文献速递骨质疏松与代谢性骨病创伤骨科

在男性骨质疏松性骨折(MrOS)研究中,髋部骨折事件与经DXA扫描有限元分析估算的股骨强度的关联

Association of incident hip fracture with the estimated femoral strength by finite element analysis of DXA scans in the Osteoporotic Fractures in Men (MrOS) study.
PubMed 文献 · Osteoporos Int · 2017-11-22

该前瞻性病例-队列研究纳入MrOS研究中91例股骨颈骨折和64例转子间骨折患者及500名随机抽样男性,平均随访7.7±2.2年。采用经验证的股骨近端平面应力线性弹性有限元模型分析基线DXA扫描,估算侧向跌倒时的股骨强度。结果显示,股骨强度估算值与股骨颈骨折风险独立于髋部骨密度相关,但对髋部骨折预测能力的改善仅限于股骨颈骨折且有限。

要点

  • 股骨强度估算与髋部骨折的关联独立于转子间和全髋骨密度,但不独立于股骨颈骨密度。
  • 股骨强度与股骨颈骨折的关联独立于股骨颈、转子间和全髋骨密度,年龄-BMI-骨密度校正后每降低1个标准差的HR为1.68至2.38。
  • 股骨强度对股骨颈骨折的预测能力与股骨颈骨密度相当(Harrell's C指数0.81 vs 0.81),优于转子间和全髋骨密度。

核心结论

  • 股骨强度估算值提供了髋部骨密度以外的额外信息,但其对预测能力的改善仅限于股骨颈骨折且有限。

研究设计与样本

  • 前瞻性病例-队列研究,纳入男性骨质疏松性骨折(MrOS)研究中91例股骨颈骨折和64例转子间骨折病例及500名随机抽样男性(其中14例发生髋部骨折),平均随访7.7±2.2年。
  • 采用经验证的股骨近端平面应力线性弹性有限元模型分析基线髋部DXA扫描,估算侧向跌倒时的股骨强度。

主要发现

  • 股骨强度估算与髋部骨折的关联独立于转子间和全髋骨密度(P<0.05),但不独立于股骨颈骨密度;强度与骨密度联合未改善髋部骨折预测。
  • 股骨强度与股骨颈骨折的关联独立于股骨颈、转子间和全髋骨密度,年龄-BMI-骨密度校正后每降低1个标准差的HR(95%CI)分别为1.68(1.07-2.64)、2.38(1.57-3.61)和2.04(1.34-3.11)。
  • 股骨强度对股骨颈骨折的预测能力与股骨颈骨密度相当(Harrell's C指数0.81 vs 0.81),优于转子间骨密度(0.8 vs 0.78)和全髋骨密度(0.81 vs 0.79)。
  • 股骨强度与转子间骨折的关联不独立于髋部骨密度。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

UNLABELLED: Finite element model can estimate bone strength better than BMD. This study used such a model to determine its association with hip fracture risk and found that the strength estimate provided limited improvement over the hip BMDs in predicting femoral neck (FN) fracture risk only. INTRODUCTION: Bone fractures occur only when it is loaded beyond its ultimate strength. The goal of this study was to determine the association of femoral strength, as estimated by finite element (FE) analysis of DXA scans, with incident hip fracture as a single condition or with femoral neck (FN) and trochanter (TR) fractures separately in older men. METHODS: This prospective case-cohort study included 91 FN and 64 TR fracture cases and a random sample of 500 men (14 had a hip fracture) from the Osteoporotic Fractures in Men study during a mean ± SD follow-up of 7.7 ± 2.2 years. We analysed the baseline DXA scans of the hip using a validated plane-stress, linear-elastic FE model of the proximal femur and estimated the femoral strength during a sideways fall. RESULTS: The estimated strength was significantly (P < 0.05) associated with hip fracture independent of the TR and total hip (TH) BMDs but not FN BMD, and combining the strength with BMD did not improve the hip fracture prediction. The strength estimate was associated with FN fractures independent of the FN, TR and TH BMDs; the age-BMI-BMD adjusted hazard ratio (95% CI) per SD decrease of the strength was 1.68 (1.07-2.64), 2.38 (1.57, 3.61) and 2.04 (1.34, 3.11), respectively. This association with FN fracture was as strong as FN BMD (Harrell's C index for the strength 0.81 vs. FN BMD 0.81) and stronger than TR and TH BMDs (0.8 vs. 0.78 and 0.81 vs. 0.79). The strength's association with TR fracture was not independent of hip BMD. CONCLUSIONS: Although the strength estimate provided additional information over the hip BMDs, its improvement in predictive ability over the hip BMDs was confined to FN fracture only and limited.

来源:Osteoporos Int,查看原文。版权归原作者所有。

引用

  1. Yang L, Parimi N, Orwoll ES, et al. Association of incident hip fracture with the estimated femoral strength by finite element analysis of DXA scans in the Osteoporotic Fractures in Men (MrOS) study. Osteoporos Int. 2017. PMID: 29167969. doi:10.1007/s00198-017-4319-2

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。