文献速递脊柱外科骨质疏松与代谢性骨病

椎体骨小梁微结构与力学特性的相关性分析:7特斯拉超高场MRI与生物力学联合研究

Correlative Analysis of Vertebral Trabecular Bone Microarchitecture and Mechanical Properties: A Combined Ultra-high Field (7 Tesla) MRI and Biomechanical Investigation.
PubMed 文献 · Spine (Phila Pa 1976) · 2017-01-01

本研究对8具尸体共24个椎体(L2、L3、L4)行双能X线吸收测定法(DXA)测骨密度、7特斯拉超高场MRI定量骨小梁微结构参数(骨体积分数BVF、骨小梁厚度Tb.Th、骨小梁间距Tb.Sp),并作压缩试验至失败。结果显示微结构参数与失效载荷/应力及骨密度相关,BVF联合骨密度对失效应力的预测优于骨密度单独。

要点

  • 骨微结构参数两位操作者间信度良好,组内相关系数为0.82至0.94。
  • 失效载荷与失效应力均与BVF、Tb.Sp及骨密度显著相关(P<0.05)。
  • BVF联合骨密度预测失效应力的校正R由骨密度单独的0.384提高至0.414。

核心结论

  • 作者首次证明,用超高场MRI评估的椎体骨微结构与生物力学参数显著相关。
  • 作者认为,用超高场MRI对骨密度与骨小梁微结构进行多模态评估,可提供椎体骨折风险的额外信息,并可能对未来特定骨质疏松患者的检查有意义。

研究设计与样本

  • 研究设计为离体椎体的高分辨率影像学与生物力学研究。
  • 对8具尸体的24个椎体(L2、L3、L4)用DXA测骨密度,用7特斯拉超高场MRI定量BVF、Tb.Th、Tb.Sp,由两位操作者测量以评估信度。
  • 全部标本行机械压缩试验至失败并计算相应失效应力。

主要发现

  • 骨微结构参数的组内相关系数为0.82至0.94。
  • 失效载荷和失效应力与BVF、Tb.Sp及骨密度显著相关(P<0.05)。
  • Tb.Th仅与失效应力相关(P<0.05)。
  • 多元回归分析显示,BVF与骨密度联合使失效应力预测的校正R由骨密度单独的0.384提高至0.414。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

STUDY DESIGN: High-resolution imaging and biomechanical investigation of ex-vivo vertebrae. OBJECTIVE: The aim of this study was to assess bone microarchitecture of cadaveric vertebrae using ultra-high field (UHF) 7 Tesla magnetic resonance imaging (MRI) and to determine whether the corresponding microarchitecture parameters were related to bone mineral density (BMD) and bone strength assessed by dual-energy x-ray absorptiometry (DXA) and mechanical compression tests. SUMMARY OF BACKGROUND DATA: Limitations of DXA for the assessment of bone fragility and osteoporosis have been recognized and criteria of microarchitecture alteration have been included in the definition of osteoporosis. Although vertebral fracture is the most common osteoporotic fracture, no study has assessed directly vertebral trabecular bone microarchitecture. METHODS: BMD of 24 vertebrae (L2, L3, L4) from eight cadavers was investigated using DXA. The bone volume fraction (BVF), trabecular thickness (Tb.Th), and trabecular spacing (Tb.Sp) of each vertebra were quantified using UHF MRI. Measurements were performed by two operators to characterize the inter-rater reliability. The whole set of specimens underwent mechanical compression tests to failure and the corresponding failure stress was calculated. RESULTS: The inter-rater reliability for bone microarchitecture parameters was good with intraclass correlation coefficients ranging from 0.82 to 0.94. Failure load and stress were significantly correlated with BVF, Tb.Sp, and BMD (P < 0.05). Tb.Th was only correlated with the failure stress (P < 0.05). Multiple regression analysis demonstrated that the combination of BVF and BMD improved the prediction of the failure stress from an adjusted R = 0.384 for BMD alone to an adjusted R = 0.414. CONCLUSION: We demonstrated for the first time that the vertebral bone microarchitecture assessed with UHF MRI was significantly correlated with biomechanical parameters. Our data suggest that the multimodal assessment of BMD and trabecular bone microarchitecture with UHF MRI provides additional information on the risk of vertebral bone fracture and might be of interest for the future investigation of selected osteoporotic patients. LEVEL OF EVIDENCE: N /A.

来源:Spine (Phila Pa 1976),查看原文。版权归原作者所有。

引用

  1. Guenoun D, Fouré A, Pithioux M, et al. Correlative Analysis of Vertebral Trabecular Bone Microarchitecture and Mechanical Properties: A Combined Ultra-high Field (7 Tesla) MRI and Biomechanical Investigation. Spine (Phila Pa 1976). 2017. PMID: 28338579. doi:10.1097/BRS.0000000000002163

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。