全膝关节置换术对线方式对软组织平衡及旋转枢轴模式的影响:运动学对线与机械对线的随机对照试验
本研究将109例初次后交叉韧带保留型全膝关节置换术随机分为机械对线或限制性运动学对线组,使用衬垫压力传感器在屈膝10°、45°、90°量化间室压力和接触点模式。结果显示限制性运动学对线组在全活动度范围内实现平衡的比例显著更高(61% vs 12%,P<0.001),且不平衡时机械对线组需要更多软组织松解和骨对线调整;旋转枢轴模式两组无显著差异,主要驱动因素为45°和90°屈膝时内外侧间室压差。
要点
- 限制性运动学对线组在全活动度实现平衡的比例为61%,机械对线组为12%(P<0.001)。
- 不平衡假体中机械对线组需要更多软组织松解(P=0.008)和骨对线调整(P<0.001)。
- 旋转枢轴模式两组无显著差异,主要驱动因素为45°和90°屈膝时内外侧间室压差(均P<0.001)。
核心结论
- 在初次后交叉韧带保留型全膝关节置换术中,限制性运动学对线技术能以显著更少的软组织松解或骨再切实现假体平衡。
- 通过控制软组织平衡实现非对称屈曲间隙(伸直相等平衡、活动度中维持内侧韧带张力、屈膝时允许外侧软组织松弛增加),可复制膝关节自然的内侧旋转枢轴模式。
研究设计与样本
- 随机对照试验,共109例初次后交叉韧带保留型全膝关节置换术随机分配至机械对线或运动学对线技术。
- 使用衬垫压力传感器在屈膝10°、45°和90°量化内外侧间室压力和接触点模式。
- 试验及方案在澳大利亚新西兰临床试验注册中心注册(ACTRN12616001705471)。
主要发现
- 初始骨切除后,限制性运动学对线组在全活动度范围内实现平衡的比例为61%,机械对线组为12%(P<0.001),且活动度各位置差异均显著。
- 对于不平衡假体,机械对线组需要显著更多的软组织松解(P=0.008)和骨对线调整(P<0.001)。
- 初始和最终旋转后退枢轴模式在两种技术间无显著差异(初始P=0.29,最终P=0.29)。
- 旋转枢轴模式的主要驱动因素不是对线,而是屈膝45°和90°时内外侧间室压差(45° P<0.001,90° P<0.001),膝关节在屈膝时以较紧间室为枢轴旋转。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: Over the last decade alternative alignment techniques in primary total knee arthroplasty (TKA) have been developed in the hope to allow knee prostheses to better replicate normal knee kinematics and improve clinical outcomes. The purpose of this study was to quantify prosthesis soft-tissue balance and pivot patterns based on a restricted kinematic alignment (KA) or mechanical alignment (MA) surgical technique. METHODS: A total of 109 primary cruciate retaining TKAs were randomized to either a mechanical or KA technique. Medial and lateral compartmental pressures and contact point patterns were quantified at 10, 45, and 90 degrees of flexion using an insert pressure sensor. RESULTS: A significantly greater proportion of KA knees were balanced through a full range of motion (ROM) after the initial bone resections (61 KA versus 12% MA, P < 0.001) and the differences were significant at all positions of ROM. For the unbalanced prostheses, the MA knees required significantly more soft-tissue releases (P = 0.008) and bone alignment adjustments (P < 0.001). The initial and final rollback pivot patterns were not significantly different between techniques (initial P = 0.29, final P = 0.29). The primary driving factor for the pivot patterns was not alignment, but instead the differential pressure between the medial and lateral compartments at 45 and 90 degrees flexion (45° P < 0.001, 90° P < 0.001), with the knee pivoting on the tighter compartment in flexion. CONCLUSIONS: In primary cruciate retaining TKA a restricted KA technique achieves a balanced prosthesis with significantly fewer soft-tissue releases or bone recuts. The knee's natural medial pivot pattern can be replicated with a prosthesis by controlling the soft tissue balance to achieve a non-symmetrical flexion gap: equal balance in extension, with medial ligament tension maintained through ROM while allowing increased lateral soft-tissue laxity in flexion. The trial and protocol were registered with the Australian New Zealand Clinical Trials Registry (ACTRN12616001705471).
引用
- Barroso Rosa S, Ismailidis P, Doma K, et al. Influence of Total Knee Arthroplasty Alignment on Soft-Tissue Balance and Pivot Patterns: A Randomized Controlled Trial of Kinematic Versus Mechanical Alignment. J Arthroplasty. 2025. PMID: 40482934. doi:10.1016/j.arth.2025.05.128
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。