文献速递关节外科

关节线倾斜度影响全膝关节置换术后假体生存率:800例12.7年随访

Joint Line Obliquity Affects Survivorship Following Total Knee Arthroplasty: 12.7-Year Follow-Up of 800 Cases.
PubMed 文献 · J Arthroplasty · 2025-11-03

该回顾性队列研究纳入2004年1月至2010年12月因原发性膝骨关节炎行全膝关节置换术的800例患者,平均随访12.7年,评估关节线倾斜度对假体生存率的影响。按术后力线分为机械对齐组(机械轴0±3°)和偏离组(机械轴超出0±3°),并按原始分类和改良分类将关节线倾斜度分为四组。结果显示机械对齐组生存率98.6%高于偏离组92.6%(P<0.001),偏离组中关节线不平行尤其是外侧倾斜者生存率最低87.7%(P<0.001),术后关节线倾斜度是机械失败的独立危险因素(HR 1.58,P=0.042)。

要点

  • 机械对齐组假体生存率98.6%高于偏离组92.6%(P<0.001)。
  • 偏离组中关节线不平行尤其外侧倾斜者生存率最低87.7%(P<0.001)。
  • 术后关节线倾斜度是机械失败的独立危险因素(HR 1.58,P=0.042)。

核心结论

  • 应用改良关节线倾斜度分类时,术后关节线倾斜度与全膝关节置换术后平均随访12.7年的高生存率相关。
  • 力线偏离合并关节线不平行,尤其是外侧倾斜,显示最低的生存率。

研究设计与样本

  • 回顾性队列研究,证据等级III级。
  • 回顾2004年1月至2010年12月因原发性膝骨关节炎行全膝关节置换术的800例患者记录。
  • 根据术后力线分为机械对齐组(机械轴0±3°)和偏离组(机械轴超出0±3°)。
  • 根据全长站立负重X线片测量的关节线倾斜度,采用原始分类(股骨远端外侧角与胫骨近端内侧角之和)和改良分类(关节面角相对于髋-膝-踝轴)将患者分为四组。
  • 采用Kaplan-Meier生存分析估计假体生存率,以无菌性翻修机械失败为终点。

主要发现

  • 平均随访12.7年期间,800例中28例(3.5%)发生机械失败。
  • 原始关节线倾斜度分类与无菌性翻修无关,但改良分类在偏离组内显示显著差异。
  • 外侧关节线倾斜与最高失败率相关(5.2%[10/193];P=0.01)。
  • 机械对齐组假体生存率98.6%高于偏离组92.6%(P<0.001,log-rank检验)。
  • 偏离组内,关节线不平行尤其外侧倾斜者生存率最低(87.7%,P<0.001)。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: The purpose of this study was to evaluate the influence of joint line obliquity (JLO) on survivorship following total knee arthroplasty (TKA) over a mean follow-up of 12.7 years METHODS: We reviewed the records for 800 patients who had undergone TKA for primary knee osteoarthritis between January 2004 and December 2010. Based on postoperative alignment, patients were categorized into two groups: the mechanically aligned group (mechanical axis of 0 ± 3°) and the outlier group (mechanical axis beyond 0 ± 3°). In addition, patients were stratified into four groups according to joint line obliquity (JLO), as measured on full-length standing weight-bearing radiographs using both the original classification (sum of lateral distal femoral angle and medial proximal tibial angle) and a modified classification (joint surface angle relative to the hip-knee-ankle axis). Kaplan-Meier survival analysis was used to estimate implant survival, with aseptic revision for mechanical failure defined as the endpoint. RESULTS: Mechanical failure occurred in 3.5% of cases (28 of 800) over a mean follow-up of 12.7 years. Although the original JLO classification was not associated with aseptic revision, the modified classification revealed significant differences within the outlier group. Notably, lateral joint line inclination was associated with the highest failure rate (5.2% [10 of 193]; P = 0.01). Implant survival was significantly higher in the mechanically aligned group (98.6%) than in the outlier group (92.6%) (P < 0.001, log-rank test). Within the outlier group, the lowest survival rate (87.7%, P < 0.001) was found in knees with nonparallel JLO, particularly those with lateral inclination. Multivariate Cox regression analyses identified postoperative JLO (hazard ratio, 1.58; P = 0.042) as an independent risk factor for mechanical failure. CONCLUSION: When applying the modified JLO classification, postoperative JLO was associated with high survival rates following TKA at a mean follow-up of 12.7 years. Outlier alignment in combination with nonparallel JLO, particularly lateral inclination, demonstrated the poorest survival rate. LEVEL OF EVIDENCE: Retrospective cohort study; Level III.

来源:J Arthroplasty,查看原文。版权归原作者所有。

引用

  1. Yang HY, Song EK, Seo JH, et al. Joint Line Obliquity Affects Survivorship Following Total Knee Arthroplasty: 12.7-Year Follow-Up of 800 Cases. J Arthroplasty. 2025. PMID: 41192531. doi:10.1016/j.arth.2025.10.114

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。