基于患者曲线的撑开方案以避免生长棒失效
该有限元研究基于青少年特发性脊柱侧凸模型(单胸椎中段弯曲、顶点位于第八胸椎),分析重力下Cobb角矫正百分比与限制生长棒最大von Mises应力至255 MPa所需的撑开间隔之间的关系。结果显示脊柱刚度增加时所需撑开间隔缩短,且随时间(自动融合)间隔进一步缩短,提示最佳撑开频率是时间依赖性变量。
要点
- 脊柱轴向刚度增加时,限制生长棒最大von Mises应力至255 MPa所需的撑开间隔缩短。
- 脊柱随时间变硬(自动融合)时,每个模型所需的适宜撑开间隔均缩短。
- 最佳撑开频率是时间依赖性变量,须达到以维持最大von Mises应力在指定安全系数下。
核心结论
- 本研究表明可将有限元建模的基础信息转化至临床领域,以减轻生长棒骨折的发生,即建立最佳撑开间隔与曲线柔韧性(通过重力下曲线矫正确定)之间的关系。
研究设计与样本
- 有限元研究,通过改变椎间盘材料属性以改变脊柱侧凸模型的轴向刚度进行参数分析;模型为青少年脊柱侧凸模型(单胸椎中段弯曲、顶点位于第八胸椎)。
主要发现
- 生长棒上的应力随脊柱轴向刚度增加而增加,导致达到生长棒安全系数2所需的optimal频率增加。
- 建立了重力单独作用下Cobb角矫正百分比与限制生长棒最大von Mises应力至255 MPa所需撑开间隔之间的关系。
- 限制应力至所选名义值所需的撑开间隔随脊柱刚度增加而缩短。
- 每个模型随着脊柱随时间变硬(自动融合),适宜的撑开间隔缩短。
关键数值与推荐
- 限制生长棒最大von Mises应力至255 MPa所需的撑开间隔与重力下Cobb角矫正百分比相关。
- 达到生长棒安全系数2所需的optimal频率随脊柱轴向刚度增加而增加。
临床怎么用
- 原文未据此给出推荐。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
STUDY DESIGN: A finite element study to establish the relationship between patient's curve flexibility (determined using curve correction under gravity) in juvenile idiopathic scoliosis and the required distraction frequency to avoid growth rod fracture, as a function of time. OBJECTIVE: To perform a parametric analysis using a juvenile scoliotic spine model (single mid-thoracic curve with the apex at the eighth thoracic vertebra) and establish the relationship between curve flexibility (determined using curve correction under gravity) and the distraction interval that allows a higher factor of safety for the growth rods. SUMMARY OF BACKGROUND DATA: Previous studies have shown that frequent distraction with smaller magnitude of distractions are less likely to result in rod failure. However there has not been any methodology or a chart provided to apply this knowledge on to the individual patients that undergo the treatment. This study aims to fill in that gap. METHOD: The parametric study was performed by varying the material properties of the disc, hence altering the axial stiffness of the scoliotic spine model. The stresses on the rod were found to increase with increased axial stiffness of the spine, and this resulted in the increase of required optimal frequency to achieve a factor of safety of two for growth rods. RESULTS: A relationship between the percentage correction in Cobb's angle due to gravity alone, and the required distraction interval for limiting the maximum von Mises stress to 255 MPa on the growth rods was established. The distraction interval required to limit the stresses to the selected nominal value reduces with increase in stiffness of the spine. Furthermore, the appropriate distraction interval reduces for each model as the spine becomes stiffer with time (autofusion). This points to the fact the optimal distraction frequency is a time-dependent variable that must be achieved to keep the maximum von Mises stress under the specified factor of safety. CONCLUSION: The current study demonstrates the possibility of translating fundamental information from finite element modeling to the clinical arena, for mitigating the occurrence of growth rod fracture, that is, establishing a relationship between optimal distraction interval and curve flexibility (determined using curve correction under gravity). LEVEL OF EVIDENCE: N/A.
引用
- Agarwal A, Jayaswal A, Goel VK, et al. Patient-specific Distraction Regimen to Avoid Growth-rod Failure. Spine (Phila Pa 1976). 2018. PMID: 28614278. doi:10.1097/BRS.0000000000002286
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。