患者中未能预防脱位。

要点

  • 术前CT模拟THA前侧撞击并测量可耐受PT,可指导脊柱矫正融合术中腰椎前凸调整。
  • 模拟组THA脱位率为28.6%(2/7),非模拟组为80%(4/5)。
  • 术前与可耐受PT差值为-25°至33°,3例为负值,其前侧撞击和脱位风险随腰椎前凸矫正显著增加。

核心结论

  • 术前模拟THA前侧植入物撞击并调整脊柱矫正程度有助于预防脱位,但该方法在部分患者中未能预防脱位。

研究设计与样本

  • 回顾性病例系列,纳入12例既往THA的连续患者(2男10女,脊柱手术时平均年龄72.1岁,范围55-81岁),数据来自单中心前瞻性收集的成人脊柱畸形手术数据库。
  • 术前使用基于CT的软件进行THA前侧植入物撞击模拟,测量髋关节120°屈曲位发生前侧撞击的可耐受骨盆倾斜(PT)。
  • 脊柱手术中根据可耐受PT有意减少腰椎前凸角度,并与2014年之前未进行模拟的患者进行比较以验证效果。

主要发现

  • THA脱位共发生6例:非模拟组5例中4例(80%),模拟组7例中2例(28.6%)。
  • 术前与可耐受PT角度差值为-25°至33°,其中3例为负值。
  • 在3例负值患者中,若PT偏前,矫正腰椎前凸时前侧撞击和THA脱位风险显著增加。
  • 2例患者发生反复THA脱位,术后与可耐受PT角度差分别为2°和-23°。

关键数值与推荐

  • 可耐受PT定义为髋关节120°屈曲位发生THA前侧植入物撞击时的骨盆倾斜角度。
  • THA脱位率:非模拟组4/5例(80%),模拟组2/7例(28.6%)。
  • 术前与可耐受PT差值范围-25°至33°,3例为负值。
  • 反复脱位2例的术后与可耐受PT角度差分别为2°和-23°。

临床怎么用

  • 对既往THA的脊柱畸形矫正融合患者,术前可考虑CT模拟THA前侧撞击并测量可耐受PT。
  • 术中根据可耐受PT调整腰椎前凸矫正程度,以降低THA脱位风险。
  • 对术前与可耐受PT差值为负值者需警惕前侧撞击和脱位风险增加。

局限性

  • 回顾性病例系列,证据等级为4级。
  • 样本量小(12例),模拟组与非模拟组比较基于历史对照。
  • 该方法在部分患者中未能预防脱位。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

STUDY DESIGN: A retrospective case series. OBJECTIVE: The aim of this study was to introduce the prevention of total hip arthroplasty (THA) dislocation using an implant impingement simulation after spinal corrective fusion and to verify the outcomes. SUMMARY OF BACKGROUND DATA: A high dislocation rate was found among patients who underwent spinal deformity corrective fusion with previous THA. To avoid dislocation, an appropriate position of the stem and cup is important, but the pelvic inclination may change after corrective fusion for spinal deformity. METHODS: Twelve consecutive patients (two men, 10 women; average age, 72.1 [range, 55-81] years during spine surgery) with previous THA were included. Data were retrospectively retrieved from a single-center's prospectively collected database of adult spinal deformity operation. Before surgery, anterior implant impingement simulation in THA was performed using computed tomography-based software. The tolerable pelvic tilt (PT) in which the anterior implant impingement occurred in the hip at the 120° flexion position was measured. The lumbar lordosis angle was deliberately reduced during spinal surgery according to the tolerable PT. The effect of the implant impingement simulation was verified by comparison with patients who underwent surgery before simulation (before 2014). RESULTS: THA dislocation occurred in six patients: four of five (80%) in the non-simulation, and two of seven (28.6%) in the simulation group. The difference between the preoperative and tolerable PT angles was-25° to 33°, and three patients had negative angles. In these three patients, the risk of anterior impingement and THA dislocation significantly increased with correction of lumbar lordosis if the PT was anterior. Two patients experienced repeated THA dislocation with postoperative and tolerable PT angle differences of 2° and -23°. CONCLUSION: Our simulation of anterior implant impingement and subsequent adjustment of the degree of spinal correction was useful to prevent dislocation. However, this method did not prevent dislocation in some patients.Level of Evidence: 4.

来源:Spine (Phila Pa 1976),查看原文。版权归原作者所有。

引用

  1. Yamato Y, Furuhashi H, Hasegawa T, et al. Simulation of Implant Impingement After Spinal Corrective Fusion Surgery in Patients with Previous Total Hip Arthroplasty: A Retrospective Case Series. Spine (Phila Pa 1976). 2021. PMID: 33273444. doi:10.1097/BRS.0000000000003836

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。