文献速递关节外科创伤骨科

感染聚丙烯网片:生物膜何时形成及哪种消毒液最有效清除

The Infected Polypropylene Mesh: When Does Biofilm Form and Which Antiseptic Solution Most Effectively Removes It?
PubMed 文献 · J Arthroplasty · 2024-05-08

本研究在体外将聚丙烯网片分别培养甲氧西林敏感金黄色葡萄球菌(MSSA)或大肠埃希菌7天,观察生物膜成熟过程,并用5种商用消毒液处理24小时(未成熟)和72小时(成熟)生物膜3分钟。结果显示两种细菌均在72小时形成成熟生物膜,仅10%聚维酮碘制剂对成熟生物膜显著降低菌落数(P < .0083)。

要点

  • MSSA和大肠埃希菌在聚丙烯网片上72小时形成成熟生物膜。
  • 10%聚维酮碘联合过氧化氢对所有条件均有效。
  • 仅10%聚维酮碘制剂对成熟生物膜显著降低菌落数(P < .0083)。

核心结论

  • 细菌在聚丙烯网片上快速形成生物膜,网片污染可造成灾难性后果。
  • 作者认为临床医生应考虑在网片植入结束时使用消毒液。
  • 作者认为尝试保留感染聚丙烯网片时可考虑使用未稀释聚维酮碘联合过氧化氢。

研究设计与样本

  • 体外研究:将编织聚丙烯网片分别与MSSA或大肠埃希菌培养7天,定期定量菌落形成单位(CFU)并用扫描电镜观察生物膜成熟。
  • 用5种商用消毒液处理24小时(未成熟)和72小时(成熟)生物膜3分钟。
  • 以较生理盐水降低3个对数级CFU作为临床有意义的标准。

主要发现

  • MSSA和大肠埃希菌的CFU计数均在72小时达到平台,提示生物膜成熟,扫描电镜证实72小时后形成融合生物膜。
  • 10%聚维酮碘对全部MSSA生物膜和未成熟大肠埃希菌生物膜有临床效果。
  • 10%聚维酮碘联合过氧化氢对所有条件均有效。
  • 仅10%聚维酮碘制剂对成熟生物膜显著降低CFU计数(P < .0083)。

关键数值与推荐

  • 消毒液包括0.05%葡萄糖酸氯己定、表面活性剂型乙醇/乙酸/乙酸钠/苯扎氯铵配方、稀释聚维酮碘(0.35%)、未稀释(10%)聚维酮碘、10%聚维酮碘与3%过氧化氢1:1组合。
  • 处理时间为3分钟。
  • 临床有意义的标准为较生理盐水降低3个对数级CFU。

临床怎么用

  • 作者认为临床医生应考虑在网片植入结束时使用消毒液。
  • 作者认为尝试保留感染聚丙烯网片时可考虑使用未稀释聚维酮碘联合过氧化氢。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

BACKGROUND: Polypropylene (PPE) mesh is commonly utilized to reconstruct catastrophic extensor mechanism disruptions in revision total knee arthroplasty. Unfortunately, these procedures are associated with a high rate of periprosthetic joint infection. The purpose of the current study was to: 1) visualize and quantify the progression of bacterial biofilm growth on PPE-mesh; and 2) determine which antiseptic solutions effectively remove viable bacteria. METHODS: Knitted PPE mesh samples were cultured with either methicillin-sensitive Staphylococcus aureus (MSSA) or Escherichia coli (E. coli) for 7 days, with regular quantification of colony forming units (CFUs) and visualization using scanning electron microscopy to identify maturity. Immature (24 hour) and mature (72 hour) biofilm was treated with one of 5 commercial antiseptics for 3 minutes. A 0.05% chlorhexidine gluconate, a surfactant-based formulation of ethanol, acetic acid, sodium acetate, benzalkonium chloride, diluted povidone-iodine (0.35%), undiluted (10%) povidone-iodine, and 1:1 combination of 10% povidone-iodine and 3% hydrogen peroxide. A 3-log reduction in CFUs compared to saline was considered clinically meaningful. RESULTS: The CFU counts plateaued, indicating maturity, at 72 hours for both MSSA and E. coli. The scanning electron microscopy confirmed confluent biofilm formation after 72 hours. The 10% povidone-iodine was clinically effective against all MSSA biofilms and immature E. coli biofilms. The 10% povidone-iodine with hydrogen peroxide was effective in all conditions. Only 10% povidone iodine formulations produced significantly (P < .0083) reduced CFU counts against mature biofilms. CONCLUSIONS: Bacteria rapidly form biofilm on PPE mesh. Mesh contamination can be catastrophic, and clinicians should consider utilizing an antiseptic solution at the conclusion of mesh implantation. Undiluted povidone-iodine with hydrogen peroxide should be considered when attempting to salvage infected PPE mesh.

来源:J Arthroplasty,查看原文。版权归原作者所有。

引用

  1. Jo S, Chao C, Khilnani TK, et al. The Infected Polypropylene Mesh: When Does Biofilm Form and Which Antiseptic Solution Most Effectively Removes It? J Arthroplasty. 2024. PMID: 38723699. doi:10.1016/j.arth.2024.04.081

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。