文献速递脊柱脊髓外科

齿状突颈椎痛风导致寰枢椎不稳:病例报告

Odontoid cervical gout causing atlantoaxial instability: case report.
PubMed 文献 · J Neurosurg Spine · 2019-01-25

本文报告一例因齿状突痛风石导致C1-2旋转半脱位及大型齿状突后血管翳的患者,既往有痛风、结节病及疑似类风湿关节炎病史,因寰枢椎不稳行后路固定融合及后路活检确诊痛风,未行前路减压。

要点

  • 齿状突痛风可表现为齿状突后血管翳和C1-2旋转半脱位,需与肿瘤、感染等鉴别。
  • 患者有痛风、结节病及疑似类风湿关节炎病史,诊断困难。
  • 无脊髓压迫证据时,后路固定融合联合后路活检可确诊并避免前路手术。

核心结论

  • 齿状突痛风是导致寰枢椎不稳及齿状突后血管翳的罕见病因,后路固定融合联合后路活检可在避免前路手术的情况下确诊。

研究设计与样本

  • 病例报告。

主要发现

  • 患者表现为C1-2旋转半脱位及大型齿状突后血管翳,齿状突内强化病灶最终证实为痛风所致。
  • 患者既往有痛风、结节病及疑似类风湿关节炎病史,属于肿瘤风险不能完全排除的人群。
  • 患者无脊髓受压的体格检查或影像学证据,未行前路减压。

临床怎么用

  • 对于有寰枢椎不稳表现的患者,后路固定融合可复位旋转半脱位并稳定C1-2。
  • 后路活检齿状突后血管翳可在避免额外手术及并发症的情况下确认痛风诊断。

局限性

  • 原文未报告局限性。

以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。

原文

The authors present a case report of a patient discovered to have a rotatory subluxation of the C1-2 joint and a large retroodontoid pannus with an enhancing lesion in the odontoid process eventually proving to be caused by gout. This patient represented a diagnostic conundrum as she had known prior diagnoses of not only gout but also sarcoidosis and possible rheumatoid arthritis, and was in the demographic range where concern for an oncological process cannot fully be ruled out. Because she presented with signs and symptoms of atlantoaxial instability, she required posterior stabilization to reduce the rotatory subluxation and to stabilize the C1-2 instability. However, despite the presence of a large retroodontoid pannus, she had no evidence of spinal cord compression on physical examination or imaging and did not require an anterior procedure to decompress the pannus. To confirm the diagnosis but avoid additional procedures and morbidity, the authors proceeded with the fusion as well as a posterior biopsy to the retroodontoid pannus and confirmed a diagnosis of gout.

来源:J Neurosurg Spine,查看原文。版权归原作者所有。

引用

  1. Slavin J, DiStasio M, Dellaripa PF, et al. Odontoid cervical gout causing atlantoaxial instability: case report. J Neurosurg Spine. 2019. PMID: 30684938. doi:10.3171/2018.9.SPINE18122

供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。