体内冲击微压痕测得的骨材料强度指数在高能量创伤骨折患者中正常
本研究用冲击微压痕(IMI)测量胫骨骨材料强度指数(BMSi),比较40例高能量创伤骨折患者与40例年龄性别匹配的低能量创伤骨折患者。高能量组BMSi显著高于低能量组(84.4±5.0 vs 78.0±4.6,p=0.001),校正aBMD后仍显著(p=0.003);两组内骨量减少与骨质疏松者BMSi无差异。
要点
- 高能量创伤骨折患者BMSi显著高于年龄性别匹配的低能量创伤骨折患者。
- 高能量组腰椎aBMD高于低能量组,股骨颈aBMD两组无显著差异。
- 每个创伤组内骨量减少与骨质疏松患者BMSi无差异。
核心结论
- 高能量创伤骨折患者的BMSi和腰椎aBMD显著高于骨折类型相似的低能量创伤匹配对照,而股骨颈aBMD无显著差异。
- 作者认为需要对无骨质疏松的高能量创伤骨折患者进一步研究BMSi,以确定IMI是否有助于识别骨强度降低者。
研究设计与样本
- 研究纳入40例高能量创伤骨折患者和40例年龄性别匹配的低能量创伤骨折对照,骨折后3.0个月(IQR 2.0-5.8)使用OsteoProbe®设备测量BMSi。
主要发现
- 高能量组与低能量组平均年龄分别为57.7±9.1岁和57.2±7.7岁(p=0.78),骨折类型可比。
- 高能量组腰椎aBMD高于低能量组(0.96±0.13 vs 0.89±0.13 g/cm2,p=0.02),股骨颈aBMD两组无显著差异(0.75±0.09 vs 0.72±0.09 g/cm2,p=0.09)。
- 高能量组BMSi显著高于低能量组(84.4±5.0 vs 78.0±4.6,p=0.001),校正aBMD后仍显著(p=0.003)。
- 每个创伤组内骨量减少与骨质疏松患者之间BMSi无差异。
局限性
- 作者指出需要对无骨质疏松的高能量创伤骨折患者进一步研究BMSi,以确定IMI是否有助于识别骨强度降低者。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
UNLABELLED: Bone material properties were assessed using impact microindentation in patients with high-energy trauma fractures. Compared to patients with low-energy trauma fractures, bone material strength index was significantly higher in patients with high-energy trauma fractures, and did not differ between patients with osteopenia and those with osteoporosis within each trauma group. INTRODUCTION: Impact microindentation (IMI) is a technique to assess tissue-level properties of bone at the tibia. Bone material strength index (BMSi), measured by IMI, is decreased in patients with low-energy trauma fractures, independently of areal bone mineral density (aBMD), but there is no information about BMSi in patients with high-energy trauma fractures. In the present study, we evaluated tissue-level properties of bone with IMI in patients with high-energy trauma fractures. METHODS: BMSi was measured 3.0 months (IQR 2.0-5.8) after the fracture in 40 patients with high-energy trauma and 40 age- and gender-matched controls with low-energy trauma fractures using the OsteoProbe® device. RESULTS: Mean age of high- and low-energy trauma patients was 57.7 ± 9.1 and 57.2 ± 7.7 years, respectively (p = 0.78). Fracture types were comparable in high- vs low-energy trauma patients. Lumbar spine (LS)-aBMD, but not femoral neck (FN)-aBMD, was higher in high- than in low-energy trauma patients (LS 0.96 ± 0.13 vs 0.89 ± 0.13 g/cm2, p = 0.02; FN 0.75 ± 0.09 vs 0.72 ± 0.09 g/cm2, p = 0.09). BMSi was significantly higher in high- than in low-energy trauma patients (84.4 ± 5.0 vs 78.0 ± 4.6, p = 0.001), also after adjusting for aBMD (p = 0.003). In addition, BMSi did not differ between patients with osteopenia and those with osteoporosis within each trauma group. CONCLUSION: Our data demonstrate that BMSi and LS-aBMD, but not FN-aBMD, are significantly higher in high-energy trauma patients compared to matched controls with similar fractures from low-energy trauma. Further studies of non-osteoporotic patients with high-energy trauma fracture with measurements of BMSi are warranted to determine whether IMI might help in identifying those with reduced bone strength.
引用
- Schoeb M, Winter EM, Malgo F, et al. Bone material strength index as measured by in vivo impact microindentation is normal in subjects with high-energy trauma fractures. Osteoporos Int. 2022. PMID: 35307747. doi:10.1007/s00198-022-06368-0
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。