金属离子水平预测初次全髋关节置换术后头颈锥度腐蚀所致不良局部组织反应的敏感性与特异性
本研究纳入62例金属对聚乙烯全髋关节置换患者,分为磁共振成像发现不良局部组织反应组(43例)与无不良局部组织反应组(19例),用受试者工作特征曲线确定不同金属离子阈值的敏感性与特异性。结果显示不良局部组织反应组钴、铬及钴/铬比值均显著更高,钴>1 ng/mL和钴/铬比值>2具有较高敏感性与特异性。
要点
- 不良局部组织反应组钴8.9 ng/mL、铬2.26 ng/mL、钴/铬比值5.9均显著高于无不良局部组织反应组。
- 钴阈值1 ng/mL的敏感性95%、特异性94%;钴/铬比值阈值2的敏感性83%、特异性72%。
- 作者认为金属离子水平不应单独作为决定翻修手术的唯一参数。
核心结论
- 尽管金属离子水平不应单独作为决定翻修手术的唯一参数,但血清钴>1 ng/mL(1 ppb)和钴/铬比值>2阈值可为外科医生解读金属对聚乙烯全髋关节置换患者金属离子水平、判断临床相关头颈锥度腐蚀提供循证实用信息。
研究设计与样本
- 共纳入62例金属对聚乙烯全髋关节置换患者,分2个队列:磁共振成像发现不良局部组织反应者43例,磁共振成像无不良局部组织反应者19例;构建受试者工作特征曲线确定不同金属离子阈值的敏感性与特异性及最佳金属离子截断值。
主要发现
- 不良局部组织反应组钴8.9 ng/mL vs 无不良局部组织反应组0.3 ng/mL(P < .001),不良局部组织反应组更高。
- 不良局部组织反应组铬2.26 ng/mL vs 无不良局部组织反应组0.21 ng/mL(P < .001),不良局部组织反应组更高。
- 不良局部组织反应组钴/铬比值5.9 vs 无不良局部组织反应组2.0(P < .001),不良局部组织反应组更高。
- 钴阈值1 ng/mL的敏感性为95%、特异性为94%。
- 钴/铬比值阈值2的敏感性为83%、特异性为72%。
关键数值与推荐
- 钴阈值1 ng/mL:敏感性95%、特异性94%。
- 钴/铬比值阈值2:敏感性83%、特异性72%。
临床怎么用
- 作者认为金属离子水平不应单独作为决定翻修手术的唯一参数。
- 作者指出血清钴>1 ng/mL(1 ppb)和钴/铬比值>2阈值可为外科医生解读金属对聚乙烯全髋关节置换患者金属离子水平、判断临床相关头颈锥度腐蚀提供循证实用信息。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: There is increasing concern regarding the occurrence of adverse local tissue reactions (ALTRs) in metal-on-polyethylene (MoP) total hip arthroplasty (THA) patients due to mechanically assisted crevice corrosion at the head-neck modular taper junction. The utility of metal ion levels in evaluating MoP patients with head-neck taper has not been fully characterized. This study aimed to investigate the sensitivity and specificity of serum metal ions as a predictor of ALTR in MoP THA patients. METHODS: A total of 62 MoP THA patients in 2 cohorts were investigated: (1) ALTR on metal artifact reduction sequence magnetic resonance imaging (n = 43) and (2) without ALTR on metal artifact reduction sequence magnetic resonance imaging (n = 19). Receiver-operating characteristic curve was constructed to determine the sensitivity and specificity using different metal ion thresholds and the optimal metal ion cutoff values. RESULTS: The presence of ALTR was associated with significantly higher cobalt (8.9 ng/mL vs 0.3 ng/mL, P < .001), chromium (2.26 ng/mL vs 0.21 ng/mL, P < .001), and Co/Cr ratio (5.9 vs 2.0, P < .001). The sensitivity and specificity for cobalt (1 ng/mL) was 95% and 94% and for Co/Cr ratio (2) was 83% and 72%, respectively. CONCLUSIONS: Although metal ion levels alone should not be relied on as the sole parameter to determine revision surgery, serum cobalt level of >1 ng/mL (1 ppb) and Co/Cr ratio >2 thresholds provide evidence-based practical information for surgeons when interpreting metal ion levels in MoP THA patients for clinically relevant head-neck taper corrosion.
引用
- Kwon YM, MacAuliffe J, Arauz PG, et al. Sensitivity and Specificity of Metal Ion Level in Predicting Adverse Local Tissue Reactions Due to Head-Neck Taper Corrosion in Primary Metal-on-Polyethylene Total Hip Arthroplasty. J Arthroplasty. 2018. PMID: 29748069. doi:10.1016/j.arth.2018.04.007
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。