文献速递角膜与眼表疾病

近视眼角膜生物力学特性显示各向异性并与眼轴长度相关

Corneal Biomechanical Properties Demonstrate Anisotropy and Correlate With Axial Length in Myopic Eyes.
PubMed 文献 · Invest Ophthalmol Vis Sci · 2023-01-01

研究对51例近视眼SMILE术中获取的角膜基质微透镜行双轴拉伸测试,术后24小时内完成,比较眼轴长度(AL)<26 mm与AL≥26 mm组。AL≥26 mm组水平和垂直方向切线模量及SSI均显著降低,各向异性参数与AL正相关(r=0.307,P<0.05),SSI在AL<26 mm组与AL负相关(r=-0.380,P<0.05)。作者认为计算角膜生物力学参数时应考虑AL。

要点

  • AL≥26 mm组角膜水平和垂直方向切线模量较AL<26 mm组显著降低(P<0.05)。
  • AL≥26 mm组SSI较AL<26 mm组显著降低(P<0.05),各向异性参数显著增加(P<0.05)。
  • SSI在AL<26 mm组与AL负相关(r=-0.380,P<0.05),在AL≥26 mm组无显著相关(P>0.05)。

核心结论

  • 角膜生物力学特性随AL增加而降低,水平方向切线模量较垂直方向显著降低,计算角膜生物力学参数时应考虑AL。

研究设计与样本

  • 研究获取51例近视眼SMILE术中角膜基质微透镜,术后24小时内行双轴拉伸测试,比较AL<26 mm与AL≥26 mm组。
  • 采用术前SSI参数评估在体角膜生物力学特性。

主要发现

  • 与AL<26 mm组相比,AL≥26 mm组水平和垂直方向切线模量均显著降低(P<0.05)。
  • 与AL<26 mm组相比,AL≥26 mm组SSI显著降低(P<0.05),各向异性参数显著增加(P<0.05)。
  • 各向异性参数与AL正相关(r=0.307,P<0.05)。
  • SSI在AL<26 mm组与AL负相关(r=-0.380,P<0.05),在AL≥26 mm组无显著相关(P>0.05)。
  • 与26 mm≤AL<27 mm组相比,27 mm≤AL<28 mm组水平方向切线模量显著降低(P<0.05),垂直方向无显著差异(P>0.05)。

临床怎么用

  • 作者认为计算角膜生物力学参数时应考虑AL,以提高有效性。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

PURPOSE: The purpose of this study was to investigate the ex vivo and in vivo biomechanical characteristic of cornea in myopic eyes. METHODS: Fifty-one corneal stromal lenticules were obtained from myopic eyes during the SMILE procedure and were tested by a biaxial tensile system within 24 hours postoperatively. The material properties of the lenticules were described using stress-strain curves and were compared among axial length (AL) <26 mm and AL ≥ 26 mm group. Pre-operative stress-strain index (SSI) parameters were used to evaluate the biomechanical properties of the cornea in vivo. RESULTS: Compared with AL < 26 mm, the tangent modulus significantly decreased in horizontal and vertical directions when AL ≥ 26 mm (P < 0.05); SSI also significantly decreased when AL ≥ 26 mm (P < 0.05). Anisotropic parameter is positively correlated with AL (r = 0.307, P < 0.05). Compared with AL < 26 mm, anisotropic parameter significantly increased when AL ≥ 26 mm (P < 0.05). SSI was negatively correlated with AL (r = -0.380, P < 0.05) in the AL < 26 mm group but not in the AL ≥ 26 mm group (P > 0.05). Compared with 26 mm ≤ AL < 27 mm group, the tangent modulus significantly decreased in the horizontal direction (P < 0.05) but not in the vertical direction when 27 mm ≤ AL < 28 mm (P > 0.05). CONCLUSIONS: The biomechanical properties of cornea decreased with the increase of AL. Tangent modulus significantly decreased in the horizontal direction compared with vertical direction. AL should be taken into account during calculation of corneal biomechanical parameters in order to improve validity.

来源:Invest Ophthalmol Vis Sci,查看原文。版权归原作者所有。

引用

  1. Chen L, Huang Y, Zhang X, et al. Corneal Biomechanical Properties Demonstrate Anisotropy and Correlate With Axial Length in Myopic Eyes. Invest Ophthalmol Vis Sci. 2023. PMID: 37477932. doi:10.1167/iovs.64.10.27

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。