文献速递关节外科

患者身高与髋部内侧偏移是全膝关节置换术中膝外翻截骨角的主要决定因素

Patient's Height and Hip Medial Offset Are the Main Determinants of the Valgus Cut Angle During Total Knee Arthroplasty.
PubMed 文献 · J Arthroplasty · 2017-01-20

该研究基于202例患者共358条肢体的站立位三关节X线片,测量颈干角、内侧偏移、股骨长度、远端股骨关节角及膝外翻截骨角(VCA),评估VCA与其他因素的相关性。线性回归、t检验及多因素分析显示,平均VCA为5.76°(范围4-8°),性别与远端股骨关节角与VCA无关(P=.343和.995),仅身高(或股骨长度)与股骨偏移为独立影响因素,前者呈负相关(P<.001),后者呈正相关(P<.001)。结论认为股骨偏移与身高是决定VCA的两个独立因素,VCA值变异较大不支持对所有患者使用通用值。

要点

  • 平均膝外翻截骨角(VCA)为5.76°(范围4-8°)。
  • 性别与远端股骨关节角与VCA无关(P=.343和.995)。
  • 身高(或股骨长度)与股骨偏移是VCA的两个独立影响因素。

核心结论

  • 股骨偏移与身高是决定膝外翻截骨角(VCA)的两个独立因素,其他参数与这两个因素间接相关。
  • 高个子且股骨偏移小的患者VCA较小,矮个子且股骨偏移大的患者VCA较大。
  • VCA值变异较大,不支持在全膝关节置换术中对所有患者使用通用值。

研究设计与样本

  • 研究采用标准站立位三关节X线片,测量202例患者(116名女性,86名男性)共358条肢体的解剖参数。
  • 测量指标包括颈干角、内侧偏移、股骨长度、远端股骨关节角及膝外翻截骨角(VCA),人口学数据(性别、身高)取自医院病历。
  • 采用线性回归、t检验及多因素分析评估VCA与其他因素的相关性。

主要发现

  • 平均VCA为5.76°(范围4-8°)。
  • 性别与VCA无关(P=.343),远端股骨关节角与VCA无关(P=.995)。
  • 股骨长度是身高的函数,多因素分析中两者效应相似。
  • 身高(或股骨长度)与VCA呈负相关(P<.001),股骨偏移与VCA呈正相关(P<.001),两者为独立影响因素。

临床怎么用

  • 原文未据此给出推荐。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Valgus cut angle (VCA), defined as the angle between the anatomical and the mechanical axes of femur, is an important parameter upon which a critical step of knee arthroplasty is based. Some variables have been proposed to affect the magnitude of this cut. However, little information is available regarding whether a generic value can be used, or if a patient-specific value from a long leg X-ray, or factors that can be determined preoperatively, is necessary to accurately set the VCA. METHODS: Standard standing 3-joint views were used to measure a number of anatomical measurements in 358 limbs, 202 patients (116 women, 86 men). Neck-shaft angle, medial offset, femoral length (FL), distal femoral articular angle, and VCA were measured. Demographic data including gender and height were extracted from hospital charts. The correlation of VCA with each of the other factors was evaluated using linear regression and t-test and finally multivariate analysis. RESULTS: The average VCA was 5.76° (range 4-8). Gender and distal femoral articular angle were not related to VCA (P = .343 and .995). FL was found to be a function of height with similar effects on multivariate analysis. Only the height (or FL) and femoral offset were identified as independent factors, with a negative correlation for the former (P < .001) and a positive correlation for the latter (P < .001). CONCLUSION: Femoral offset and height are the 2 independent factors determining VCA. Other parameters are indirectly related to these 2 factors. Tall patients with a small femoral offset have smaller VCA and short patients with a large offset have larger VCA. The wide variety of VCA values does not support using a generic value for all patients during knee arthroplasty.

来源:J Arthroplasty,查看原文。版权归原作者所有。

引用

  1. Drexler M, Abolghasemian M, Barbuto R, et al. Patient's Height and Hip Medial Offset Are the Main Determinants of the Valgus Cut Angle During Total Knee Arthroplasty. J Arthroplasty. 2017. PMID: 28233603. doi:10.1016/j.arth.2016.12.021

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。