过氧化物交联维生素E混合超高分子量聚乙烯残留副产物的研究
本研究在兔皮下植入经高浓度有机过氧化物交联的维生素E混合超高分子量聚乙烯(UHMWPE)样本,用傅里叶变换红外光谱定量残留过氧化物副产物的洗脱,并通过组织学分析评价生物相容性。结果显示副产物在体内发生洗脱,但三组植入物周围组织均表现为纤维化和滑膜样衬里,未见组织学差异。作者认为该化学交联方式未对皮下组织造成不良改变,进一步证明其作为关节置换承重面的可行性。
要点
- 傅里叶变换红外光谱证实残留过氧化物副产物在体内发生洗脱。
- 三组植入物周围组织均以纤维化和滑膜样衬里为特征,未见组织学差异。
- 作者认为高浓度有机过氧化物化学交联UHMWPE未对周围皮下组织造成不良改变。
核心结论
- 以极高浓度有机过氧化物化学交联的UHMWPE未对周围皮下组织造成不良改变,进一步证明用过氧化物而非辐照交联UHMWPE作为关节置换承重面材料的可行性。
研究设计与样本
- 将未交联对照样本、交联样本和交联高温熔融样本植入新西兰白兔皮下28天。
- 采用傅里叶变换红外光谱定量残留过氧化物副产物的洗脱,并通过假体周围组织组织学分析评价生物相容性。
- 交联UHMWPE样本所用过氧化物浓度为改善耐磨性所需标称浓度的5倍。
主要发现
- 傅里叶变换红外光谱证实残留过氧化物副产物在体内发生洗脱。
- 三组植入物接触的组织之间未观察到组织学差异,所有组组织均以纤维化和滑膜样衬里为特征。
临床怎么用
- 原文未据此给出临床推荐。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: Wear resistance of ultrahigh molecular weight polyethylene (UHMWPE) is improved via ionizing radiation crosslinking and subsequent high temperature melting for improved toughness. Our group has previously reported that crosslinking can also be achieved chemically using organic peroxides. However, volatile peroxide byproducts are generated during consolidation. The purpose of this study was to quantify elution of volatile peroxide byproducts from UHMWPE before and after in vivo implantation, and to determine their effects on local tissues. METHODS: We prepared crosslinked UHMWPE samples with 5 times the nominal concentration of peroxide needed for improved wear resistance. Control samples (not crosslinked), crosslinked samples, and crosslinked high temperature melting samples were implanted subcutaneously in New Zealand white rabbits for 28 days. Fourier-transform infrared spectroscopy (FTIR) was used to quantify elution of residual peroxide byproducts, and biocompatibility was determined via histological analysis of periprosthetic tissues. RESULTS: Fourier-transform infrared spectroscopy demonstrated elution of residual peroxide byproducts in vivo. No histological differences were observed between tissues in contact with any of the 3 groups of implants; tissues were characterized by fibrosis and a synovial-like lining for all groups. CONCLUSION: UHMWPE chemically crosslinked with very high concentration of organic peroxide did not show any detrimental changes to surrounding subcutaneous tissues, further demonstrating feasibility of crosslinking UHMWPE with a peroxide, rather than irradiation, for the potential use of the material as a bearing surface for joint arthroplasty.
引用
- Bichara DA, O'Brien CC, Doshi BN, et al. Residual Byproducts of Peroxide Crosslinked Vitamin E-Blended Ultrahigh Molecular Weight Polyethylene. J Arthroplasty. 2018. PMID: 29784551. doi:10.1016/j.arth.2018.03.004
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。