文献速递关节外科

机械与限制性运动学对线对全膝关节置换术膝关节解剖的影响

The Impact of Mechanical and Restricted Kinematic Alignment on Knee Anatomy in Total Knee Arthroplasty.
PubMed 文献 · J Arthroplasty · 2017-02-20

研究分析4884例拟行全膝关节置换术患者的膝关节CT,测量股骨远端外侧角、胫骨近端内侧角和髋-膝-踝角。采用限制性运动学对线方案时,51%的膝关节无需调整即可运动学对线,83%的病例仅需平均0.5°和0.3°校正,显著小于机械对线所需的3.3°和3.2°(P < .001)。

要点

  • 拟行全膝关节置换术患者膝关节解剖变异范围大
  • 机械对线导致膝关节解剖改变大于限制性运动学对线
  • 限制性运动学对线是机械对线与纯运动学对线间的混合选择

核心结论

  • 拟行全膝关节置换术患者的膝关节解剖范围宽泛。
  • 机械对线导致膝关节解剖改变更大。
  • 为避免重现极端解剖,所提出的限制性运动学对线方案提供了机械对线与纯运动学对线之间的一种混合选择。

研究设计与样本

  • 研究分析了来自患者特异性器械全膝关节置换术数据库的4884例膝关节计算机断层扫描。
  • 测量股骨远端外侧角、胫骨近端内侧角和髋-膝-踝角。
  • 比较标准机械对线与限制性运动学对线的骨切除量,限制性运动学对线目标为胫骨和股骨独立截骨最大偏离冠状机械轴±5°,且整体冠状髋-膝-踝角在中性±3°以内。

主要发现

  • 术前平均胫骨近端内侧角为2.9°内翻,股骨远端外侧角为2.7°外翻,整体髋-膝-踝角为0.1°内翻。
  • 采用本方案,2475例膝关节(51%)无需调整即可行运动学对线。
  • 为纳入4062例(83%),胫骨近端内侧角平均需校正0.5°、股骨远端外侧角平均需校正0.3°,显著小于机械对线的胫骨近端内侧角3.3°和股骨远端外侧角3.2°(P < .001)。

关键数值与推荐

  • 限制性运动学对线目标为胫骨和股骨独立截骨最大偏离冠状机械轴±5°,整体冠状髋-膝-踝角在中性±3°以内。
  • 采用限制性运动学对线方案,51%(2475例)的膝关节无需调整即可行运动学对线。
  • 为纳入83%(4062例)的病例,胫骨近端内侧角平均校正0.5°、股骨远端外侧角平均校正0.3°,显著小于机械对线的胫骨近端内侧角3.3°和股骨远端外侧角3.2°(P < .001)。

临床怎么用

  • 原文未据此给出推荐。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Total knee arthroplasty (TKA), aiming at neutral mechanical alignment (MA), inevitably modifies the patient's native knee anatomy. Another option is kinematic alignment (KA), which aims to restore the original anatomy of the knee. The aim of this study was to evaluate the variations in lower limb anatomy of a patient population scheduled for TKA, and to assess the use of a restricted KA TKA protocol and compare the resulting anatomic modifications with the standard MA technique. METHODS: A total of 4884 knee computed tomography scans were analyzed from a database of patients undergoing TKA with patient-specific instrumentation. The lateral distal femoral angle (LDFA), medial proximal tibial angle (MPTA), and hip-knee-ankle angle (HKA) were measured. Bone resections were compared using a standard MA and a restricted KA aiming for independent tibial and femoral cuts of maximum ±5° deviation from the coronal mechanical axis and a resulting overall coronal HKA within ±3° of neutral. RESULTS: The mean preoperative MPTA was 2.9° varus, LDFA was 2.7° valgus, and overall HKA was 0.1° varus. Using our protocol, 2475 knees (51%) could have undergone KA without adjustment. To include 4062 cases (83%), mean corrections of 0.5° for MPTA and 0.3° for LDFA were needed, significantly less than with MA (3.3° for MPTA and 3.2° for LDFA; P < .001). CONCLUSION: The range of knee anatomy in patients scheduled for TKA is wide. MA leads to greater modifications of knee joint anatomy. To avoid reproducing extreme anatomy, the proposed restricted KA protocol provides an interesting hybrid option between MA and true KA.

来源:J Arthroplasty,查看原文。版权归原作者所有。

引用

  1. Almaawi AM, Hutt JRB, Masse V, et al. The Impact of Mechanical and Restricted Kinematic Alignment on Knee Anatomy in Total Knee Arthroplasty. J Arthroplasty. 2017. PMID: 28302462. doi:10.1016/j.arth.2017.02.028

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。