改良MacIntosh前交叉韧带重建术后胫股接触应力与移植物负荷的体外评价
采用8具尸体膝关节在机器人平台上模拟枢轴移位,比较完整、前交叉韧带切断与改良MacIntosh重建三种状态。重建后外侧间室峰值接触应力较完整膝增加0.31至0.35 MPa且接触应力中心前移1.3至3.3 mm,同时内旋与内翻松弛度下降,关节内移植物承受的力小于原生前交叉韧带。
要点
- 重建后外侧间室峰值应力较完整膝增加0.31至0.35 MPa,接触应力中心前移1.3至3.3 mm。
- 重建使内旋松弛度下降18%至24%、内翻松弛度下降13%至24%。
- 模拟枢轴移位时关节内移植物力27至36 N,比原生前交叉韧带小51%至65%。
核心结论
- 在模拟枢轴移位的尸体模型中,改良MacIntosh前交叉韧带重建较原生膝使外侧间室接触应力前移并轻度增加,但较前交叉韧带缺损膝降低该区应力。
- 关节外束增加对旋转负荷的约束,部分卸载关节内移植物,为改良MacIntosh重建后移植物失败率低提供生物力学依据。
研究设计与样本
- 控制性实验室研究,8具尸体膝关节,平均年龄56±7岁,50%为男性。
- 在机器人操纵器上测试完整、前交叉韧带切断和改良MacIntosh重建三种状态,模拟枢轴移位并评估0°至90°屈膝下三种单平面加载的松弛度。
主要发现
- 重建后峰值应力较完整膝增加0.31至0.35 MPa(P < .03),接触应力中心前移1.3至3.3 mm(P < .05)。
- 与完整状态相比,重建使内旋松弛度下降18%至24%(P≤ .01)、内翻松弛度下降13%至24%(P < .02)。
- 模拟枢轴移位时关节内移植物原位力为27至36 N,比原生前交叉韧带力小51%至65%,关节外组件承担25至30 N。
临床怎么用
- 改良MacIntosh重建可在模拟枢轴移位时卸载关节内移植物并降低外侧间室后部接触应力,但长期是否影响软骨健康需长期临床研究确定。
局限性
- 原文为尸体体外模型,样本量8具,临床相关性需长期临床研究验证。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: The modified MacIntosh anterior cruciate ligament reconstruction (ACLR) consists of a combined intra- and extra-articular construct using iliotibial band autograft. It is used in skeletally immature patients to avoid physeal injury. However, its effect on articular cartilage contact mechanics, rotational laxity, and graft loading is poorly understood. HYPOTHESIS: Relative to the intact knee, a modified MacIntosh ACLR would (1) increase and anteriorize lateral tibiofemoral contact stress, (2) decrease internal rotation (IR) and varus laxity, and (3) offload the intra-articular graft relative to the native ACL in response to simulated pivot-shift loads. STUDY DESIGN: Controlled laboratory study. METHODS: Eight cadaveric knees (mean age 56 ± 7 years; 50% male) were tested on a robotic manipulator in 3 states: intact, ACL-sectioned, and modified MacIntosh ACLR. Peak contact stress and the anterior-posterior position of the center of contact stress (CCS) in the lateral compartment were calculated during simulated pivot shifts. Laxity was assessed for 3 uniplanar loading conditions (134 N anterior, 8 N·m varus, and 5 N·m IR) at knee flexion angles from 0° to 90°. Tissue forces were determined via the principle of superposition. RESULTS: After modified MacIntosh ACLR, peak stress increased by 0.31 to 0.35 MPa (P < .03) and the CCS shifted anteriorly by 1.3 to 3.3 mm (P < .05) relative to the intact knee. ACLR decreased IR and varus laxity by 18% to 24% (P≤ .01) and 13% to 24% (P < .02), respectively, compared with the intact state. During simulated pivot shift, in situ force in the intra-articular graft component (27 to 36 N) was 51% to 65% less than native ACL force, whereas the extra-articular component carried 25 to 30 N. CONCLUSION: In a cadaveric model of a simulated pivot shift, a modified MacIntosh ACLR anteriorized and mildly increased lateral compartment contact stress compared to the native knee, while decreasing lateral compartment contact stress relative to the ACL-deficient knee. The extraarticular limb also increased constraint to rotational loads, partially offloading the intra-articular graft. CLINICAL RELEVANCE: Partial intraarticular graft offloading with clinical pivoting maneuvers provides a biomechanical rationale for the low number of graft failures after modified MacIntosh ACLR. The ability of a modified MacIntosh ACLR to decrease and anteriorize contact stress in the posterior aspect of the lateral compartment offloads the region most affected by ACL injury and the pivot shift contact. Long-term clinical studies are needed to determine whether altered contact mechanics after modified MacIntosh ACLR influence long-term cartilage health.
引用
- Bram JT, Shamritsky DZ, Mange TR, et al. In Vitro Evaluation of Tibiofemoral Contact Stress and Graft Loading After Modified MacIntosh Anterior Cruciate Ligament Reconstruction. Am J Sports Med. 2026. PMID: 42246498. doi:10.1177/03635465261449796
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。