模块化双动髋臼假体在全髋关节翻修术中的多中心评估
这项多机构回顾性队列研究纳入2011至2017年间315例使用模块化双动(MDM)假体行全髋关节翻修术的髋关节,平均随访3.3年。术后9髋(2.9%)出现不稳,30髋(9.5%)需再手术;复发性不稳与仅更换内衬(P=0.021)及内衬外径≤38 mm(P=0.016)相关。
要点
- 翻修全髋使用MDM假体术后不稳发生率为2.9%,再手术率为9.5%。
- 复发性不稳与仅更换内衬(P=0.021)及聚乙烯内衬外径≤38 mm(P=0.016)相关。
- 作者结论认为MDM在翻修队列中不稳与再手术率低。
核心结论
- 使用MDM假体行翻修全髋关节置换术在翻修队列中提供了低的不稳率和再手术率。
- 翻修全髋使用MDM后复发性不稳与保留髋臼组件及聚乙烯外径≤38 mm相关。
研究设计与样本
- 多机构回顾性队列研究,纳入2011年至2017年间使用MDM行翻修全髋关节置换术的315髋。
- 315例患者达到至少1年随访,平均随访3.3年,收集临床结局和失败原因。
主要发现
- 术后9髋出现不稳(2.9%),30髋需再手术(9.5%)。
- 7髋出现复发性不稳(6.5%),其与仅更换内衬(P=0.021)及内衬外径≤38 mm(P=0.016)相关。
临床怎么用
- 原文未据此给出推荐。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
INTRODUCTION: Modular Dual Mobility (MDM) constructs in total hip arthroplasty (THA) offer increased hip stability compared with constrained liners, without compromising hip range of motion. The purpose of this study was to evaluate outcomes of revision THA using MDM. METHODS: The study was a multiinstitutional retrospective cohort study of 315 hips that underwent revision THA using MDM between 2011 and 2017. Clinical outcomes and reasons for failure were collected. RESULTS: Three hundred fifteen patients met 1-year minimum follow-up (mean 3.3 years). Nine hips had instability postoperatively (2.9%), and 30 hips required reoperation (9.5%). Seven had recurrent instability (6.5%) which was associated with liner-only exchange (P = .021) and liner outer diameter of ≤ 38 mm (P = .016). CONCLUSION: Revision THA with MDM provided a low rate of instability and reoperation in a revision cohort. Recurrent instability following use of MDM in revision THA was associated with retention of the acetabular component and polyethylene outer diameter ≤ 38 mm. LEVEL OF EVIDENCE: Therapeutic Level III.
引用
- Huang RC, Malkani AL, Harwin SF, et al. Multicenter Evaluation of a Modular Dual Mobility Construct for Revision Total Hip Arthroplasty. J Arthroplasty. 2019. PMID: 31005430. doi:10.1016/j.arth.2019.03.027
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。