文献速递关节外科

冲洗股骨髓腔可使短锥形股骨柄假体坐位更可预测

Washing the Femoral Canal Results in More Predictable Seating of a Short, Tapered Femoral Stem.
PubMed 文献 · J Arthroplasty · 2018-06-19

该回顾性研究分析了170例使用短锥形非骨水泥干骺端填充股骨柄行初次全髋关节置换术的患者,比较仅锉磨与锉磨后以100毫升生理盐水冲洗髓腔对假体坐位的影响。结果显示,冲洗组锉磨与假体坐位差异超过2毫米的临床显著不匹配发生率显著低于未冲洗组(15% vs 50%),多因素回归证实冲洗显著减少不匹配。

要点

  • 锉磨后以100毫升生理盐水冲洗髓腔可显著减少短锥形股骨柄假体坐位不匹配。
  • 未冲洗组临床显著不匹配发生率为50%(49/99),冲洗组为15%(11/71)。

核心结论

  • 现有锉磨设计虽能为短干骺端填充型股骨柄创造几何空间,但不足以去除骨碎屑以确保假体可重复坐位。
  • 锉磨后、置入最终假体前以生理盐水冲洗股骨干骺端去除骨碎屑,可显著减少最终锉磨与假体坐位之间的不匹配。

研究设计与样本

  • 回顾性分析170例连续接受初次全髋关节置换术并使用短锥形非骨水泥干骺端填充股骨柄的患者。
  • 股骨准备均采用仅锉磨技术;初始99例仅锉磨不冲洗(1组),随后71例锉磨后以100毫升生理盐水冲洗髓腔(2组)。
  • 术中测量股骨距截骨面与锉磨及与最终假体之间的距离,定义两者差异超过2毫米为临床显著不匹配。

主要发现

  • 临床显著不匹配在1组发生率为50%(49/99),在2组为15%(11/71)。

关键数值与推荐

  • 临床显著不匹配定义为锉磨坐位与最终假体坐位差异超过2毫米。
  • 2组在锉磨后、置入假体前以100毫升生理盐水冲洗髓腔以去除所有松散松质骨。

临床怎么用

  • 作者在结论中建议,锉磨后、置入最终假体前以生理盐水冲洗股骨干骺端去除骨碎屑,可显著减少短锥形干骺端填充型非骨水泥股骨柄的坐位不匹配。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: It is critical that a femoral rasp be effective in preparing the proximal femur to accept the size and the geometry of the femoral implant at the time of total hip arthroplasty. Short, tapered femoral stems may be at greater risk because they require the preparation of a short femoral region without any reaming. We undertook a study to determine the effect on implant seating in femora that were prepared by rasping alone with those that were rasped and the canal was washed with saline at the time of cementless THA with a short, tapered femoral implant. METHODS: We retrospectively analyzed the preoperative, intraoperative, and radiographic data on 170 consecutive patients undergoing a primary THA using a short, taper, uncemented metaphyseal-filling stem. The femur was prepared using a rasp-only technique. In the initial 99 patients, the canal was rasped, but not washed (group 1). In the subsequent 71 patients, the canal was rasped and before implant insertion the canal was washed with 100 cc of normal saline to remove all loose cancellous bone (group 2). Intraoperatively, the distance between the calcar cut and the rasp and subsequently, the calcar cut and the implant was measured. We defined a difference of more than 2 mm between the seating of the rasp and the final implant as a clinically significant mismatch. RESULTS: Overall, a clinically significant mismatch occurred in 50% (49/99) of cases in group 1 and 15% (11/71) in group 2. Multivariate logistic regression analysis corrected for preoperative, intraoperative, and radiographic measurements showed that washing significantly decreased the mismatch between the rasp and the implant (odds ratio, 5.32; confidence interval, 2.10-13.73; P < .001). CONCLUSION: Although the present rasp design is sufficient to create the geometric space for this short, metaphyseal stem, it does not adequately remove the bone debris to ensure reproducible seating of the implant. Washing the femoral metaphysis with saline to remove bone debris, after rasping and before inserting the final implant, significantly decreased the mismatch between seating of the final rasp and the implant in this cementless short, metaphyseal-filling, taper design stem. Level of Evidence III.

来源:J Arthroplasty,查看原文。版权归原作者所有。

引用

  1. Husseini A, Nooh A, Tanzer D, et al. Washing the Femoral Canal Results in More Predictable Seating of a Short, Tapered Femoral Stem. J Arthroplasty. 2018. PMID: 30041990. doi:10.1016/j.arth.2018.05.047

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。