胸段特发性脊柱侧凸严重程度与三维胸椎后凸测量高度相关
本研究纳入442例脊柱侧凸门诊患者,采用站立位双平面X线三维重建,分析二维与三维胸椎后凸及顶椎轴向旋转与主胸弯Cobb角的相关性。结果显示三维T5-T12后凸与主胸弯角度呈强负相关(相关系数-0.75),而二维后凸相关性差,三维评估对描述特发性脊柱侧凸多平面畸形至关重要。
要点
- 三维T5-T12后凸与主胸弯角度强负相关(相关系数-0.75),二维后凸相关性差(-0.14)。
- 主胸弯角度每增加1°,三维胸椎后凸减少超过0.5°。
- 主胸弯角度与顶椎轴向旋转及三维T1-T12后凸丢失亦强相关。
核心结论
- 节段性计算的三维胸椎后凸与主胸弯角度呈强负相关,三维后凸随侧凸严重程度增加而递减,递减速率超过主胸弯角度增加量的一半。
- 侧凸严重程度与三维后凸丢失的相关性 surprising 强,而二维分析中未显现;主胸弯角度与顶椎轴向旋转亦呈类似强相关。
- 这些发现进一步支持特发性脊柱侧凸在冠状面、矢状面和轴向同时进展的概念。
研究设计与样本
- 研究纳入在脊柱侧凸门诊评估并判定为正常脊柱或特发性脊柱侧凸的患者,均接受站立位双平面X线摄影及三维重建。
- 记录主胸弯角度和胸椎后凸的二维测量值,利用图像处理和MATLAB分析生成胸椎后凸和顶椎轴向旋转的三维计算值。
- 采用回归分析确定二维后凸、三维后凸及顶椎轴向旋转与主胸弯角度的相关性。
主要发现
- 442例患者的主胸弯角度范围为1°至118°。
- 二维与三维T5-T12后凸对主胸弯角度的线性回归模型均有统计学意义(p < 0.05)。
- 二维模型斜率-0.07,R值0.02,相关系数-0.14,相关性差。
- 三维模型斜率-0.54,R值0.56,相关系数-0.75,呈强负相关。
- 主胸弯角度与三维T1-T12后凸丢失及顶椎轴向旋转增加亦呈强相关。
临床怎么用
- 作者认为三维评估对于充分描述特发性脊柱侧凸的多平面畸形至关重要,矢状面畸形与冠状面畸形相关联。
- 作者指出冠状面弯曲严重程度增加与胸椎后凸进行性丢失相关,应预判此变化,以便在全部三个平面应用适当的术中技术矫正特发性脊柱侧凸。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: Loss of thoracic kyphosis has been associated with thoracic idiopathic scoliosis. Modern 3-dimensional (3D) imaging systems allow more accurate characterization of the scoliotic deformity than traditional radiographs. In this study, we utilized 3D calculations to characterize the association between increasing scoliosis severity and changes in the sagittal and axial planes. METHODS: Patients evaluated in a scoliosis clinic and determined to have either a normal spine or idiopathic scoliosis were included in the analysis. All underwent upright, biplanar radiography with 3D reconstructions. Two-dimensional (2D) measurements of the magnitude of the thoracic major curve and the thoracic kyphosis were recorded. Image processing and MATLAB analysis were utilized to produce a 3D calculation of thoracic kyphosis and apical vertebral axial rotation. Regression analysis was performed to determine the correlation of 2D kyphosis, 3D kyphosis, and apical axial rotation with the magnitude of the thoracic major curve. RESULTS: The 442 patients for whom 2D and 3D data were collected had a main thoracic curve magnitude ranging from 1° to 118°. Linear regression analysis of the 2D and 3D T5-T12 kyphosis versus main thoracic curve magnitude yielded significant models (p < 0.05). The 2D model had a minimally negative slope (-0.07), a small R value (0.02), and a poor correlation coefficient (-0.14). In contrast, the 3D model had a strongly negative slope (-0.54), a high R value (0.56), and a strong correlation coefficient (-0.75). Curve magnitude also had a strong correlation with loss of 3D T1-T12 kyphosis and increasing apical axial rotation. CONCLUSIONS: Segmentally calculated 3D thoracic kyphosis had a strongly negative correlation with the magnitude of the main thoracic curve. With near uniformity, 3D thoracic kyphosis progressively decreased as scoliosis magnitude increased, at a rate of more than half the increase in the main thoracic curve magnitude. Analysis confirmed a surprisingly strong correlation between scoliosis severity and loss of 3D kyphosis that was absent in the 2D analysis. A similarly strong correlation between curve magnitude and apical axial rotation was evident. These findings lend further credence to the concept that scoliosis progresses in the coronal, sagittal, and axial planes simultaneously. CLINICAL RELEVANCE: The findings of this study suggest that 3D assessment is critical for adequate characterization of the multiplanar deformity of idiopathic scoliosis and deformity in the sagittal plane is linked to deformity in the coronal plane. Increasing severity of coronal plane curvature is associated with a progressive loss of thoracic kyphosis that should be anticipated so that the appropriate intraoperative techniques for correction of idiopathic scoliosis can be applied in all 3 planes.
引用
- Sullivan TB, Reighard FG, Osborn EJ, et al. Thoracic Idiopathic Scoliosis Severity Is Highly Correlated with 3D Measures of Thoracic Kyphosis. J Bone Joint Surg Am. 2017. PMID: 28590384. doi:10.2106/JBJS.16.01324
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。