新南威尔士州髋部骨折全髋关节置换术后脱位与翻修手术的累积发生率:一项数据关联研究
基于澳大利亚骨科协会国家关节置换登记处与新南威尔士州入院患者数据关联的观察性队列研究,纳入2010年7月1日至2018年12月31日因股骨颈骨折行全髋关节置换术的4632例患者。一年脱位发生率为4.8%(95%CI 4.2至5.5),其中79%发生在90天内;因脱位翻修率为1.1%(95%CI 0.80至1.4)。与双动髋臼组件相比,≤32 mm和>32 mm常规轴承脱位风险无显著差异;在2532例亚组中,前路入路较后路入路显著降低脱位风险(OR 0.28(95%CI 0.12至0.67);p=0.004),外侧入路无显著差异。
要点
- 因股骨颈骨折行全髋关节置换术的患者一年脱位发生率为4.8%,其中79%发生在术后90天内。
- 因脱位行翻修手术的比例为1.1%。
- 调整手术入路后,≤32 mm轴承较双动组件脱位风险更高(OR 1.97(95%CI 1.06至3.66);p=0.031)。
核心结论
- 因骨折行全髋关节置换术的患者中,每20例约有1例在一年内发生脱位,但多数无需翻修。
- 与较小直径股骨头相比,双动组件可能对脱位具有保护作用。
研究设计与样本
- 观察性队列研究,数据来自澳大利亚骨科协会国家关节置换登记处与新南威尔士州入院患者数据集的关联。
- 纳入2010年7月1日至2018年12月31日在新南威尔士州因股骨颈骨折行全髋关节置换术、年龄超过18岁的患者,共4632例。
- 采用多变量逻辑回归评估脱位的人口学、手术及植入物相关危险因素,亚组分析考虑手术入路和体重指数。
主要发现
- 4632例患者中,一年脱位发生率为4.8%(95%CI 4.2至5.5),其中79%发生在90天内。
- 因脱位行翻修手术的比例为1.1%(95%CI 0.80至1.4)。
- 与双动髋臼组件相比,≤32 mm常规轴承的脱位风险OR为1.64(95%CI 0.93至2.90;p=0.087),>32 mm常规轴承的OR为1.33(95%CI 0.75至2.37;p=0.332),均无显著差异。
- 在2532例亚组中,与后路入路相比,前路入路显著降低脱位风险(OR 0.28(95%CI 0.12至0.67);p=0.004),外侧入路无显著差异(OR 0.75(95%CI 0.48至1.17);p=0.202)。
- 调整手术入路后,≤32 mm轴承较双动组件脱位风险更高(OR 1.97(95%CI 1.06至3.66);p=0.031);>32 mm轴承无显著差异(OR 1.68(95%CI 0.89至3.15);p=0.110)。
临床怎么用
- 作者认为,与较小直径股骨头相比,双动组件可能对脱位具有保护作用。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
AIMS: Dislocation is a common problem after total hip arthroplasty (THA) for hip fracture. This study aimed to assess the one-year cumulative incidence of dislocation, and identify associated risk factors. METHODS: An observational cohort study was conducted using data from the Australian Orthopaedic Association National Joint Replacement Registry linked with the New South Wales Admitted Patient Data Collection. Patients aged over 18 years who underwent THA for fracture neck of femur between 1 July 2010 and 31 December 2018 in New South Wales were included. Dislocations and revision surgeries were identified via linked datasets. Multivariable logistic regression evaluated demographic, surgical, and implant-related risk factors for dislocation. Subgroup analysis considered surgical approach and BMI. RESULTS: Among 4,632 patients, the one-year dislocation incidence was 4.8% (95% CI 4.2 to 5.5), with 79% occurring within 90 days. Revision for dislocation occurred in 1.1% of cases (95% CI 0.80 to 1.4). Compared with dual-mobility acetabular components, conventional bearings ≤ 32 mm (odds ratio (OR) 1.64 (95% CI 0.93 to 2.90); p = 0.087) and > 32 mm (OR 1.33 (95% CI 0.75 to 2.37); p = 0.332) showed no significant difference in dislocation risk. In a subgroup of 2,532 patients, the anterior approach significantly reduced dislocation risk (OR 0.28 (95% CI 0.12 to 0.67); p = 0.004), whereas the lateral approach did not (OR 0.75 (95% CI 0.48 to 1.17); p = 0.202) compared to the posterior approach. Adjusting for surgical approach, ≤ 32 mm bearings were associated with a higher dislocation risk than dual-mobility components (OR 1.97 (95% CI 1.06 to 3.66); p = 0.031); > 32 mm bearings were not significantly different (OR 1.68 (95% CI 0.89 to 3.15); p = 0.110). CONCLUSION: One in 20 patients undergoing THA for fracture will experience dislocation within a year, though most will not require revision. Dual-mobility components may be protective against dislocation compared with smaller-diameter femoral head sizes.
引用
- Farey JE, Li A, Adie S, et al. The cumulative incidence of dislocation and revision surgery following total hip arthroplasty for hip fracture in New South Wales : a data linkage study. Bone Joint J. 2025. PMID: 41027612. doi:10.1302/0301-620X.107B10.BJJ-2024-1637.R1
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。