立体定向弥散张量成像纤维束成像用于伽玛刀放射外科
该研究纳入20例接受伽玛刀放射外科(GKRS)的患者,在Leksell立体定向框架固定下于标准GKRS方案MRI时采集弥散张量成像(DTI),经处理后生成方向编码彩色图、表观弥散系数图及各向异性分数图,并将关键纤维束作为「危险器官」导入GammaPlan参与射野规划。全部患者均成功获得立体定向DTI图像,短期随访未记录到放射性新发神经功能缺损。
要点
- 20例患者均在立体定向框架固定下成功完成DTI采集并生成正确的方向编码彩色图像。
- 软件生成纤维束简便且可重复,视辐射和弓状束等轴位走行纤维束尤为适用。
- 皮质脊髓束显示受立体定向框架底部伪影影响,可通过调整框架/MRI体积与DTI种子参数克服。
核心结论
- 将立体定向纤维束成像整合入GKRS是预防并发症的有前景工具,可降低功能危险器官(包括关键皮质区和皮质下白质纤维束)的放射剂量。
研究设计与样本
- 研究队列为20例接受GKRS的患者,包括1例初始测试病例(前庭神经鞘瘤)、5例动静脉畸形、9例脑转移瘤、1例矢状窦旁脑膜瘤和4例前庭神经鞘瘤。
- DT图像在标准GKRS方案MRI(T1和T2加权)时采集,患者头部由Leksell立体定向框架固定,使用1.5-T磁共振和单通道头线圈,弥散梯度为32个方向,并与容积T1加权序列配准。
- DTI后处理使用商用软件完成张量计算,生成方向编码彩色、表观弥散系数和各向异性分数图,并将可视化的关键纤维束导出为结构体积,作为「危险器官」整合入GammaPlan进行射野规划。
主要发现
- 所有患者均成功获得立体定向DT图像并生成正确的方向编码彩色图像。
- 软件生成纤维束简便且可重复,尤其适用于视辐射和弓状束等轴位走行纤维束。
- 皮质脊髓束可视化受立体定向框架底部伪影影响,但通过框架/MRI体积调整和DTI种子参数组合得以克服。
- 在成像时将DTI序列与T1加权治疗体积配准对生成正确张量数据至关重要。
- 除前庭神经鞘瘤病例外,所有患者的治疗病理均位于功能纤维束和/或皮质附近;短期随访未记录到放射性新发神经功能缺损。
局限性
- 原文未报告局限性。
以上解读依据论文摘要(全文未开放获取或许可不允许翻译转载)。
原文
OBJECTIVE The integration of modern neuroimaging into treatment planning has increased the therapeutic potential and safety of stereotactic radiosurgery. The authors report their method of integrating stereotactic diffusion tensor imaging (DTI) tractography into conventional treatment planning for Gamma Knife radiosurgery (GKRS). The aim of this study was to demonstrate the feasibility of this technique and to address some of the technical limitations of previously reported techniques. METHODS Twenty patients who underwent GKRS composed the study cohort. They consisted of 1 initial test case (a patient with a vestibular schwannoma), 5 patients with arteriovenous malformations, 9 patients with cerebral metastases, 1 patient with parasagittal meningioma, and 4 patients with vestibular schwannoma. DT images were obtained at the time of standard GKRS protocol MRI (T1 and T2 weighted) for treatment, with the patient's head secured by a Leksell stereotactic frame. All studies were performed using a 1.5-T magnet with a single-channel head coil. DTI was performed with diffusion gradients in 32 directions and coregistered with the volumetric T1-weighted study. DTI postprocessing by means of commercially available software allowed tensor computation and the creation of directionally encoded color-, apparent diffusion coefficient-, and fractional anisotropy-mapped sequences. In addition, the software allowed visualized critical tracts to be exported as a structural volume and integrated into GammaPlan as an "organ at risk" during shot planning. Combined images were transferred to GammaPlan and integrated into treatment planning. RESULTS Stereotactic DT images were successfully acquired in all patients, with generation of correct directionally encoded color images. Tract generation with the software was straightforward and reproducible, particularly for axial tracts such as the optic radiation and the arcuate fasciculus. Corticospinal tract visualization was hampered by some artifacts from the base of the stereotactic frame, but this was overcome by a combination of frame/MRI volume adjustment and DTI seeding parameters. Coregistration of the DTI series with the T1-weighted treatment volume at the time of imaging was essential for the generation of correct tensor data. All patients with the exception of the vestibular schwannoma cases had treatment pathology in the vicinity of eloquent tracts and/or the cortex. No new neurological deficits due to radiation were recorded at the short-term follow-up. CONCLUSIONS Recent reports in the medical literature have suggested that white matter tracts (particularly the optic radiation and arcuate fasciculus) are more vulnerable to radiation during stereotactic radiosurgery than previously thought. Integration of stereotactic tractography into GKRS represents a promising tool for preventing GKRS complications by reduction in radiation doses to functional organs at risk, including critical cortical areas and subcortical white matter tracts.
引用
- Gavin CG, Ian Sabin H. Stereotactic diffusion tensor imaging tractography for Gamma Knife radiosurgery. J Neurosurg. 2016. PMID: 27903187
供执业医师工作参考,不替代临床判断;数值与分级以指南原文为准。