桡骨远端骨折掌侧钢板固定后背侧螺钉穿出的诊断:术中3D透视与背侧切线位比较
本研究回顾性分析165例掌侧钢板固定治疗关节内桡骨远端骨折的前瞻性入组患者,比较三种术中成像方案对背侧皮质螺钉穿出的检测效能,以术后CT多平面重建为参考标准。结果显示,背侧切线位视图的灵敏度为39%、阴性预测值91%、准确率91%;3D透视灵敏度25%、阴性预测值93%、准确率93%。结论认为先进术中成像有助于识别穿出背侧间室的螺钉,但不能断定3D透视优于背侧切线位视图,后者足够准确且可能更有效。
要点
- 背侧切线位视图检测背侧螺钉穿出的灵敏度为39%,阴性预测值91%,准确率91%。
- 3D透视检测背侧螺钉穿出的灵敏度为25%,阴性预测值93%,准确率93%。
- 术后CT显示2D透视组40%、2D+背侧切线位组32%、3D透视组25%的患者存在穿出螺钉。
核心结论
- 先进术中成像有助于识别穿出腕部背侧间室的螺钉。
- 基于诊断性能特征,不能断定3D透视在检测背侧螺钉穿出方面优于背侧切线位视图。
- 背侧切线位视图检测背侧螺钉穿出足够准确,且可能比3D透视更有效。
研究设计与样本
- 回顾性评估165例前瞻性入组的关节内桡骨远端骨折掌侧钢板固定患者。
- 比较三种术中成像方案:标准2D透视(正位和抬高侧位,n=55);2D透视加正位、侧位和背侧切线位视图(n=50);3D透视(n=60)。
- 以术后CT多平面重建作为参考标准。
主要发现
- 背侧切线位视图检测背侧螺钉穿出的灵敏度为39%,阴性预测值91%,准确率91%。
- 3D透视检测背侧螺钉穿出的灵敏度为25%,阴性预测值93%,准确率93%。
- 术后CT显示穿出螺钉的患者比例:2D透视组40%,2D透视加背侧切线位组32%,3D透视组25%。
- 三组中第二间室均易发生穿出,使用更先进成像时术后穿出发生率降低。
- 3D透视组第三间室(拇长伸肌腱沟)无穿出螺钉,背侧切线位组有1例。
临床怎么用
- 背侧切线位视图可作为检测掌侧钢板固定后背侧螺钉穿出的有效术中成像方法。
- 3D透视虽能降低术后穿出发生率,但诊断性能未显示优于背侧切线位视图。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
AIMS: The aim of this study was to investigate whether intraoperative 3D fluoroscopic imaging outperforms dorsal tangential views in the detection of dorsal cortex screw penetration after volar plating of an intra-articular distal radial fracture, as identified on postoperative CT imaging. METHODS: A total of 165 prospectively enrolled patients who underwent volar plating for an intra-articular distal radial fracture were retrospectively evaluated to study three intraoperative imaging protocols: 1) standard 2D fluoroscopic imaging with anteroposterior (AP) and elevated lateral images (n = 55); 2) 2D fluoroscopic imaging with AP, lateral, and dorsal tangential views images (n = 50); and 3) 3D fluoroscopy (n = 60). Multiplanar reconstructions of postoperative CT scans served as the reference standard. RESULTS: In order to detect dorsal screw penetration, the sensitivity of dorsal tangential views was 39% with a negative predictive value (NPV) of 91% and an accuracy of 91%; compared with a sensitivity of 25% for 3D fluoroscopy with a NPV of 93% and an accuracy of 93%. On the postoperative CT scans, we found penetrating screws in: 1) 40% of patients in the 2D fluoroscopy group; 2) in 32% of those in the 2D fluoroscopy group with AP, lateral, and dorsal tangential views; and 3) in 25% of patients in the 3D fluoroscopy group. In all three groups, the second compartment was prone to penetration, while the postoperative incidence decreased when more advanced imaging was used. There were no penetrating screws in the third compartment (extensor pollicis longus groove) in the 3D fluoroscopy groups, and one in the dorsal tangential views group. CONCLUSION: Advanced intraoperative imaging helps to identify screws which have penetrated the dorsal compartments of the wrist. However, based on diagnostic performance characteristics, one cannot conclude that 3D fluoroscopy outperforms dorsal tangential views when used for this purpose. Dorsal tangential views are sufficiently accurate to detect dorsal screw penetration, and arguably more efficacious than 3D fluoroscopy. Cite this article: Bone Joint J 2020;102-B(7):874-880.
引用
- Langerhuizen DWG, Bergsma M, Selles CA, et al. Diagnosis of dorsal screw penetration after volar plating of a distal radial fracture. Bone Joint J. 2020. PMID: 32600133. doi:10.1302/0301-620X.102B7.BJJ-2019-1489.R1
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。