文献速递运动医学关节外科

垂直褥式与交叉缝合技术及单排与双排配置治疗桶柄状内侧半月板撕裂的生物力学比较

Biomechanical Comparison of Vertical Mattress and Cross-stitch Suture Techniques and Single- and Double-Row Configurations for the Treatment of Bucket-Handle Medial Meniscal Tears.
PubMed 文献 · Am J Sports Med · 2019-03-21

在10对配对尸体膝关节桶柄状内侧半月板撕裂模型中,比较垂直褥式和交叉缝合的单排与双排配置恢复 native 运动学的能力;两种缝合的单排和双排配置均恢复 native 胫股压力,但交叉缝合双排配置接触面积较 intact 减少且压力较垂直双排降低。

要点

  • 垂直褥式和交叉缝合的单排与双排配置均能在各屈曲角度恢复 native 胫股压力。
  • 交叉缝合双排配置在部分屈曲角度未能恢复 intact 接触面积。
  • 交叉缝合双排配置较垂直褥式双排配置显著降低接触面积、平均和峰值接触压力。

核心结论

  • 垂直褥式和交叉缝合由内向外半月板修复技术的单排和双排配置在评估的所有膝关节屈曲角度均恢复桶柄状内侧半月板撕裂后的 native 胫股压力。
  • 尽管交叉缝合双排配置与 intact 状态相比接触面积减少,但与垂直褥式双排修复相比,交叉缝合双排修复导致压力降低。
  • 这些发现仅适用于手术当时,因为未考虑愈合的生物学效应。

研究设计与样本

  • 控制实验室研究,采用10对配对人类尸体膝关节,随机分配至垂直褥式(n=10)或交叉缝合(n=10)修复组。
  • 每个膝关节依次经历4种测试条件:完整状态、移位桶柄状撕裂、股骨半月板表面单排缝合配置、双排缝合配置(修复股骨和胫骨半月板表面)。
  • 在每个条件下,以1000 N轴向压缩力在0°、30°、60°、90°和120°屈曲角度加载,记录内侧间室接触面积、平均接触压力和峰值接触压力。

主要发现

  • 垂直褥式双排配置在0°时未恢复 intact 接触面积(P = .027);交叉缝合双排配置在0°(P = .032)、60°(P < .001)和90°(P = .007)屈曲时未恢复 intact 接触面积。
  • 在任何屈曲角度,垂直褥式和交叉缝合的单排与双排修复与 intact 状态之间,平均接触压力和峰值接触压力均无显著差异。
  • 比较垂直褥式和交叉缝合修复,单排配置在所有屈曲角度无显著差异;双排配置中,交叉缝合修复导致接触面积、平均接触压力和峰值接触压力显著降低(均P < .001)。

临床怎么用

  • 内侧半月板桶柄状撕裂可采用垂直褥式或交叉缝合的单排或双排配置进行修复。

局限性

  • 这些发现仅适用于手术当时,因为未考虑愈合的生物学效应。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Given the variety of suturing techniques for bucket-handle meniscal repair, it is important to assess which suturing technique best restores native biomechanics. PURPOSE/HYPOTHESIS: To biomechanically compare vertical mattress and cross-stitch suture techniques, in single- and double-row configurations, in their ability to restore native knee kinematics in a bucket-handle medial meniscal tear model. The hypothesis was that there would be no difference between the vertical mattress and cross-stitch double-row suture techniques but that the double-row technique would provide significantly improved biomechanical parameters versus the single-row technique. STUDY DESIGN: Controlled laboratory study. METHODS: Ten matched pairs of human cadaver knees were randomly assigned to the vertical mattress (n = 10) or cross-stitch (n = 10) repair group. Each knee underwent 4 consecutive testing conditions: (1) intact, (2) displaced bucket-handle tear, (3) single-row suture configuration on the femoral meniscus surface, and (4) double-row suture configuration (repair of femoral and tibial meniscus surfaces). Knees were loaded with a 1000-N axial compressive force at 0°, 30°, 60°, 90°, and 120° of flexion for each condition. Resultant medial compartment contact area, average contact pressure, and peak contact pressure data were recorded. RESULTS: Intact state contact area was not restored at 0° ( P = .027) for the vertical double-row configuration and at 0° ( P = .032), 60° ( P < .001), and 90° ( P = .007) of flexion for the cross-stitch double-row configuration. No significant differences were found in the average contact pressure and peak contact pressure between the intact state and the vertical mattress and cross-stitch repairs with single- and double-row configurations at any flexion angles. When the vertical and cross-stich repairs were compared across all flexion angles, no significant differences were observed in single-row configurations, but in double-row configurations, cross-stitch repair resulted in a significantly decreased contact area, average contact pressure, and peak contact pressure (all P < .001). CONCLUSION: Single- and double-row configurations of the vertical mattress and cross-stitch inside-out meniscal repair techniques restored native tibiofemoral pressure after a medial meniscal bucket-handle tear at all assessed knee flexion angles. Despite decreased contact area with a double-row configuration, mainly related to the cross-stitch repair, in comparison with the intact state, the cross-stitch double-row repair led to decreased pressure as compared with the vertical double-row repair. These findings are applicable only at the time of the surgery, as the biological effects of healing were not considered. CLINICAL RELEVANCE: Medial meniscal bucket-handle tears may be repaired with the single- or double-row configuration of vertical mattress or cross-stitch sutures.

来源:Am J Sports Med,查看原文。版权归原作者所有。

引用

  1. Nakama GY, Kaleka CC, Franciozi CE, et al. Biomechanical Comparison of Vertical Mattress and Cross-stitch Suture Techniques and Single- and Double-Row Configurations for the Treatment of Bucket-Handle Medial Meniscal Tears. Am J Sports Med. 2019. PMID: 30897004. doi:10.1177/0363546519830402

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。