俯卧位牵引X线片预测腰椎退变性滑脱的矫正效果
本研究纳入63例连续腰椎退变性滑脱患者,比较俯卧牵引位、过屈过伸位及站立位X线片与术后滑移距离、滑移角、椎间盘高度和腰椎前凸变化的相关性。俯卧牵引位X线片对椎间融合术后滑移距离和椎间盘高度矫正的预测最佳,ROC截断值显示俯卧牵引位椎间盘高度8.5 mm时需行椎间融合以达到节段前凸角增加3.0°。
要点
- 俯卧牵引位X线片对椎间融合术后滑移距离和椎间盘高度矫正的预测最佳。
- 俯卧牵引位椎间盘高度8.5 mm为ROC截断值,对应节段前凸角增加3.0°需行椎间融合。
- 滑移角矫正的最佳预测指标为过伸位X线片(AICc=26.453)。
核心结论
- 俯卧牵引位X线片对腰椎退变性滑脱椎间融合术后滑移距离和椎间盘高度的矫正预测最佳。
- 若术前俯卧牵引位X线片椎间盘高度超过8.5 mm,为达到最大矫正应行椎间融合。
研究设计与样本
- 研究纳入自2010年以来连续63例腰椎退变性滑脱患者,均有术前俯卧牵引位X线片。
- 在术前站立侧位、过屈过伸侧位、俯卧牵引侧位及术后站立侧位X线片上测量滑移距离、滑移角、椎间盘高度、节段前凸角和整体前凸角(L1至S1)。
- 患者分为后外侧融合组和后外侧融合加椎间融合组两组。
主要发现
- 椎间融合组节段前凸角和整体前凸角平均变化分别为7.1°(标准差6.7°)和2.9°(标准差9.9°),仅后外侧融合组分别为0.8°(标准差5.1°)和-0.4°(标准差10.1°)。
- 椎间融合矫正的节段前凸角与俯卧牵引位X线片相关性最佳(ρ=0.794,p<0.001)。
- 整体腰椎前凸角与椎间融合组及术前站立侧位X线片相关性最佳(ρ=0.788,p<0.001)。
- 俯卧牵引位与术后X线片间滑移距离差值最小(-0.3 mm,标准差1.7 mm,p<0.001),滑移角差值最小(0.9°,标准差5.2°,p<0.001),椎间盘高度差值最小(0.02 mm,标准差2.4 mm,p<0.001)。
- 回归分析提示俯卧牵引参数对滑移距离矫正(校正赤池信息准则AICc=37.336)和椎间盘高度矫正(AICc=58.096)预测最佳,滑移角矫正(AICc=26.453)最佳预测指标为过伸位X线片。
关键数值与推荐
- ROC截断值显示,以68.3%灵敏度和64.5%特异度,为达到节段前凸角增加3.0°,俯卧牵引位椎间盘高度为8.5 mm的患者需行椎间融合。
临床怎么用
- 作者认为俯卧牵引位X线片对腰椎退变性滑脱椎间融合术后滑移距离和椎间盘高度矫正预测最佳。
- 作者认为为达到最大矫正,若术前俯卧牵引位X线片椎间盘高度超过8.5 mm应行椎间融合。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
AIMS: To determine the effectiveness of prone traction radiographs in predicting postoperative slip distance, slip angle, changes in disc height, and lordosis after surgery for degenerative spondylolisthesis of the lumbar spine. METHODS: A total of 63 consecutive patients with a degenerative spondylolisthesis and preoperative prone traction radiographs obtained since 2010 were studied. Slip distance, slip angle, disc height, segmental lordosis, and global lordosis (L1 to S1) were measured on preoperative lateral standing radiographs, flexion-extension lateral radiographs, prone traction lateral radiographs, and postoperative lateral standing radiographs. Patients were divided into two groups: posterolateral fusion or posterolateral fusion with interbody fusion. RESULTS: The mean changes in segmental lordosis and global lordosis were 7.1° (SD 6.7°) and 2.9° (SD 9.9°) respectively for the interbody fusion group, and 0.8° (SD 5.1°) and -0.4° (SD 10.1°) respectively for the posterolateral fusion-only group. Segmental lordosis (ρ = 0.794, p < 0.001) corrected by interbody fusion correlated best with prone traction radiographs. Global lumbar lordosis (ρ = 0.788, p < 0.001) correlated best with the interbody fusion group and preoperative lateral standing radiographs. The least difference in slip distance (-0.3 mm (SD 1.7 mm), p < 0.001), slip angle (0.9° (SD 5.2°), p < 0.001), and disc height (0.02 mm (SD 2.4 mm), p < 0.001) was seen between prone traction and postoperative radiographs. Regression analyses suggested that prone traction parameters best predicted correction of slip distance (Corrected Akaike's Information Criterion (AICc) = 37.336) and disc height (AICc = 58.096), while correction of slip angle (AICc = 26.453) was best predicted by extension radiographs. Receiver operating characteristic (ROC) cut-off showed, with 68.3% sensitivity and 64.5% specificity, that to achieve a 3.0° increase in segmental lordotic angle, patients with a prone traction disc height of 8.5 mm needed an interbody fusion. CONCLUSION: Prone traction radiographs best predict the slip distance and disc height correction achieved by interbody fusion for lumbar degenerative spondylolisthesis. To achieve this maximum correction, interbody fusion should be undertaken if a disc height of more than 8.5 mm is attained on preoperative prone traction radiographs. Level of Evidence: Level II Prognostic Study Cite this article: Bone Joint J 2020;102-B(8):1062-1071.
引用
- Cheung JPY, Fong HK, Cheung PWH, et al. Predicting spondylolisthesis correction with prone traction radiographs. Bone Joint J. 2020. PMID: 32731831. doi:10.1302/0301-620X.102B8.BJJ-2020-0528.R1
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。