文献速递骨质疏松与代谢性骨病

建立并验证基于深度学习的骨密度预测模型作为女性检查工具的可靠性

Establish and validate the reliability of predictive models in bone mineral density by deep learning as examination tool for women.
PubMed 文献 · Osteoporos Int · 2023-09-20

本研究为横断面研究,纳入台湾全国骨骼健康筛查计划中约10827名女性(平均年龄65.4±9.4岁),建立深度学习模型预测腰椎、全髋或股骨颈最低T值及相应骨密度值,并基于预测骨密度与不含骨密度的FRAX评分构建骨折高风险分类模型。Bland-Altman分析显示预测模型与双能X线吸收测定法(DXA)间差异无统计学意义;分类模型AUROC为0.913(95%CI 0.904-0.922),准确率83.5%。结论认为,在无骨密度测量时,深度学习模型经验证可轻微减少治疗不足和治疗过度的患者数量,可用于筛查骨折和骨质疏松高风险患者。

要点

  • 深度学习模型预测腰椎、全髋、股骨颈骨密度及最低T值的均方根误差分别为0.099、0.089、0.076和0.68。
  • Bland-Altman分析显示预测模型与DXA之间差异无统计学意义。
  • 分类模型AUROC为0.913(95%CI 0.904-0.922),准确率83.5%,阳性预测值71.2%,阴性预测值92.2%。

核心结论

  • 含骨密度的FRAX在估计骨折风险时可能更精确,但经验证的深度学习模型在无骨密度测量时可轻微减少治疗不足和治疗过度的患者数量。
  • 经验证的模型可用于筛查骨折和骨质疏松高风险患者。

研究设计与样本

  • 横断面研究,参与者来自台湾全国骨骼健康筛查计划。
  • 共纳入约10827名女性,平均年龄65.4±9.4岁。
  • 首先建立深度学习模型预测腰椎、全髋或股骨颈的最低T值及各自骨密度值,采用Bland-Altman分析比较模型与DXA的一致性。
  • 其次根据第一步估计的骨密度与不含骨密度的FRAX评分建立骨折高风险分类预测模型,并与基于含骨密度FRAX的分类进行比较。

主要发现

  • 预测腰椎骨密度、全髋骨密度、股骨颈骨密度和最低T值的均方根误差分别为0.099、0.089、0.076和0.68。
  • Bland-Altman分析显示预测模型与DXA之间差异无统计学意义。
  • 含股骨颈骨密度的FRAX评分中,主要骨质疏松性骨折风险为9.7%±6.7%,髋部骨折风险为3.3%±4.6%。
  • 含与不含骨密度的FRAX分类比较,准确率、阳性预测值和阴性预测值分别为78.8%、64.6%和89.9%。
  • 分类模型的AUROC为0.913(95%CI 0.904-0.922),准确率83.5%,阳性预测值71.2%,阴性预测值92.2%。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

UNLABELLED: While FRAX with BMD could be more precise in estimating the fracture risk, DL-based models were validated to slightly reduce the number of under- and over-treated patients when no BMD measurements were available. The validated models could be used to screen for patients at a high risk of fracture and osteoporosis. PURPOSE: Fracture risk assessment tool (FRAX) is useful in classifying the fracture risk level, and precise prediction can be achieved by estimating both clinical risk factors and bone mineral density (BMD) using dual X-ray absorptiometry (DXA). However, DXA is not frequently feasible because of its cost and accessibility. This study aimed to establish the reliability of deep learning (DL)-based alternative tools for screening patients at a high risk of fracture and osteoporosis. METHODS: Participants were enrolled from the National Bone Health Screening Project of Taiwan in this cross-sectional study. First, DL-based models were built to predict the lowest T-score value in either the lumbar spine, total hip, or femoral neck and their respective BMD values. The Bland-Altman analysis was used to compare the agreement between the models and DXA. Second, the predictive model to classify patients with a high fracture risk was built according to the estimated BMD from the first step and the FRAX score without BMD. The performance of the model was compared with the classification based on FRAX with BMD. RESULTS: Approximately 10,827 women (mean age, 65.4 ± 9.4 years) were enrolled. In the prediction of the lumbar spine BMD, total hip BMD, femoral neck BMD, and lowest T-score, the root-mean-square error (RMSE) was 0.099, 0.089, 0.076, and 0.68, respectively. The Bland-Altman analysis revealed a nonsignificant difference between the predictive models and DXA. The FRAX score with femoral neck BMD for major osteoporotic fracture risk was 9.7% ± 6.7%, whereas the risk for hip fracture was 3.3% ± 4.6%. Comparison between the classification of FRAX with and without BMD revealed the accuracy rate, positive predictive value (PPV), and negative predictive value (NPV) of 78.8%, 64.6%, and 89.9%, respectively. The area under the receiver operating characteristic curve (AUROC), accuracy rate, PPV, and NPV of the classification model were 0.913 (95% confidence interval: 0.904-0.922), 83.5%, 71.2%, and 92.2%, respectively. CONCLUSION: While FRAX with BMD could be more precise in estimating the fracture risk, DL-based models were validated to slightly reduce the number of under- and over-treated patients when no BMD measurements were available. The validated models could be used to screen for patients at a high risk of fracture and osteoporosis.

来源:Osteoporos Int,查看原文。版权归原作者所有。

引用

  1. Hung WC, Lin YL, Cheng TT, et al. Establish and validate the reliability of predictive models in bone mineral density by deep learning as examination tool for women. Osteoporos Int. 2023. PMID: 37728768. doi:10.1007/s00198-023-06913-5

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。