文献速递关节外科

全髋关节置换术中假体撞击与骨性撞击的动态术前分析

Does Prosthetic or Bony Impingement Occur More Often in Total Hip Arthroplasty: A Dynamic Preoperative Analysis.
PubMed 文献 · J Arthroplasty · 2020-05-11

结果显示标准活动范围屈曲时假体与骨性撞击均可发生,后伸时带唇 liner 模型出现假体撞击;极限活动范围前撞击在32mm和36mm球头中分别78%和88%为骨性,后撞击分别65%和55%为假体性;双动杯在过伸时后假体撞击风险最高(74%)。

要点

  • 标准活动范围屈曲时假体与骨性撞击均可发生,后伸时带唇 liner 出现假体撞击。
  • 极限活动范围前撞击以骨性为主,32mm球头78%、36mm球头88%为骨性。
  • 双动杯在过伸时后假体撞击风险最高,达74%。

核心结论

  • 标准活动范围屈曲时假体与骨性撞击均可发生,后伸时带唇 liner 模型出现假体撞击。
  • 极限活动范围前撞击主要为骨性,36mm球头时骨性撞击占88%。
  • 双动杯在过伸时后假体撞击风险最高,为74%。

研究设计与样本

  • 站立位杯外倾45°、前倾25°,股骨组件和颈长重现原生前倾并匹配对侧肢体长度和偏距。
  • 在标准与极限活动范围重现前、后撞击并记录撞击类型和位置;证据等级为3。

主要发现

  • 标准活动范围屈曲时假体与骨性撞击均发生,后伸时带唇 liner 模型出现假体撞击。
  • 极限活动范围前撞击在32mm球头中78%为骨性,在36mm球头中88%为骨性。
  • 极限活动范围后撞击在32mm球头中65%为假体性,在36mm球头中55%为假体性。
  • 双动杯在过伸时后假体撞击风险最高,为74%。

临床怎么用

  • 术前动态规划可模拟不同活动范围下撞击类型,辅助假体选择与杯定位。
  • 使用36mm球头时屈曲位撞击主要为骨性,带唇 liner 后伸时需注意假体撞击。
  • 双动杯在过伸时后假体撞击风险最高,高活动需求患者应谨慎评估。

局限性

  • 证据等级为3,结论需进一步临床研究证实。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Impingement is a leading cause for instability resulting in revision total hip arthroplasty (THA). Impingement can be prosthetic, bony, or soft tissue. The purpose of this study is to investigate, using a virtual simulation, whether bony or prosthetic impingement presents first in well-positioned THAs. METHODS: Twenty-three patients requiring THA were planned for a ceramic-on-poly cementless construct using dynamic planning software. Cups were orientated at 45° inclination and 25° anteversion when standing. Femoral components and neck lengths were positioned to reproduce native anteversion and match contralateral leg length and offset. The type and location of impingement was then recorded with recreation of anterior and posterior impingement during standard and extreme ranges of motion (ROM). RESULTS: In standard ROM, flexion produced both prosthetic and bony impingement and extension resulted in prosthetic impingement in models with lipped liners. In extreme ROM, anterior impingement was 78% bony in 32-mm articulations, and 88% bony in 36-mm articulations. Posterior impingement was 65% prosthetic in 32-mm articulations, and 55% prosthetic in 36-mm articulations. Dual mobility cups showed the greatest risk of posterior prosthetic impingement in hyperextension (74%). CONCLUSION: In standard ROM, both bony and prosthetic impingement occurred in flexion, while prosthetic impingement occurred in extension in models with lipped liners. In hyperextension, prosthetic impingement was more common than bony impingement, and was exclusively the cause of impingement when a lip was used. In flexion, impingement was primarily bony with the use of a 36-mm head. The risk of posterior prosthetic impingement was greatest with dual mobility cups. LEVEL OF EVIDENCE: 3.

来源:J Arthroplasty,查看原文。版权归原作者所有。

引用

  1. Vigdorchik JM, Sharma AK, Madurawe CS, et al. Does Prosthetic or Bony Impingement Occur More Often in Total Hip Arthroplasty: A Dynamic Preoperative Analysis. J Arthroplasty. 2020. PMID: 32507449. doi:10.1016/j.arth.2020.05.009

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。