文献速递心脏核医学肿瘤 PET/CT

动脉[18F]-氟脱氧葡萄糖摄取定量的准确性:一项动力学建模研究

Accuracy of arterial [18F]-Fluorodeoxyglucose uptake quantification: A kinetic modeling study.
PubMed 文献 · J Nucl Cardiol · 2020-02-10

本研究利用13例无心血管疾病史受试者的动态PET数据,以血浆活性为输入函数、t*=20分钟进行体素级Patlak分析获得升主动脉壁FDG净摄取率Ki,并与按指南计算的mean SUVmax和mean TBRmax比较。结果显示Ki与mean TBRmax相关(r=0.82,P<0.001),与mean SUVmax不相关(r=0.10,P=NS)。动力学建模支持mean TBRmax作为动脉壁FDG净摄取率的替代指标。

要点

  • 升主动脉壁Ki与mean TBRmax相关(r=0.82,P<0.001),与mean SUVmax不相关(r=0.10,P=NS)。
  • Ki与Ki_max强相关(R=0.96,P<0.0001)。
  • Ki_max与mean TBRmax相关(r=0.83,P<0.001),与mean SUVmax不相关(r=0.17,P=NS)。

核心结论

  • 动力学建模支持将mean TBRmax作为动脉壁FDG净摄取率的替代指标。
  • 该结果适用于任何PET显像剂,与示踪剂在血管壁摄取的生物学意义无关。

研究设计与样本

  • 本研究纳入13例无心血管疾病史、参加血管炎症研究的受试者,使用其动态PET数据进行此分析。
  • 以体外测量的血浆活性作为输入函数,采用t*=20分钟进行体素级Patlak分析获得Ki图像。
  • 按近期血管成像指南在PET图像上定量升主动脉壁FDG信号,确定mean SUVmax和mean TBRmax。

主要发现

  • 升主动脉壁Ki与mean SUVmax不相关(r=0.10,P=NS),与mean TBRmax相关(r=0.82,P<0.001)。
  • Ki与Ki_max强相关(R=0.96,P<0.0001)。
  • Ki_max与mean SUVmax不相关(r=0.17,P=NS),与mean TBRmax相关(r=0.83,P<0.001)。

关键数值与推荐

  • 指南推荐使用mean SUVmax和mean TBRmax分析动脉壁FDG信号,但此前未对照组织活性或动力学建模Ki等金标准验证。
  • 本研究中mean TBRmax与Ki相关(r=0.82,P<0.001),mean SUVmax与Ki不相关(r=0.10,P=NS)。

临床怎么用

  • 原文结论支持将mean TBRmax作为动脉壁FDG净摄取率的替代指标,未据此给出其他推荐。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

UNLABELLED: 2-deoxy-2- [18F] fluoro-D-glucose (FDG) PET is commonly used for the assessment of vessel wall inflammation. Guidelines for analysis of arterial wall FDG signal recommend the use of the average of maximal standardized uptake value (mean SUVmax) and target-to-blood (mean TBRmax) ratio. However, these methods have not been validated against a gold standard such as tissue activity ex vivo or net uptake rate of FDG (Ki) obtained using kinetic modeling. We sought to evaluate the accuracy of mean SUVmax and mean TBRmax for aortic wall FDG signal quantification in comparison with the net uptake rate of FDG. METHODS: Dynamic PET data from 13 subjects without prior history of cardiovascular disease who enrolled in a study of vascular inflammation were used for this analysis. Ex vivo measurement of plasma activity was used as the input function and voxel-by-voxel Patlak analysis was performed with t* = 20 minute to obtain the Ki image. The FDG signal in the ascending aortic wall was quantified on PET images following recent guidelines for vascular imaging to determine mean SUVmax and mean TBRmax. RESULTS: The Ki in the ascending aortic wall did not correlate with mean SUVmax (r = 0.10, P = NS), but correlated with mean TBRmax (r = 0.82, P < 0.001) (Figure 1B). Ki and Ki_max strongly correlated (R = 0.96, P < 0.0001) and similar to Ki, Ki_max did not correlate with mean SUVmax (r = 0.17, P = NS), but correlated with mean TBRmax (r = 0.83, P < 0.001). CONCLUSIONS: Kinetic modeling supports the use of mean TBRmax as a surrogate for the net uptake rate of FDG in the arterial wall. These results are relevant to any PET imaging agent, regardless of the biological significance of the tracer uptake in the vessel wall.

来源:J Nucl Cardiol,查看原文。版权归原作者所有。

引用

  1. Toczek J, Wu J, Hillmer AT, et al. Accuracy of arterial [18F]-Fluorodeoxyglucose uptake quantification: A kinetic modeling study. J Nucl Cardiol. 2020. PMID: 32043239. doi:10.1007/s12350-020-02055-x

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。