文献速递创伤骨科骨质疏松与代谢性骨病

非典型股骨骨折位置与下肢机械轴的关系:基于计算机断层扫描的有限元分析

Association of atypical femoral fracture location and lower limb mechanical axis: a computed tomography-based finite element analysis.
PubMed 文献 · Osteoporos Int · 2022-02-03

本研究回顾19例非典型股骨骨折(AFF)患者的对侧完整股骨CT图像,用有限元分析(FEA)计算最大主应力(MPS)和最大拉伸应力加载区(股骨最弱点,FWP),并与真实骨折位置匹配。结果显示FWP与AFF位置一致,且由下肢机械轴和股骨弯曲决定;调整膝关节机械轴后FWP与真实骨折位置的均方根误差由14.58%降至10.87%。

要点

  • 19例AFF患者均为女性,平均年龄75.9岁(范围61-87岁),共20处股骨干AFF和7处转子下AFF。
  • 膝关节水平平均机械轴为内翻22.6 mm(范围0-70 mm)。
  • 机械轴从外翻向内翻变化时,所有患者MPS呈增加趋势且FWP向远端移动。

核心结论

  • CT有限元分析显示,抗拉伸应力的股骨最弱点(FWP)与非典型股骨骨折(AFF)位置一致,该位置由下肢机械轴和股骨弯曲决定。

研究设计与样本

  • 回顾性分析19例AFF患者对侧完整股骨的CT图像,采用基于CT的有限元分析(FEA)模型。
  • 对每例患者计算最大主应力(MPS)和最大拉伸应力加载区(FWP),并将FWP与真实AFF位置匹配。
  • 在FEA模型中分别施加中立、内翻和外翻机械轴,分析MPS和FWP随下肢对线的变化。
  • 比较膝关节机械轴调整前后真实骨折位置与FWP之间的一致程度。

主要发现

  • 19例患者平均年龄75.9岁(范围61-87岁),全部为女性;共观察到20处股骨干AFF和7处转子下AFF。
  • 膝关节水平平均机械轴为内翻22.6 mm(范围0-70 mm)。
  • 当膝关节机械轴从外翻向内翻施加时,所有患者均显示MPS增加趋势和FWP向远端移动。
  • FWP与真实骨折位置的均方根误差在调整前为14.58%,调整后为10.87%,提示接受机械轴调整的患者一致程度更好。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

UNLABELLED: Atypical femoral fractures (AFFs) are categorized as low-energy fractures of the femoral shaft or subtrochanteric region. The use of computed tomography-based finite element analysis demonstrated that the femoral weakest point against tensile stress coincided with AFF location, which was determined by the lower limb axis and femoral bowing. INTRODUCTION: This study aimed to assess the relationship between the femoral weakest point against tensile stress and the lower limb axis and geometry, including femoral bowing, using a computed tomography (CT)-based finite element analysis (FEA) model. METHODS: We retrospectively reviewed 19 patients with AFFs and analyzed their CT images of the contralateral intact femur. We performed FEA to find the maximum principal stress (MPS) and maximal tensile stress loading area (femoral weakest point, FWP) of each patient and matched the FWP with the real location of AFF. We applied mechanical axes differently, as neutral, varus, and valgus, in the FEA model, when we analyzed the change in MPS and FWP based on lower limb alignment. We compared the degree of agreement between the real fracture location and FWP before and after knee mechanical axis adjustment. RESULTS: The average participant age was 75.9 (range, 61-87) years, and all participants were women. In the 19 patients included, we observed 20 and 7 shaft and subtrochanteric AFFs, respectively. The average mechanical axis at the knee joint level was 22.6 mm (range, 0-70 mm) of the varus. All the patients showed an increasing trend of MPS and a distal movement of FWP when the mechanical axis of the knee was applied from the valgus to varus alignment. The root mean square errors between the FWP and real fracture location were 14.58% and 10.87% before and after adjustment, respectively, implying that the degree of agreement was better in patients who underwent mechanical adjustment. CONCLUSION: The use of CT/FEA demonstrated that the FWP against tensile stress coincided with AFF location, which was determined by the lower limb axis and femoral bowing.

来源:Osteoporos Int,查看原文。版权归原作者所有。

引用

  1. Hwang D, Kim CH, Lee Y, et al. Association of atypical femoral fracture location and lower limb mechanical axis: a computed tomography-based finite element analysis. Osteoporos Int. 2022. PMID: 35112136. doi:10.1007/s00198-021-06173-1

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。