文献速递创伤骨科关节外科

假体柄设计是否影响股骨颈骨折关节置换术中股骨假体周围骨折的发生率?HEALTH试验的二次分析

Does Stem Design Affect the Incidence of Periprosthetic Femoral Fractures in Arthroplasty for Femoral Neck Fractures? A Secondary Analysis of the HEALTH Trial.
PubMed 文献 · J Arthroplasty · 2025-02-18

本研究为HEALTH随机对照试验的二次分析,评估1374例股骨颈骨折患者中假体柄设计对股骨假体周围骨折(PFF)的影响。结果显示骨水泥柄PFF发生率显著低于非骨水泥柄(2.6% vs 10.3%,P<0.001);锥形滑动柄与复合梁柄PFF率无差异,但锥形滑动柄晚期骨折更多且半髋置换后因疼痛再手术率更高。

要点

  • 骨水泥柄PFF发生率显著低于非骨水泥柄(2.6% vs 10.3%,P<0.001)。
  • 锥形滑动柄与复合梁柄PFF率无差异(2.3% vs 2.9%,P>0.05),但锥形滑动柄晚期骨折占55%。
  • 半髋置换使用锥形滑动柄者因疼痛再手术率高于复合梁柄(2.6% vs 0.4%,P=0.048)。

核心结论

  • 非骨水泥柄PFF发生率高,无论柄类型或是否带领。
  • 锥形滑动柄导致晚期骨折,其长期性能令人担忧。
  • 半髋置换使用锥形滑动柄时因疼痛再手术风险可能更高。

研究设计与样本

  • HEALTH试验的二次分析,该试验为多中心、前瞻性、随机对照试验,比较全髋关节置换与半髋置换治疗低能量股骨颈骨折。
  • 共评估1374例患者(414例男性,960例女性),其中72例发生PFF(5.2%)。

主要发现

  • 术中PFF 42例,术后早期PFF 15例,晚期PFF 15例。
  • 骨水泥柄组PFF发生率2.6%,非骨水泥柄组10.3%,差异显著(P<0.001)。
  • 骨水泥组内锥形滑动柄(n=482)与复合梁柄(n=414)PFF率分别为2.3%和2.9%,无差异(P>0.05)。
  • 复合梁柄PFF多发生于术中(75%),锥形滑动柄PFF多发生于晚期(55%)。
  • 半髋置换使用锥形滑动柄者WOMAC评分较差,因疼痛再手术率2.6%,复合梁柄为0.4%(P=0.048)。

关键数值与推荐

  • 骨水泥柄PFF发生率2.6% vs 非骨水泥柄10.3%(P<0.001)。
  • 锥形滑动柄PFF发生率2.3% vs 复合梁柄2.9%(P>0.05)。
  • 半髋置换因疼痛再手术率:锥形滑动柄2.6% vs 复合梁柄0.4%(P=0.048)。

临床怎么用

  • 原文未据此给出推荐。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: The aim of this study was to evaluate how stem design influences the risk of periprosthetic femoral fractures (PFFs) after hemiarthroplasty (HA) and total hip arthroplasty for femoral neck fractures. METHODS: We performed a secondary analysis of the Hip Fracture Evaluation with Alternatives of Total Hip Arthroplasty versus Hemiarthroplasty trial, a multicenter, prospective, randomized control trial that assessed total hip arthroplasty versus hemiarthroplasty for low-energy femoral neck fractures. Between 1,374 patients (414 men, 960 women) that were assessed, 72 sustained PFFs (5.2%). Intraoperative PFFs were recorded in 42 patients, early postoperative PFFs in 15 and late PFFs in 15 patients. The incidence of PFFs was compared between cemented and cementless stems. Within the cemented group (n = 896), we analyzed the effect of taper-slip (n = 482) versus composite-beam (n = 414) designs, while within the cementless group (n = 478), we assessed the impact of single-wedged (n = 206) versus metaphyseal-filling stems (n = 272). The role of collars (n = 87) was also examined within the press-fit stems. Clinical outcomes were recorded with the Western Ontario and McMaster Universities Arthritis Index RESULTS: Cemented stems had a significantly lower incidence of PFFs than their cementless counterparts (2.6 versus 10.3%, P < 0.001). There was no difference in fracture rates between taper-slip and composite-beam stems (2.3 versus 2.9%, P > 0.05). Most of the composite-beam PFFs occurred intraoperatively (75%), while most of the taper-slip PFFs occurred late (55%). There was no difference between the. press-fit stems, while the presence of a collar did not show protective results (P > 0.05). Patients who underwent HA with taper-slip stems demonstrated inferior Western Ontario and McMaster Universities Arthritis Index scores and higher incidence of reoperation for pain than those treated with composite-beam stems (2.6 versus 0.4%, P = 0.048). CONCLUSIONS: Cementless stems have a high PFF rate, regardless of the stem type or presence of collar. Taper-slip stems are responsible for late fractures, raising concerns about their performance in the long term. Patients treated with HA may present a higher risk of reoperation for pain when taper-slip stems are used.

来源:J Arthroplasty,查看原文。版权归原作者所有。

引用

  1. Megaloikonomos PD, Nowak L, Shehata M, et al. Does Stem Design Affect the Incidence of Periprosthetic Femoral Fractures in Arthroplasty for Femoral Neck Fractures? A Secondary Analysis of the HEALTH Trial. J Arthroplasty. 2025. PMID: 39978649. doi:10.1016/j.arth.2025.02.036

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。