LASIK、SMILE与PRK术后气压所致角膜形变的有限元模拟预测
本研究用有限元模型模拟LASIK、SMILE和PRK术后气压压平角膜的形变幅度,基于正常眼队列反演术前角膜特性并预测术后形变,与在体测量比较。预测的术后角膜刚度参数与在体值吻合良好,PRK眼组内相关系数最高(ICC > 0.95),SMILE和LASIK眼峰值形变与偏移幅度一致性较低(ICC < 0.9)。
要点
- 有限元模型可预测LASIK、SMILE和PRK术后气压所致角膜形变。
- PRK眼预测与在体测量一致性最高,ICC > 0.95。
- SMILE和LASIK峰值形变与偏移幅度预测一致性较低,ICC < 0.9。
核心结论
- 首次提出不同屈光手术后角膜形变变化的预测性模拟。
- 患者特异性术前角膜生物力学特性与有限元模型是准确预测术后形变幅度的重要决定因素。
研究设计与样本
- 对已接受屈光治疗正常眼队列进行LASIK、SMILE和PRK模型的气压压平有限元模拟。
- SMILE和LASIK模型考虑短期和长期伤口愈合反应,依据为Bowman层微扭曲和胶原纤维卷曲证据。
- 先反演模拟推导角膜术前特性,再用计划屈光治疗预测术后气压形变幅度并与在体测量比较。
主要发现
- 预测的术后角膜刚度参数与SMILE、LASIK和PRK眼在体值吻合很好。
- PRK眼组内相关系数最高(ICC > 0.95)。
- SMILE和LASIK眼峰值形变幅度与峰值偏移幅度一致性较低(ICC < 0.9)。
- PRK眼峰值形变与偏移幅度预测相对在体幅度最佳。
- 在体测量与预测生物力学参数线性相关强:SMILE r ≥ 0.89,LASIK r ≥ 0.83,PRK r ≥ 0.87。
关键数值与推荐
- PRK眼预测与在体角膜刚度参数ICC > 0.95。
- SMILE和LASIK眼峰值形变与偏移幅度ICC < 0.9。
- 在体与预测生物力学参数线性相关:SMILE r ≥ 0.89,LASIK r ≥ 0.83,PRK r ≥ 0.87。
临床怎么用
- 可利用患者特异性术前角膜生物力学特性与有限元模型预测屈光术后角膜形变反应。
- 不同屈光手术方式术后形变预测一致性存在差异,PRK预测一致性最高。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
PURPOSE: To simulate deformation amplitude after laser-assisted in situ keratomileusis (LASIK), small incision lenticule extraction (SMILE), and photorefractive keratectomy (PRK) with finite element models. METHODS: Finite element simulations of air-puff applanation on LASIK, SMILE, and PRK models were performed on a cohort of normal eyes, which had undergone refractive treatments. Short- and long-term wound healing responses were considered for SMILE and LASIK models based on evidence of microdistortions in Bowman's layer and crimping of collagen fibers. First, inverse simulations were performed to derive the preoperative properties of the cornea. Using these properties and planned refractive treatment, postoperative air-puff deformation amplitude was predicted and compared with the in vivo measurements. RESULTS: The predicted postoperative corneal stiffness parameters agreed very well with in vivo values of SMILE, LASIK, and PRK eyes. Intraclass correlations (ICC) were greatest in PRK eyes (ICC > 0.95). This agreement was lower for peak deformation amplitude and peak deflection amplitude in SMILE and LASIK eyes (ICC < 0.9). In PRK eyes, peak deformation and deflection amplitude predictions were the best relative to in vivo magnitudes. Also, linear correlation (r) between in vivo measurement and predicted biomechanical parameters indicated strong agreement between them (SMILE: r ≥ 0.89, LASIK: r ≥ 0.83, PRK: r ≥ 0.87). CONCLUSIONS: The is the first study to present predictive simulations of corneal deformation changes after different procedures. Patient-specific preoperative corneal biomechanical properties and finite element models were a significant determinant of accurate postoperative deformation amplitude prediction.
引用
- Francis M, Khamar P, Shetty R, et al. In Vivo Prediction of Air-Puff Induced Corneal Deformation Using LASIK, SMILE, and PRK Finite Element Simulations. Invest Ophthalmol Vis Sci. 2018. PMID: 30398623. doi:10.1167/iovs.18-2470
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。