解剖型肩关节置换术中混合型肩胛盂假体的骨性整合:短期CT扫描分析
这项前瞻性多中心研究纳入100例初次解剖型全肩关节置换患者(104个肩),术后12至24个月CT评估混合型肩胛盂假体的骨性整合。下聚乙烯带法兰柱周围完美骨性整合见于67%的肩,上多孔涂层钛柱周围骨性整合见于67%的肩;短期临床结果满意,但需更长期随访评估假体生存率。
要点
- 上聚乙烯带法兰柱周围骨溶解见于32个肩(31%)。
- 下多孔涂层钛柱平均Gulotta评分6.5分,70个肩(67%)完美整合。
- 平均随访16个月无假体断裂,短期临床结果满意。
核心结论
- 短期CT分析显示新型混合型解剖肩胛盂假体下多孔涂层钛柱周围完美骨性整合见于90%的患者,上聚乙烯带法兰柱骨性整合见于70个肩(67%)。
- 需要更长期随访分析该假体的生存率,短期临床结果满意。
研究设计与样本
- 前瞻性多中心研究,纳入因初次解剖型全肩关节置换术使用混合型肩胛盂假体(上柱为全聚乙烯带法兰、下柱为多孔涂层钛)且在术后12至24个月接受CT扫描的患者。
- 初始组为116例患者的120个解剖型全肩关节置换,最终分析100例患者的104个CT扫描(4例双侧肩),平均年龄66岁(标准差11),女性62例、男性38例;两名独立观察者阅片。
主要发现
- 上柱周围骨溶解见于32例患者(32个肩,31%);其余患者中72例平均Arnold评分5.6分(标准差0.9),70个肩(67%)完美整合。
- 下柱平均Gulotta评分6.5分(标准差1.4),70例患者(70个肩,67%)完美整合;9例患者(9个肩,9%)两柱均无骨性整合。
- 上柱水平肩胛盂前、后方向穿孔分别见于3例和28例患者,下柱水平分别见于11例和18例患者。
- 观察者间和观察者内信度良好(k值分别为0.782和0.86);平均随访16个月(12至24)无假体断裂。
- 平均随访32个月(24至35)临床结果满意,采用疼痛视觉模拟评分、Constant-Murley评分、主观肩关节评分和美国肩肘外科医师评分评估。
局限性
- 需要更长期随访分析该假体的生存率。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
AIMS: Loosening of the glenoid component in the long term remains an important complication of the anatomical total shoulder arthroplasty (aTSA). The aim of this study was to explore the bony integration of a hybrid glenoid component based on an analysis of CT scans. METHODS: In a prospective multicentre study, patients who underwent primary aTSA, whose hybrid design of glenoid component included a fully-polyethylene flanged upper peg and a porous-coated titanium lower peg, and who were reviewed with CT scans between 12 and 24 months postoperatively, were included. Two independent observers reviewed the scans. Bony integration of the upper peg was scored as described by Arnold et al, and integration of the lower peg was scored as described by Gulotta et al. Perforation of the glenoid vault in any plane was also assessed. RESULTS: From an initial group of 120 aTSAs in 116 patients, 104 CT scans were analyzed in 100 patients (four bilateral shoulders, mean age 66 years (SD 11), 62 female and 38 male). Osteolysis around the upper peg was found in 32 patients (32 aTSAs; 31%). Of the remaining patients, 72 had a mean Arnold score of 5.6 points (SD 0.9), and 70 (67%) had perfect integration. The lower peg had a mean Gulotta score of 6.5 points (SD 1.4). There was perfect integration of the lower peg in 70 patients (70 aTSAs; 67%). A total of nine patients (nine aTSAs; 9%) had no bony integration at either peg. There was perforation of the glenoid in an anterior or posterior direction at the level of the upper peg in three and 28 patients, respectively. This occurred at the level of the lower peg in 11 and 18 patients, respectively. The inter- and intraobserver reliability was good (k = 0.782 and 0.86, respectively). No implant breakage occurred at a mean follow-up of 16 months (12 to 24). The clinical outcome was satisfactory at a mean follow-up of 32 months (24 to 35), as assessed by a visual analogue scale score for pain, the Constant-Murley score, Subjective Shoulder Value, and American Shoulder and Elbow Surgeons score. CONCLUSION: Short-term CT scan analysis of a new hybrid anatomical glenoid component found perfect bony integration around the lower porous coated titanium peg in 90% of patients. The upper polyethylene flanged peg had bony integration in 70 patients (70 aTSAs; 67%). Longer follow-up is needed to analyze the rate of survival of this component. The short-term clinical outcome was satisfactory.
引用
- Barret H, Tiercelin J, Godenèche A, et al. Bony integration of a hybrid glenoid component in anatomical shoulder arthroplasty : short-term CT scan analysis. Bone Joint J. 2025. PMID: 39889755. doi:10.1302/0301-620X.107B2.BJJ-2024-1123.R1
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。