髋关节置换术后假体周围股骨骨折:哪种假体设计与固定方式再手术风险最低
基于挪威关节置换登记库和挪威髋部骨折登记库2005年1月1日至2023年12月31日的数据,纳入187,576例初次髋关节置换的股骨假体,采用Cox回归分析假体设计与固定方式对假体周围股骨骨折再手术风险的影响。结果显示,与骨水泥复合梁假体相比,骨水泥双锥度、三锥度及非骨水泥楔形无领、有领假体的再手术风险均显著升高;非骨水泥楔形无领假体风险高于有领设计。作者认为,为降低假体周围股骨骨折风险,骨水泥复合梁股骨假体应为首选;若无法骨水泥固定,非骨水泥楔形有领假体是最佳替代。
要点
- 骨水泥复合梁假体再手术风险最低,骨水泥双锥度aHRR 4.0、三锥度aHRR 4.0、非骨水泥楔形无领aHRR 7.3、有领aHRR 3.5。
- 非骨水泥楔形无领假体较有领假体再手术风险更高(aHRR 2.1)。
- 骨水泥三锥度与双锥度假体再手术风险相似(aHRR 1.0)。
核心结论
- 为降低假体周围股骨骨折风险,骨水泥复合梁股骨假体应为首选。
- 若无法骨水泥固定,非骨水泥楔形有领假体是最佳替代。
- 选择骨水泥三锥度设计相较双锥度设计并未改善结局。
研究设计与样本
- 分析挪威关节置换登记库和挪威髋部骨折登记库2005年1月1日至2023年12月31日报告的初次髋关节置换股骨假体数据。
- 纳入187,576例记录完整的半髋和全髋关节置换股骨假体,采用Cox回归评估。
- 假体分为五组:骨水泥复合梁(n=30,415)、骨水泥双锥度(n=52,255)、骨水泥三锥度(n=13,894)、非骨水泥楔形无领(n=38,389)、非骨水泥楔形有领(n=40,853)。
主要发现
- 共1,398例股骨假体(0.7%)报告因假体周围股骨骨折再手术。
- 与骨水泥复合梁假体相比,骨水泥双锥度aHRR 4.0(95%CI 3.1至5.2)、骨水泥三锥度aHRR 4.0(95%CI 2.9至5.6)、非骨水泥楔形无领aHRR 7.3(95%CI 5.6至9.5)、非骨水泥楔形有领aHRR 3.5(95%CI 2.6至4.6)再手术风险均显著更高。
- 骨水泥三锥度假体再手术风险与骨水泥双锥度假体相似(aHRR 1.0,95%CI 0.8至1.3)。
- 非骨水泥楔形无领假体较非骨水泥楔形有领假体假体周围股骨骨折风险更高(aHRR 2.1,95%CI 1.8至2.5)。
临床怎么用
- 作者认为,为降低假体周围股骨骨折风险,骨水泥复合梁股骨假体应为首选。
- 作者认为,若无法骨水泥固定,非骨水泥楔形有领假体是最佳替代。
- 作者认为,选择骨水泥三锥度设计相较双锥度设计并未改善结局。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
AIMS: Periprosthetic femoral fracture (PPFF) is a major complication following hip arthroplasty. This study examined the influence of femoral component design and fixation method on the risk of reoperation for PPFF. METHODS: We analyzed data on femoral component type use for primary hip arthroplasty stems reported to the Norwegian Arthroplasty Register and the Norwegian Hip Fracture Register from 1 January 2005 to 31 December 2023. The study included 187,576 well-documented femoral components used in hemi- and total hip arthroplasties which were assessed by Cox regression. The femoral components were categorized into five groups: 1) cemented composite beam (n = 30,415), and two types of cemented polished taper-slip components; 2) double-tapered (n = 52,255); 3) triple-tapered (n = 13,894), and two types of uncemented femoral components; 4) wedged collarless (n = 38,389); and 5) wedged collared (n = 40,853). Endpoint was reoperation for PPFF (revisions and osteosyntheses). RESULTS: A total of 1,398 femoral components (0.7%) were reported with a reoperation due to PPFF. The risk of reoperation was significantly higher for cemented double-tapered (adjusted hazard rate ratio (aHRR) 4.0 (95% CI 3.1 to 5.2), cemented triple-tapered (aHRR 4.0 (95% CI 2.9 to 5.6)), uncemented wedged collarless (aHRR 7.3 (95% CI 5.6 to 9.5)), and uncemented wedged collared (aHRR 3.5 (95% CI 2.6 to 4.6)) components compared to cemented composite beam components. Cemented triple-tapered prostheses exhibited a similar risk of reoperation (aHRR 1.0 (95% CI 0.8 to 1.3)) to cemented double-tapered components. Uncemented wedged collarless prostheses were associated with a higher risk of PPFF (aHRR 2.1 (95% CI 1.8 to 2.5)) compared to uncemented wedged collared designs. CONCLUSION: To minimize the risk of PPFF, cemented composite-beam femoral components should be the surgeon's preferred choice. If cementing is not an option, uncemented wedged collared components are the best alternative. Opting for a cemented triple-tapered design does not improve outcomes compared to double-tapered component.
引用
- Børsheim S, Kristensen TB, Hallan G, et al. Periprosthetic femoral fracture following hip arthroplasty : which component design and fixation method has the lowest risk of reoperation? Bone Joint J. 2025. PMID: 40887059. doi:10.1302/0301-620X.107B9.BJJ-2024-1706.R1
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。