高交联聚乙烯内衬磨损与髋中心位置的比较研究: elevated hip center技术在Crowe I至III型髋关节发育不良中的应用,至少18年随访结果
研究纳入2000年4月至2003年8月91例患者共108髋,使用高交联聚乙烯内衬联合氧化锆股骨头及髋臼组件行全髋关节置换,评估不同髋中心位置对内衬磨损的影响,平均随访19年(范围18至21年)。平均内衬磨损为0.221 mm,年均磨损0.012 mm/年;不同髋中心高度(<20、20至30、>30 mm)及四个象限分区之间线性磨损无差异。结论认为在至少18年随访中,采用高交联聚乙烯对陶瓷组件及非骨水泥固定的elevated hip center技术与极低磨损率和优良功能评分相关。
要点
- 平均随访19年,平均内衬磨损0.221 mm,年均磨损0.012 mm/年。
- 髋中心高度<20、20至30、>30 mm三组间线性磨损无差异。
- 四个象限分区之间线性磨损无差异。
核心结论
- 在至少18年随访的髋关节发育不良患者中,不同Crowe亚型及不同髋中心位置下,采用高交联聚乙烯对陶瓷组件及非骨水泥固定的elevated hip center技术与极低磨损率和优良功能评分相关。
研究设计与样本
- 2000年4月至2003年8月,91例患者接受108次全髋关节置换术,使用高交联聚乙烯内衬联合氧化锆股骨头及髋臼组件。
- 通过骨盆X线片评估髋中心垂直和水平距离及内衬磨损量;手术时平均年龄54岁(范围33至73岁),平均随访19年(范围18至21年)。
主要发现
- 平均内衬磨损为0.221 mm,平均年磨损为0.012 mm/年。
- 髋中心平均垂直和水平距离分别为24.9 mm和31.8 mm。
- 髋中心高度<20 mm、20至30 mm、>30 mm的患者之间线性磨损无差异。
- 象限分区显示4个象限区域之间无差异。
临床怎么用
- 原文未据此给出推荐。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: The literature has reported that supero-lateralization of the femoral head increases the rates of aseptic loosening and prosthesis revision. However, there are few reports on the influence of different hip center positions on liner wear with more than a 15-year follow-up period. METHODS: From April 2000 to August 2003, 91 patients underwent 108 total hip arthroplasties using a highly cross-linked polyethylene liner combined with zirconia femoral head and cup components. Pelvic radiographs were used to assess the vertical and horizontal distances to the center of the hip and the amount of liner wear. Mean patient age at the time of surgery was 54 years (range, 33 to 73), and mean follow-up duration was 19 years (range, 18 to 21). RESULTS: Average liner wear was 0.221 mm, with average annual wear of 0.012 mm/year. Mean vertical and horizontal distances for the hip center were 24.9 and 31.8 mm, respectively. There was no difference in linear wear between patients who had different hip center heights (<20, 20 to 30, and >30 mm), and quadrant partitioning showed no differences across the 4 quadrant zones. CONCLUSION: At a minimum of 18 years of follow-up in patients having developmental dysplasia of the hip who had different Crowe subtypes and different hip centers, elevated hip center and uncemented fixation techniques using a highly cross-linked polyethylene on ceramic components were associated with very low wear rates and excellent functional scores.
引用
- Takahashi E, Chen M, Kaneuji A, et al. Comparative Study of Highly Cross-Linked Polyethylene Liner Wear by Hip Center Location Using Elevated Hip Center Technique in Crowe I to III Hip Dysplasia: Outcomes for a Minimum of Eighteen Years of Follow-Up. J Arthroplasty. 2023. PMID: 37279849. doi:10.1016/j.arth.2023.05.078
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。