文献速递关节外科

全髋关节置换术后髋臼溶骨性缺损患者的风险分析:基于个体化有限元建模

Risk analysis of patients with an osteolytic acetabular defect after total hip arthroplasty using subject-specific finite-element modelling.
PubMed 文献 · Bone Joint J · 2018-01-01

本研究对11例全髋关节置换术后髋臼周围溶骨患者构建22个半骨盆有限元模型,分析慢速行走和侧方跌倒时的载荷传递。结果显示溶骨缺损使皮质结构应力增高,整体von Mises应力仅中度增加11.2%,但大缺损(>20cm3)或体型小、皮质薄、骨密度低的患者骨折载荷可能适度降低。

要点

  • 溶骨缺损使皮质结构应力增高,整体von Mises应力中度增加11.2%。
  • 部分区域应力值增加高达100%,骨折部位在部分模型中改变,骨折载荷降低500 N。
  • 最常见骨折部位为耻骨支,在大缺损模型中更常见。

核心结论

  • 松质骨缺损导致皮质结构内应力增高,但若缺损较大(>20cm3)或患者体型小、皮质结构薄且骨密度低,则可能导致骨折载荷适度降低。

研究设计与样本

  • 构建22个半骨盆有限元模型,评估11例全髋关节置换术后髋臼假体周围溶骨患者在慢速行走和侧方跌倒时的载荷传递;9例男性、2例女性,末次随访平均年龄69岁(55至81岁)。

主要发现

  • 有缺损和无缺损模型在两种载荷场景下von Mises应力均增高,部分区域应力值增加高达100%,但整个系列von Mises应力仅中度增加11.2%。
  • 部分模型骨折部位改变,骨折载荷降低500 N。
  • 最常见骨折部位为耻骨支,在大缺损模型中更常见。

关键数值与推荐

  • 缺损较大(>20cm3)或患者体型小、皮质结构薄且骨密度低时,骨折载荷可能适度降低。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

AIMS: Osteolysis, secondary to local and systemic physiological effects, is a major challenge in total hip arthroplasty (THA). While osteolytic defects are commonly observed in long-term follow-up, how such lesions alter the distribution of stress is unclear. The aim of this study was to quantitatively describe the biomechanical implication of such lesions by performing subject-specific finite-element (FE) analysis on patients with osteolysis after THA. PATIENTS AND METHODS: A total of 22 hemipelvis FE models were constructed in order to assess the transfer of load in 11 patients with osteolysis around the acetabular component of a THA during slow walking and a fall onto the side. There were nine men and two women. Their mean age was 69 years (55 to 81) at final follow-up. Changes in peak stress values and loads to fracture in the presence of the osteolytic defects were measured. RESULTS: The von Mises stresses were increased in models of those with and those without defects for both loading scenarios. Although some regions showed increases in stress values of up to 100%, there was only a moderate 11.2% increase in von Mises stress in the series as a whole. The site of fracture changed in some models with lowering of the load to fracture by 500 N. The most common site of fracture was the pubic ramus. This was more frequent in models with larger defects. CONCLUSION: We conclude that cancellous defects cause increases in stress within cortical structures. However, these are likely to lead to a modest decrease in the load to fracture if the defect is large (> 20cm3) or if the patient is small with thin cortical structures and low bone mineral density. Cite this article: Bone Joint J 2018;100-B:1455-62.

来源:Bone Joint J,查看原文。版权归原作者所有。

引用

  1. Munro JT, Millar JS, Fernandez JW, et al. Risk analysis of patients with an osteolytic acetabular defect after total hip arthroplasty using subject-specific finite-element modelling. Bone Joint J. 2018. PMID: 30418069. doi:10.1302/0301-620X.100B11.BJJ-2018-0092.R2

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。