高偏距股骨柄对高风险全髋关节置换术后脱位具有保护作用
该回顾性研究纳入2016至2018年行全髋关节置换术的12,365例患者,比较标准偏距与高偏距股骨柄的脱位率,并对50例脊柱僵硬患者进行基于CT的撞击模拟。结果显示总体脱位率为0.41%,脱位患者中96%使用标准偏距柄;偏距每增加1 mm,撞击前活动范围增加5度。作者认为在高风险全髋关节置换术中,术者应考虑使用高偏距股骨柄并注意偏距恢复。
要点
- 12,365例全髋关节置换术中脱位51例,脱位率0.41%。
- 脱位患者中49例(96%)使用标准偏距股骨柄。
- 脊柱僵硬患者模拟中,偏距每增加1 mm,撞击前活动范围增加5度。
核心结论
- 在撞击模型中,高偏距股骨柄在骨性撞击前提供更大的活动范围,并导致更低的脱位率。
- 对于因脊柱僵硬而处于高脱位风险的全髋关节置换术,作者认为术者应考虑使用高偏距股骨柄并注意偏距恢复。
研究设计与样本
- 回顾性研究,纳入2016至2018年行全髋关节置换术的12,365例患者,分析脱位率及标准偏距与高偏距股骨柄的使用情况。
- 对50例连续脊柱僵硬患者,采用基于CT的计算机软件撞击建模系统,在模拟活动范围内评估骨性或假体撞击,每位患者以不同偏距运行模型5次。
主要发现
- 整个队列共发生51例脱位,脱位率为0.41%。
- 整个队列中高偏距股骨柄的总体使用率为49%。
- 发生脱位的患者中,49例(96%)使用标准偏距股骨柄。
- 撞击建模显示,偏距每增加1 mm,撞击前活动范围增加5度。
临床怎么用
- 对于因脊柱僵硬而处于高脱位风险的全髋关节置换术,作者认为术者应考虑使用高偏距股骨柄并注意偏距恢复。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: Spinal stiffness has been shown to increase risk of dislocation due to impingement and instability. Increasing anteversion of the acetabular component has been suggested to prevent dislocation, but little has been discussed in terms of femoral or global offset restoration. The purpose of this study is to quantify dislocation rates after primary THA using standard versus high-offset femoral components and to determine how differences in offset affect impingement-free range of motion in a stiff spine cohort using a novel impingement model. METHODS: A total of 12,365 patients undergoing THA from 2016 to 2018 were retrospectively reviewed to determine dislocation rates and utilization of standard- versus high-offset stems. For 50 consecutive patients with spinal stiffness, a CT-based computer software impingement modeling system assessed bony or prosthetic impingement during simulated range of motion. The model was run 5 times for each patient with varying offsets. Range of motion was simulated in each scenario to determine the degree at which impingement occurred. RESULTS: There were 51 dislocations for a 0.41% dislocation rate. Total utilization of high-offset stems in the entire cohort was 49%. Of those patients who sustained a dislocation, 49 (96%) utilized a standard-offset stem. The impingement modeling demonstrated 5 degrees of added range of motion until impingement for every 1 mm offset increase. CONCLUSION: In the impingement model, high-offset stems facilitated greater ROM before bony impingement and resulted in lower dislocation rates. In the setting of high-risk THA due to spinal stiffness, surgeons should consider the use of high-offset stems and pay attention to offset restoration.
引用
- Vigdorchik JM, Sharma AK, Elbuluk AM, et al. High Offset Stems Are Protective of Dislocation in High-Risk Total Hip Arthroplasty. J Arthroplasty. 2020. PMID: 32741711. doi:10.1016/j.arth.2020.07.016
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。