对与手术并发症相关的缺陷Drysdale晶状体核操作器进行的电子显微镜及元素分析
该实验性实验室研究用扫描电镜和能谱分析检测了5把复用Drysdale晶状体核操作器(DNM)桨状头,全部复用器械均见锐利毛刺、空腔、碎屑等结构缺陷,而新器械对照无缺陷;毛刺主要含碳或铝,作者支持开发一次性替代器械并鼓励术前指尖检查。
要点
- 全部5把复用DNM在扫描电镜下均有显著结构缺陷,新器械对照无缺陷。
- 能谱分析显示毛刺主要成分为碳或铝,另见混合成分毛刺。
- 作者支持开发可靠的一次性替代器械,并鼓励术前指尖检查复用器械锐边。
核心结论
- 全部受检复用DNM均检出含碳或铝的锐利毛刺及1个混合成分毛刺,来源为有机残留、器械碎片或盐类与污染物沉积。
- 锐利缺陷可能造成囊膜损伤包括后囊膜破裂(PCR),残留物可能带来其他安全隐患。
- 作者支持开发高质量、可靠的一次性替代器械,并进一步鼓励术前主要经指尖触诊仔细检查所有复用器械有无锐边。
研究设计与样本
- 实验性实验室研究,分析5把复用Drysdale晶状体核操作器(DNM)桨状头,其中DNM 1和4与后囊膜破裂(PCR)相关,另3把为术中指尖触诊发现锐边者;以新器械DNM 3为对照。
- 先用扫描电子显微镜(SEM)评估锐利表面缺陷的数量与尺寸,再对锐利缺陷行能量色散X射线光谱(EDS)测定元素组成。
主要发现
- 全部5把复用DNM(5/5)在SEM下均有显著结构缺陷,包括锐利毛刺、空腔与凹痕、表面碎屑或残留及粗糙化;新器械对照(DNM 3)无缺陷。
- DNM 1有2个锐利缺陷,较大者为14×76 µm,另有一个167×220 µm含碎屑的火山口样缺陷。
- DNM 2的4个毛刺中3个主要成分为碳,第4个为混合成分(钙、硫、氧);DNM 4有1个小毛刺,EDS显示碳有意义;DNM 5有3个明显毛刺,最大者20×28 µm,其中2个成分为铝,并见部分碳残留。
- DNM 6有1个成分为铝的毛刺和3个明显空腔缺陷,最大者面积781 µm²。
临床怎么用
- 作者支持开发高质量、可靠的一次性替代器械。
- 作者进一步鼓励术前主要经指尖触诊仔细检查所有复用器械有无锐边。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
PURPOSE: To analyze microtopography of 5 reusable Drysdale nucleus manipulator (DNM) paddled tips for sharp defects and evaluate their elemental composition to determine probable source, investigating 2 instruments (DNM 1 and 4) implicated in causing posterior capsule rupture (PCR) and 3 instruments with sharp edges identified by finger-tip interrogation intraoperatively. DESIGN: Experimental laboratory investigation. METHODS: DNM paddled tips were analyzed using scanning electron microscopy (SEM) to evaluate for sharp surface defects (number, dimensions), and subsequently energy dispersive x-ray spectroscopy (EDS) performed on sharp defects to determine their elemental composition. RESULTS: All reused DNMs analyzed (5 of 5) had significant structural defects on SEM analysis including sharp burrs, cavities and indentations, surface debris or residues, and roughening, compared to the new instrument (DNM 3, control) which had no defects. DNM 1 had 2 sharp defects, a larger 14 × 76-µm one and a craterlike 167 × 220-µm defect containing debris. EDS found that DNM 2 had 3 of 4 burrs composed mainly of carbon, the fourth of mixed composition (calcium, sulfur, oxygen); DNM 4 had 1 small burr, EDS significant for carbon; DNM 5 had 3 prominent burrs, the largest of 20 × 28 µm, 2 composed of aluminum, and some carbon residue. DNM 6 had 1 burr composed of aluminum and 3 prominent cavity defects, the largest covering 781 µm2. CONCLUSION: Reusable DNMs are widely used in cataract surgery. Sharp carbon- or aluminum-containing burrs were detected on all reused instruments analyzed together with 1 burr of mixed composition, originating from (1) organic residues, (2) instrument fragments, or (3) salt and contaminant deposits. Sharp defects may contribute to capsular damage including PCR, and residues may pose other safety concerns. Therefore, we support development of a quality, reliable single-use alternative instrument and further encourage careful inspection of all reusable instruments principally by finger-tip interrogation for sharp edges preuse.
引用
- Kopecny LR, Biazik JM, Coroneo MT, et al. Electron Microscopy and Elemental Analysis of Defective Drysdale Nucleus Manipulator Instruments Implicated in Surgical Complications. Am J Ophthalmol. 2022. PMID: 36103900. doi:10.1016/j.ajo.2022.09.001
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。