文献速递青光眼

通过数值建模与先进OCT成像估算人小梁网硬度

Estimating Human Trabecular Meshwork Stiffness by Numerical Modeling and Advanced OCT Imaging.
PubMed 文献 · Invest Ophthalmol Vis Sci · 2017-01-01

研究采用逆向有限元建模结合OCT成像估算人小梁网硬度,并与原子力显微镜直接测量比较。正常眼小梁网弹性模量为70±20 kPa,青光眼眼为98±19 kPa;原子力显微镜测得正常眼硬度为1.37±0.56 kPa,低于青光眼眼的2.75±1.19 kPa,但差异均无统计学显著性。在6只人眼中,房水流出易度与小梁网硬度显著相关(P=0.018)。

要点

  • 逆向有限元建模估算正常眼小梁网弹性模量为70±20 kPa,青光眼眼为98±19 kPa。
  • 原子力显微镜测得正常眼小梁网硬度1.37±0.56 kPa,低于青光眼眼2.75±1.19 kPa。
  • 6只人眼中房水流出易度与小梁网硬度显著相关(P=0.018)。

核心结论

  • 青光眼患者小梁网硬度更高,但仅轻度升高。
  • 正常眼与青光眼人眼的房水流出易度似乎与小梁网硬度相关。
  • 这些证据促使进一步研究小梁网生物力学特性调控的相关因素。

研究设计与样本

  • 研究采用离体人眼,灌流测量房水流出易度并通过示踪剂识别高流量区与低流量区。
  • 在直接调控Schlemm管腔内压力时获取OCT图像,通过逆向有限元建模推算小梁网硬度。
  • 在径向切开的平坦角膜巩膜楔上,使小梁网朝上,沿穿过前房角的一条线采集原子力显微镜力分布图。

主要发现

  • 逆向有限元建模估算正常眼小梁网弹性模量为70±20 kPa(均值±标准差),青光眼眼小梁网略硬,为98±19 kPa。
  • 原子力显微镜测得正常眼小梁网硬度为1.37±0.56 kPa,低于青光眼眼的2.75±1.19 kPa。
  • 上述差异均无统计学显著性。
  • 基于逆向有限元建模,正常眼与青光眼眼的高流量区小梁网均较低流量区更软,但原子力显微镜未显示此差异。
  • 6只人眼中房水流出易度与逆向有限元建模估算的小梁网硬度显著相关(P=0.018)。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

PURPOSE: The purpose of this study was to estimate human trabecular meshwork (hTM) stiffness, thought to be elevated in glaucoma, using a novel indirect approach, and to compare results with direct en face atomic force microscopy (AFM) measurements. METHODS: Postmortem human eyes were perfused to measure outflow facility and identify high- and low-flow regions (HF, LF) by tracer. Optical coherence tomography (OCT) images were obtained as Schlemm's canal luminal pressure was directly manipulated. TM stiffness was deduced by an inverse finite element modeling (FEM) approach. A series of AFM forcemaps was acquired along a line traversing the anterior angle on a radially cut flat-mount corneoscleral wedge with TM facing upward. RESULTS: The elastic modulus of normal hTM estimated by inverse FEM was 70 ± 20 kPa (mean ± SD), whereas glaucomatous hTM was slightly stiffer (98 ± 19 kPa). This trend was consistent with TM stiffnesses measured by AFM: normal hTM stiffness = 1.37 ± 0.56 kPa, which was lower than glaucomatous hTM stiffness (2.75 ± 1.19 kPa). None of these differences were statistically significant. TM in HF wedges was softer than that in LF wedges for both normal and glaucomatous eyes based on the inverse FEM approach but not by AFM. Outflow facility was significantly correlated with TM stiffness estimated by FEM in six human eyes (P = 0.018). CONCLUSIONS: TM stiffness is higher, but only modestly so, in glaucomatous patients. Outflow facility in both normal and glaucomatous human eyes appears to associate with TM stiffness. This evidence motivates further studies to investigate factors underlying TM biomechanical property regulation.

来源:Invest Ophthalmol Vis Sci,查看原文。版权归原作者所有。

引用

  1. Wang K, Johnstone MA, Xin C, et al. Estimating Human Trabecular Meshwork Stiffness by Numerical Modeling and Advanced OCT Imaging. Invest Ophthalmol Vis Sci. 2017. PMID: 28973327. doi:10.1167/iovs.17-22175

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。