文献速递运动医学创伤骨科

倾斜骨块恢复肩胛盂凹面:生物力学上优于平坦骨块并恢复盂肱关节力

Restoring Glenoid Concavity: Angled Bone Blocks Provide Biomechanically Superior Function and Restore Glenohumeral Forces Over Flat Constructs in Glenoid Augmentation.
PubMed 文献 · Am J Sports Med · 2026-04-04

本研究在9例尸体肩关节上制作20%前侧骨缺损,比较平坦与30°倾斜胫骨远端异体骨块重建后的生物力学。倾斜骨块组峰值分离力达完整肩的98.5%,接触力与完整肩无显著差异,且移植物接触率100%高于平坦组的70%。结论认为倾斜骨块更好地恢复肩胛盂凹面与生物力学。

要点

  • 倾斜骨块组峰值分离力为完整肩的98.5%,平坦组为89.6%。
  • 倾斜骨块组肱骨头与移植物接触率100%,平坦组为70%。
  • 倾斜骨块组接触力与完整肩无显著差异,平坦组有显著差异。

核心结论

  • 倾斜骨块比平坦骨块更好地恢复原生肩胛盂凹面,在骨缺损后重建稳定性和肱骨头中心化方面生物力学更优。

研究设计与样本

  • 控制性实验室研究,使用9例尸体肩关节,制作20%前侧骨缺损,比较完整、缺损、平坦骨块和30°倾斜骨块四种条件。

主要发现

  • 平均峰值分离力:完整48.28±8.06 N,缺损33.99±10.54 N(完整的70.4%),平坦41.83±9.07 N(89.6%),倾斜45.64±9.03 N(98.5%)。
  • 肱骨头与移植物接触率:倾斜组100.0%,平坦组70.0%。
  • 平均盂肱接触力:完整71.81±16.42 N,缺损31.39±16.60 N,平坦46.91±4.12 N,倾斜62.17±9.26 N。
  • 单因素方差分析显示构造类型对接触力和分离力均有显著影响(P < .001)。
  • 两两比较显示分离力在完整与缺损、缺损与倾斜骨块间有显著差异;接触力在完整与缺损、完整与平坦、缺损与平坦、缺损与倾斜、平坦与倾斜间有显著差异;完整肩与倾斜骨块间无显著差异。

临床怎么用

  • 在肩胛盂骨缺损的骨块增强术中,采用倾斜骨块(30°)可能比平坦骨块更好地恢复凹面和生物力学稳定性。

局限性

  • 本研究为尸体实验室研究,样本量9例,结论需临床验证。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Surgical treatment of shoulder instability with glenoid bone loss using a distal tibial allograft has achieved success, with the bone graft placed parallel, flush, or recessed to the articular surface, but questions remain about optimal graft positioning. HYPOTHESIS: Given evidence that glenoid concavity and congruence influence stability, we hypothesized that angled bone blocks better restore native concavity and biomechanics compared to flat graft placement. STUDY DESIGN: Controlled laboratory study. METHODS: A total of 9 cadaveric shoulders were dissected, separating rotator cuff muscles from the capsule. Native glenoid dimensions were measured with a digitizer. A 20% anterior bone defect was created and then reconstructed with a distal tibial allograft (bone graft). There were 4 conditions tested: intact, defect, flat bone block, and angled bone block (30°). Using a testing machine, the humeral head was translated anteriorly 10 mm, and distraction and contact forces were recorded. RESULTS: Mean peak distraction forces were as follows: 48.28 ± 8.06 N (intact), 33.99 ± 10.54 N (defect; 70.4% of intact), 41.83 ± 9.07 N (flat; 89.6% of intact), and 45.64 ± 9.03 N (angled; 98.5% of intact). Humeral head contact with the graft occurred in 100.0% of angled trials versus 70.0% of flat trials. Mean glenohumeral contact forces were as follows: 71.81 ± 16.42 N (intact), 31.39 ± 16.60 N (defect), 46.91 ± 4.12 N (flat), and 62.17 ± 9.26 N (angled). One-way analysis of variance showed a significant effect of construct type on both contact and distraction forces (P < .001). Pairwise comparisons showed significant differences in distraction forces between intact and defect conditions and between defect and angled bone block conditions. Comparisons also demonstrated significant differences in contact forces between intact and defect, intact and flat bone block, defect and flat bone block, defect and angled bone block, and flat bone block and angled bone block conditions. No significant difference was observed between the intact shoulder and angled bone block repair. CONCLUSION: Angled bone blocks more closely restored native glenoid concavity and were biomechanically superior to flat bone blocks in re-establishing stability and centering the humeral head after glenoid bone loss. CLINICAL RELEVANCE: This study provides a quantitative comparison between different bony glenoid augmentation methods.

来源:Am J Sports Med,查看原文。版权归原作者所有。

引用

  1. Bauer J, Rajan R, Singh R, et al. Restoring Glenoid Concavity: Angled Bone Blocks Provide Biomechanically Superior Function and Restore Glenohumeral Forces Over Flat Constructs in Glenoid Augmentation. Am J Sports Med. 2026. PMID: 41934353. doi:10.1177/03635465261429466

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。