电子束辐照移动平台全膝关节置换术后15年未检测到聚乙烯磨损
本研究评估电子束辐照高交联聚乙烯全膝关节置换术后10年以上的显著磨损风险,纳入2001至2004年两中心578例置换,448例获得10年以上完整随访,仅1例因聚乙烯磨损于13年翻修,非翻修病例最终影像学未见显著磨损,10年机械性翻修生存率98.0%,15年降至96.2%。
要点
- 578例电子束辐照高交联聚乙烯全膝关节置换中,仅1例因聚乙烯磨损于13年翻修。
- 非翻修病例最终影像学评估未检测到显著聚乙烯磨损。
- 仅机械性翻修10年生存率98.0%,15年降至96.2%。
核心结论
- 电子束辐照聚乙烯的使用与极低的磨损发生率相关。
- 作者认为该技术在聚乙烯行为方面对于全膝关节置换术后10年以上可考虑为安全。
- 作者认为可能不需要进一步改进聚乙烯制造。
研究设计与样本
- 研究纳入2001至2004年在两个参与中心接受该特定全膝关节置换的所有患者。
- 所有患者在10年随访后接受重复临床检查和影像学评估,并记录最终评估前翻修的发生及原因。
- 在平片X线上测量聚乙烯部件厚度。
主要发现
- 研究期间共植入578例全膝关节置换。
- 116例患者(20%)在10年随访前死亡,另有121例患者(21%)在10年随访前失访。
- 448例(78%)获得10年以上完整随访(包括死亡或翻修)。
- 随访期间因机械性原因行10例假体翻修(2%),仅1例因13年后聚乙烯磨损行翻修。
- 非翻修病例最终影像学评估未检测到显著聚乙烯磨损。
关键数值与推荐
- 仅机械性翻修的10年生存率为98.0%,15年降至96.2%。
- 578例全膝关节置换中,10例(2%)因机械性原因翻修。
- 578例中1例因13年后聚乙烯磨损翻修。
临床怎么用
- 原文结论认为该技术在聚乙烯行为方面对于全膝关节置换术后10年以上可考虑为安全。
- 原文结论认为可能不需要进一步改进聚乙烯制造。
局限性
- 116例患者(20%)在10年随访前死亡。
- 另有121例患者(21%)在10年随访前失访。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: The present study was designed to evaluate the risk of significant polyethylene (PE) wear 10 years or more after implantation of a total knee arthroplasty (TKA) using electron beam-irradiated highly cross-linked PE component. METHODS: All patients operated between 2001 and 2004 for implantation of this particular TKA in the two participating centers were eligible for this study. All patients were contacted after the 10-year follow-up for repeat clinical examination and radiological evaluation. The occurrence of a revision prior to the final evaluation and its reason were recorded. The thickness of the PE piece was measured on plain X-rays. RESULTS: Five hundred seventy-eight TKAs were implanted during the study time-frame. One hundred sixteen patients deceased prior to the 10-year follow-up (20%). An additional 121 patients were lost to follow-up prior to the 10-year follow-up (21%). Complete follow-up at 10 years or more (including death or revision) was obtained for 448 cases (78%). Ten prosthetic revisions were performed for mechanical reasons during the follow-up time (2%). One single revision was performed because PE wear after 13 years. No significant PE wear was detected at the final radiographic evaluation for nonrevised cases. The 10-year survival rate for mechanical revision only was 98.0% and decreased to 96.2% at 15 years. CONCLUSION: The use of electron beam-irradiated PE was associated with an extremely low incidence of wear. This technology may be considered as safe regarding PE behavior for TKA after more than 10 years. Further improvement of PE manufacturing may be not required.
引用
- Jenny JY, Saragaglia D. No Detectable Polyethylene Wear 15 Years After Implantation of a Mobile-Bearing Total Knee Arthroplasty With Electron Beam-Irradiated Polyethylene. J Arthroplasty. 2019. PMID: 31000400. doi:10.1016/j.arth.2019.03.054
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。