文献速递运动医学创伤骨科

驼背肩胛姿势增加后三角肌需求及肩峰-肩胛冈应变:一项尸体研究

Kyphotic Scapular Posture Increases Posterior Deltoid Demand and Acromial-Spine Strain During Shoulder Motion: A Cadaver Study.
PubMed 文献 · Clin Orthop Relat Res · 2026-07-07

该尸体研究使用动态肩关节模拟器测试6具肩关节,比较A型直立与C型驼背肩胛姿势下三角肌和肩袖肌力及肩峰-肩胛冈骨应变。结果发现C型姿势使三角肌募集后移,后三角肌力增加、前三角肌力降低,并在前屈和负重旋转时增加肩胛冈应变。结论提示驼背姿势导致姿势依赖性力学低效,而非关节受限。

要点

  • C型驼背姿势使后三角肌力增加、前三角肌力降低,三角肌募集后移。
  • C型姿势在前屈和负重轴向旋转时增加肩胛冈应变,肩胛平面抬高时无差异。
  • 术前CT姿势分类可帮助预判三角肌需求后移和肩峰应变升高。

核心结论

  • C型驼背肩胛姿势增加后三角肌需求和肩峰-肩胛冈应变,同时降低前三角肌贡献,提示姿势依赖性力学低效而非关节受限是肩功能下降的潜在驱动因素。

研究设计与样本

  • 研究为尸体生物力学研究,使用6具新鲜冷冻肩关节(平均年龄53±10岁;5男1女)和验证过的动态肩关节模拟器,独立驱动8组肌肉并测量肩峰及肩胛冈骨应变。

主要发现

  • C型姿势在所有测试动作中使三角肌募集后移,后三角肌力更大而前三角肌力更低;肩胛平面抬高终末前三角肌力A型96.8±14.5 N vs C型60.5±19.3 N,平均差-36.4(95%CI -53.7至-19.1),p=0.003。
  • 肩胛平面抬高中间后三角肌力A型25.6±10.8 N vs C型60.6±12.2 N,平均差35.0(95%CI 22.4至47.7),p<0.001。
  • 肩袖反应随动作变化,冈上肌和冈下肌力因任务和弧度而异。
  • C型姿势在前屈和负重轴向旋转时增加肩胛冈应变,前屈时zone 3B增幅最大:A型261±248 µε vs C型653±249 µε,平均差392(95%CI 42.2至741.5),p=0.04,代表临床骨折风险最高区域增加150%。
  • 肩胛平面抬高时两种姿势间应变无差异。

临床怎么用

  • 术前CT姿势分类可帮助外科医生预判C型排列相关的三角肌需求后移和肩峰应变升高,从而调整植入物位置以考虑前三角肌机械优势降低。
  • 康复专家应优先加强前三角肌力量,以减少C型驼背肩胛排列患者的疲劳和肩峰过载风险。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Scapulothoracic posture is known to influence shoulder mechanics, with kyphotic (type C) alignment associated with altered scapular orientation and muscle balance. However, the biomechanical consequences of scapular posture on individual muscle loading and bone strain remain poorly defined, limiting the ability to tailor surgical planning and rehabilitation to a patient's baseline alignment. QUESTIONS/PURPOSES: (1) Does a type C posture alter deltoid recruitment and rotator cuff loading patterns compared with a type A upright posture across dynamic shoulder motions? (2) Does type C posture alter acromial and scapular spine strain compared with type A alignment? METHODS: Six fresh-frozen cadaveric shoulders (mean ± SD age 53 ± 10 years; 5 males, 1 female) were tested using a validated dynamic shoulder simulator capable of independently actuating eight muscle groups (supraspinatus, infraspinatus, teres minor, upper and lower subscapularis, and anterior, middle, and posterior deltoid) and measuring acromial and scapular spine bone strain across Levy zones 1, 2, and 3 (subdivided into 3A and 3B). Each specimen was positioned in either a type A upright (scapulothoracic upward rotation 5°, anterior tilt 13°, internal rotation 30°) or kyphotic type C scapular alignment (upward rotation 6.4°, anterior tilt 23.5°, internal rotation 49.2°) via a 6-DOF Stewart platform. Humerothoracic kinematics were imposed across postures during forward flexion, scapular plane elevation, and weighted (1 kg) internal and external rotation. Continuous muscle forces and acromial-spine strains (Levy zones 1 to 3B) were recorded. Repeated-measures ANOVA was used to evaluate group differences using joint angle (1° increments) as the within-subject factor, with only significant (p < 0.05) spans of ≥ 5° reported because smaller differences (even if detectable in this model) probably would be too small to be perceived clinically. RESULTS: Type C posture shifted deltoid recruitment posteriorly across all tested motions, with posterior deltoid force greater and anterior deltoid force lower; the largest differences during scapular plane elevation were at terminal elevation for the anterior deltoid (type A 96.8 ± 14.5 N versus type C 60.5 ± 19.3 N, mean difference -36.4 [95% confidence interval (CI) -53.7 to -19.1]; p = 0.003) and at mid-elevation for the posterior deltoid (type A 25.6 ± 10.8 N versus type C 60.6 ± 12.2 N, mean difference 35.0 [95% CI 22.4 to 47.7]; p < 0.001). Rotator cuff responses were motion dependent, with supraspinatus and infraspinatus forces varying by task and arc. Type C posture increased scapular spine strain during forward flexion and weighted axial rotation, with the largest increase in zone 3B during forward flexion (type A 261 ± 248 µε versus type C 653 ± 249 µε, mean difference 392 [95% CI 42.2 to 741.5]; p = 0.04), representing a 150% increase in the region of highest clinical fracture risk. Strain did not differ between postures during scapular plane elevation. CONCLUSION: A type C posture increases posterior deltoid demand and acromial-spine strain while reducing anterior deltoid contribution. These findings suggest posture-dependent mechanical inefficiency rather than joint restriction as a potential driver of reduced shoulder performance in individuals with kyphosis. Preoperative CT-based posture classification may help surgeons anticipate the posterior shift in deltoid demand and elevated acromial strain associated with type C alignment, informing implant positioning decisions to account for the reduced anterior deltoid mechanical advantage in this group. CLINICAL RELEVANCE: Patients with type C kyphotic scapular alignment experience greater posterior deltoid demand and elevated acromial spine strain during routine shoulder movements compared with those with type A upright alignment. Incorporating scapular posture assessment into preoperative planning may help surgeons identify patients with reduced anterior deltoid mechanical advantage and adjust implant positioning accordingly, while guiding rehabilitation specialists to prioritize anterior deltoid strengthening to reduce fatigue and acromial overload risk in this group.

来源:Clin Orthop Relat Res,查看原文。版权归原作者所有。

引用

  1. Haddara M, Sun K, Hasler J, et al. Kyphotic Scapular Posture Increases Posterior Deltoid Demand and Acromial-Spine Strain During Shoulder Motion: A Cadaver Study. Clin Orthop Relat Res. 2026. PMID: 42413941. doi:10.1097/CORR.0000000000004053

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。