使用68Ga-通气/灌注PET/CT自动勾画功能性肺体积
研究纳入30例肺癌患者,基于68Ga-通气/灌注PET/CT图像,以人工勾画体积为参考标准,评估不同最大像素值百分比阈值自动分割功能性体积的效果;通气和灌注图像的最佳阈值均为15%max,但该单一阈值下体积变异性较大且与肺功能检查参数相关性较弱,作者更倾向于视觉适配的半自动方法。
要点
- 通气图像在15%max阈值下平均体积差最小(-0.4%),Pearson相关系数为0.71。
- 灌注图像在15%max阈值下平均体积差最小(3.3%)且Pearson相关系数最高(0.81)。
- 采用15%max阈值时,通气和灌注体积与FEV1/FVC呈中等相关(r分别为0.48和0.46)。
核心结论
- 对于68Ga-通气/灌注PET/CT自动勾画功能性体积,通气和灌注图像最合适的阈值均为15%max。
- 但使用该单一阈值时,与参考体积相比系统性提供了不可接受的变异性,且与肺功能检查参数的相关性相对较差。
- 因此,作者更倾向于采用视觉适配的半自动方法,以实现快速、定量的功能性肺体积勾画。
研究设计与样本
- 研究分析了30例同时接受68Ga-通气/灌注PET/CT和肺功能检查的肺癌患者。
- 图像采集于吸入Galligas后,随后静脉注射68Ga-大颗粒聚合白蛋白(MAA)。
- 以视觉定义的人工勾画轮廓为参考标准,应用了以最大像素值百分比表示的各种截断值。
主要发现
- 通气体积:15%max阈值下平均体积差最低(-0.4%),Pearson相关系数为0.71;该阈值下中位DSC为0.93(0.87-0.95),但体积差的一致性界限较大(-31.0%和30.2%),差值范围为-40.4%至+33.0%。
- 灌注体积:15%max阈值下平均体积差最低(3.3%)且Pearson相关系数最高(0.81);该阈值下中位DSC为0.93(0.88-0.93),但一致性界限仍较大(-21.1%和27.8%),体积差范围为-18.6%至+35.5%。
- 采用15%max阈值时,通气和灌注图像体积与FEV1/FVC呈中等相关(r分别为0.48和0.46)。
- 其他肺功能检查指标与自动体积之间未发现相关性。
临床怎么用
- 原文未据此给出推荐。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
BACKGROUND: Functional volumes computed from 68Ga-ventilation/perfusion (V/Q) PET/CT, which we have shown to correlate with pulmonary function test parameters (PFTs), have potential diagnostic utility in a variety of clinical applications, including radiotherapy planning. An automatic segmentation method would facilitate delineation of such volumes. The aim of this study was to develop an automated threshold-based approach to delineate functional volumes that best correlates with manual delineation. Thirty lung cancer patients undergoing both V/Q PET/CT and PFTs were analyzed. Images were acquired following inhalation of Galligas and, subsequently, intravenous administration of 68Ga-macroaggreted-albumin (MAA). Using visually defined manual contours as the reference standard, various cutoff values, expressed as a percentage of the maximal pixel value, were applied. The average volume difference and Dice similarity coefficient (DSC) were calculated, measuring the similarity of the automatic segmentation and the reference standard. Pearson's correlation was also calculated to compare automated volumes with manual volumes, and automated volumes optimized to PFT indices. RESULTS: For ventilation volumes, mean volume difference was lowest (- 0.4%) using a 15%max threshold with Pearson's coefficient of 0.71. Applying this cutoff, median DSC was 0.93 (0.87-0.95). Nevertheless, limits of agreement in volume differences were large (- 31.0 and 30.2%) with differences ranging from - 40.4 to + 33.0%. For perfusion volumes, mean volume difference was lowest and Pearson's coefficient was highest using a 15%max threshold (3.3% and 0.81, respectively). Applying this cutoff, median DSC was 0.93 (0.88-0.93). Nevertheless, limits of agreement were again large (- 21.1 and 27.8%) with volume differences ranging from - 18.6 to + 35.5%. Using the 15%max threshold, moderate correlation was demonstrated with FEV1/FVC (r = 0.48 and r = 0.46 for ventilation and perfusion images, respectively). No correlation was found between other PFT indices. CONCLUSIONS: To automatically delineate functional volumes with 68Ga-V/Q PET/CT, the most appropriate cutoff was 15%max for both ventilation and perfusion images. However, using this unique threshold systematically provided unacceptable variability compared to the reference volume and relatively poor correlation with PFT parameters. Accordingly, a visually adapted semi-automatic method is favored, enabling rapid and quantitative delineation of lung functional volumes with 68Ga-V/Q PET/CT.
引用
- Le Roux PY, Siva S, Callahan J, et al. Automatic delineation of functional lung volumes with 68Ga-ventilation/perfusion PET/CT. EJNMMI Res. 2017. PMID: 29019109. doi:10.1186/s13550-017-0332-x
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。