计算肿瘤模体库中的剂量学变异性
研究用Blender软件构建不同形状、大小和边缘轮廓的三维肿瘤模型,计算90Y、131I、177Lu、211At、225Ac、213Bi和223Ra的S值。结果显示肿瘤形状对S值的影响在偏离球形几何极端和长程发射时最大,等效球近似在明显偏离球形和小体积时系统误差达30%–75%,作者认为轮廓匹配模体可提高肿瘤剂量学准确性。
要点
- 肿瘤S值对形状的依赖在极端偏离球形几何和长程发射(如90Y β发射)时最大。
- 对于明显偏离球形和小体积,等效球近似的系统误差增至30%–75%,取决于放射性核素。
- 误差在具有许多长针状突起的形状以及厚度小于或相当于组织内粒子射程的球壳中最大。
核心结论
- 观察到肿瘤S值随肿瘤形状和边缘轮廓变化,提示使用轮廓匹配模体可提高器官级剂量学范式中肿瘤剂量学的准确性。
- 在器官级剂量学软件中实施肿瘤模体库可能有助于优化个性化放射性核素治疗的策略。
研究设计与样本
- 使用Blender软件生成不同形状分类的三维肿瘤模型:卵形通过轴向缩放生成,分叶状、针状和 irregular 轮廓通过基于噪声的网格变形生成。
- 网格被刚性缩放至不同体积,然后使用PARaDIM软件计算S值,并提取每个形状的影像组学特征,检查其对S值的影响。
- 最后估计了模拟复杂肿瘤形状与等效质量球体相比在剂量计算中存在的系统误差。
主要发现
- 肿瘤S值对形状的依赖在极端偏离球形几何和长程发射(如90Y β发射)时最大。
- 如果表面扰动小,球体的S值与分叶状、针状或 irregular 轮廓相当一致。
- 对于明显偏离球形和小体积,等效球近似的系统误差增至30%–75%,取决于放射性核素。
- 误差在具有许多长针状突起的形状以及厚度小于或相当于组织内粒子射程的球壳中最大。
关键数值与推荐
- 计算了90Y、131I、177Lu、211At、225Ac、213Bi和223Ra的S值(每单位时间积分活度的吸收剂量)。
临床怎么用
- 作者认为使用轮廓匹配模体可提高器官级剂量学范式中肿瘤剂量学的准确性。
- 作者认为在器官级剂量学软件中实施肿瘤模体库可能有助于优化个性化放射性核素治疗的策略。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
In radiopharmaceutical therapy, dosimetry-based treatment planning and response evaluation require accurate estimates of tumor-absorbed dose. Tumor dose estimates are routinely derived using simplistic spherical models, despite the well-established influence of tumor geometry on the dosimetry. Moreover, the degree of disease invasiveness correlates with departure from ideal geometry; malignant lesions often possess lobular, spiculated, or otherwise irregular margins in contrast to the commonly regular or smooth contours characteristic of benign lesions. To assess the effects of tumor shape, size, and margin contour on absorbed dose, an array of tumor geometries was modeled using computer-aided design software, and the models were used to calculate absorbed dose per unit of time-integrated activity (i.e., S values) for several clinically applied therapeutic radionuclides (90Y, 131I, 177Lu, 211At, 225Ac, 213Bi, and 223Ra). Methods: Three-dimensional tumor models of several different shape classifications were generated using Blender software. Ovoid shapes were generated using axial scaling. Lobulated, spiculated, and irregular contours were generated using noise-based mesh deformation. The meshes were rigidly scaled to different volumes, and S values were then computed using PARaDIM software. Radiomic features were extracted for each shape, and the impact on S values was examined. Finally, the systematic error present in dose calculations that model complex tumor shapes versus equivalent-mass spheres was estimated. Results: The dependence of tumor S values on shape was largest for extreme departures from spherical geometry and for long-range emissions (e.g., 90Y β-emissions). S values for spheres agreed reasonably well with lobulated, spiculated, or irregular contours if the surface perturbation was small. For marked deviations from spherical shape and small volumes, the systematic error of the equivalent-sphere approximation increased to 30%–75% depending on radionuclide. The errors were largest for shapes with many long spicules and for spherical shells with a thickness less than or comparable to the particle range in tissue. Conclusion: Variability in tumor S values as a function of tumor shape and margin contour was observed, suggesting use of contour-matched phantoms to improve the accuracy of tumor dosimetry in organ-level dosimetry paradigms. Implementing a library of tumor phantoms in organ-level dosimetry software may facilitate optimization strategies for personalized radionuclide therapies.
引用
- Carter LM, Krebs S, Marquis H, et al. Dosimetric variability across a library of computational tumor phantoms. J Nucl Med. 2022. PMID: 37074039. doi:10.2967/jnumed.122.264916
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。